CST-59611
Self contained, 1 piece tool for preparation of coaxial drop cables, for installation
of “F” connectors.
z
Strips RG-59 and RG-6 (1/4” x 1/4”)
z
Strips RG-7 and RG-11 (1/4” x 5/16”)
z
Fast, easy, one-step operation
z
Repeatable accurate cable preparation
z
Integral stop for proper center conductor length
z
V-notched blade eliminates damage to center
conductor
z
Easily replaceable blade cartridges
z
Bright yellow body makes it easy to find
z
Rugged nylon construction
CST-596
Coax Strip Tool RG-59 and RG-6
z
Prepares Cable to Proper Dimensions
z
Notch in Blade to Prevent Damage to Copper
on Center Conductor
z
Adjustable Blade Depth for Standard / Tri /
Quad Shield Cables
z
Replaceable Blades (Part #CST-596BL)
PT-1 Pocket Toner
The Pocket Toner is a simple, easy to use tool to “ring
out cables”. By attaching the battery section to either a
male or female F connector of the cable you are trying
to trace or identify, and then fitting the smaller “buzzer”
piece to any cables where you think your cable terminates, you will identify the correct cable when the
buzzer sounds.
z
Machined Aluminum Construction
z
Plated Brass Fittings
z
Battery LED, 12 Volt A23 Battery
z
Pocket Clip