Toko TMW1052 User Manual

FCC ID：NUSTMW1052

Annex P User’s Manual (Draft)

2.4GHz Wireless LAN Mini-PCI Card Model:TMW1052

User’s Manual

(Draft)

TOKO INC.

Page 1 of 4

1. FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to following two conditions:
(1) this device may not cause harmful interference. and (2) this device must accept any interference
received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B Personal Computer and
Peripheral, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
dose cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This equipment has been tested to comply with the limits for a Class B personal computer and peripheral,
pursuant to Subpart B of Part 15 of FCC Rules. Only peripherals(computer input/output devices, terminals,
printers, etc.) certified (DoC) or verified to comply with Class B limits may be attached to this equipment.
Operation with non-certified (DoC) or non-verified personal computer and/or peripherals is likely to result in
Interference to radio and TV reception. The connection of a unshielded equipment interface cable to this
Equipment will invalidate the FCC Certification of this device and may cause interference levels which
Exceed the limits established by FCC for equipment.

You are cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.

Thisdeviceanditsantennamustnotbeco‑locatedoroperatinginconjunctionwithanyotherantenna

ortransmitter.

Page 2 of 4