Toastmaster TP409, TP430, TP224, BTW24, HT409 User Manual 2
...
TP209/244/409/424/430;
HT409/424; BTW09/24
English
Solid State Slot Toaster
Models TP209, TP224, TP409, TP424, TP430,
HT409, HT424, BTW09, BTW24
OWNER'S OPERATING AND
INSTALLATION MANUAL
is a registered trademark of Toastmaster, A Middleby Company. All rights reserved.
P/N 41491
Price $5.00
Rev. B V1 6/99
WARNING: IN CASE OF FIRE
Disconnect the toaster from its power source IMMEDIATELY. This allows the unit to cool, making it easier to
put out the fire.
WARNING
FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS
IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE
WARNING
IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE OR MAINTENANCE CAN CAUSE
PROPERTY DAMAGE, INJURY OR DEATH. READ
THE INSTALLATION AND OPERATING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING OR
SERVICING THIS EQUIPMENT.
WARNING
DO NOT PICK UP THE TOASTER BY INSERTING
FINGERS INTO THE TOASTER SLOTS AND GRASPING THE HEATING ELEMENTS. ELECTRICAL SHOCK
AND DAMAGE TO THE HEATING ELEMENTS CAN
OCCUR.
CAUTION
Using any parts other than genuine Toastmaster factory
parts relieves the manufacturer of all liability.
IMPORTANT
Contact your authorized service agent to perform maintenance and repairs. A service agency directory is supplied
with your toaster.
IMPORTANT
Toastmaster (manufacturer) reserves the right to change
specifications and product design without notice. Such
revisions do not entitle the buyer to corresponding changes,
improvements, additions or replacements for previously
purchased equipment.
RETAIN THIS MANUAL FOR FUTURE REFERENCE
This manual provides detailed information for the installation and operation of your toaster. It also contains information to assist the operator in diagnosing problems in the
event of a malfunction. This manual is an important tool for
the operator and should be kept readily available.
WARNING
NEVER INSERT A KNIFE, FORK, OR SIMILAR OBJECT INTO THE TOASTING CHAMBER. ELECTRICAL SHOCK AND DAMAGE TO THE HEATING ELEMENTS CAN OCCUR.
WARNING
DISCONNECT THE UNIT FROM ITS ELECTRICAL
POWER SUPPLY BEFORE CLEANING OR SERVICING.
1
I. DESCRIPTION AND SPECIFICATIONS
A. Component Location
The major components of the toaster are shown in Figure 1 below.
Figure 1
3b. Extra-wide,
one-sided slot
4. Data plate
(not shown at lower rear
of toaster)
5. Removable
crumb tray
(model HT409/424 shown)
B. Component Function (see Figure 1)
1. Color selection knob - see Section III, Operation.
2. Operating lever - see Section III, Operation.
3a. Standard slot - 1-1/8/29mm wide, these slots can accomodate
Texas Size bread, frozen waffles, English muffins, etc.
Heating elements are located on both sides of the slot.
3b. Extra-wide slot - 1-5/8/41mm wide, these slots can
accomodate bagels and thick English muffins. A heating
element is located on one side of the slot, permitting one-sided
toasting.
4. Data plate - Provides manufacturing and electrical information.
5. Crumb tray - Collects crumbs from the toasted product. The
tray can be removed for cleaning.
C. Toaster Information
Slot information: TP209, TP409, HT409, BTW09,
TP224 TP424, HT424 BTW24
TP430
Standard slots 2420
Extra-wide,
one-sided slots 0024
NOTE
Electrical specifications are provided on the wiring diagrams at the
back of this Manual.
3a. Standard slot
2. Operating
lever
1. Color
selection
knob
II. INSTALLATION
IMPORTANT
IT IS THE CUSTOMERS RESPONSIBILITY TO REPORT ANY
CONCEALED OR NON-CONCEALED DAMAGE TO THE FREIGHT
COMPANY.
A. Installation Options and Kit Availability
Two-slot toasters (TP209/224) are to be installed on a countertop, as
described in Part B, Electrical Utility Connection, below.
Four-slot toasters (TP409/424/430, HT409/424, BTW09/24) may be installed EITHER on a countertop, OR on the four-slot toaster stand shown
in Figure 2, below. The stand (Toastmaster P/N 1D3CS) is not included
with your toaster, but is available separately.
Figure 2 - Four-slot toaster stand,
Toastmaster P/N 1D3CS
Available separately
To install the toaster on a countertop, follow the instructions in Part
B, Electrical Utility Connection, below.
To install the toaster on a stand, follow the assembly instructions
included with the stand kit. Then, proceed to Part B, Electrical
Utility Connection.
B. Electrical Utility Connection
1. Position the toaster in place.
2. Before proceeding with the electrical connection, check the following:
a. Check that the electrical supply matches the toasters
requirements. Refer to the toasters data plate (at the lower
rear of toaster - see Figure 1), and to the electrical specifications
provided on the wiring diagrams at the back of this Manual.
b. Check that the appropriate receptacle is available for the power
cord plug.
c. Check that the main electrical supply source is turned OFF.
CONSULT ALL APPLICABLE NATIONAL AND LOCAL CODES
FOR FURTHER ELECTRICAL CONNECTION REQUIREMENTS.
WARNING
ENSURE THAT ANY PACKING MATERIAL RESIDUE HAS
BEEN REMOVED FROM INSIDE THE TOASTING
CHAMBER.
3. Insert the power cord plug into its receptacle.
2
III. OPERATION
A. Location and Function of Controls
This section provides a basic description of the toaster controls, their
location, and the functions they perform. The operator MUST be
familiar with the controls. See Figure 3.
Figure 3 -Toaster Controls
Operating
Lever
Color
Selection
Knob
1. Color Selection Knob
Adjusts the darkness of the toasted bakery product.
Turn the knob to the LEFT for lighter toasting.
Turn the knob to the RIGHT for darker toasting.
2. Operating Lever
Press the lever DOWN to load the bakery product into the
toaster.
Push the lever UP to manually raise the product during the
toasting cycle. If the operating lever is not raised manually, it
will be automatically raised at the end of the toasting cycle.
B. Operation Procedure
CAUTION
THE REMOVABLE CRUMB TRAY MUST BE IN PLACE BEFORE THE
TOASTER MAY BE OPERATED. If the tray is removed for cleaning,
ensure that it is replaced before operation.
1. Insert the bakery product into the slots. For extra-wide, one-sided
slots, check that the side of the product that is to be toasted faces
the LEFT side of the slot, as shown in Figure 4.
Figure 4 - Loading extra-wide, one-sided slots
Models HT409/424, BTW09/24 only
Side of bakery
product to be
toasted faces
LEFT
2. Turn the color selection knob (if necessary) to set the desired
darkness. A medium color setting is achieved at the 9 oclock
position.
NOTE
It will be necessary to determine the color setting for each different
bakery product that is to be toasted. Test a single piece at the 9
oclock setting, and then adjust the Color Selection Knob as
necessary to find the proper setting.
3. Press the Operating Lever DOWN to lower the product into the
toasting chambers.
4. Wait for the toasting cycle to complete, and the toasted product will
automatically be raised.
OR
Push the Operating Lever UP to manually raise the product at any
time during the toasting cycle.
C. Clearing Jams
WARNING
DISCONNECT THE TOASTER FROM ITS ELECTRICAL
POWER SUPPLY BEFORE ATTEMPTING TO CLEAR A
JAM.
WARNING
DO NOT TOUCH HOT SURFACES ON THE TOASTER,
OR REACH INTO THE TOASTING CHAMBER, UNTIL THE
UNIT HAS COOLED THOROUGHLY.
WARNING
NEVER INSERT A KNIFE, FORK, OR SIMILAR OBJECT
INTO THE TOASTING CHAMBER. THIS CAN CAUSE AN
ELECTRICAL SHOCK OR DAMAGE THE HEATING
ELEMENTS.
D. Cleaning
WARNING
DISCONNECT THE TOASTER FROM ITS ELECTRICAL
POWER SUPPLY BEFORE CLEANING OR SERVICING.
WARNING
DO NOT TOUCH HOT SURFACES ON THE TOASTER,
OR REACH INTO THE TOASTING CHAMBER, UNTIL THE
UNIT HAS COOLED THOROUGHLY.
WARNING
WHEN CLEANING THE TOASTER, NEVER APPLY
ENOUGH LIQUID TO STAND IN PLACE ON THE UNIT.
DO NOT SPRAY, RINSE, OR SUBMERGE THE TOASTER.
EXCESSIVE MOISTURE IN THE UNIT WILL CAUSE A
SEVERE ELECTRICAL HAZARD AND MAY OTHERWISE
DAMAGE THE TOASTER.
CAUTION
DO NOT clean your toaster using abrasive cleaners or pads. Both will
scratch and dull the finish.
1. Wipe the exterior of the toaster with a sponge or cloth soaked in hot
or warm detergent water. Wipe with a clean, damp cloth to remove
the excess detergent, and then wipe again to dry the toaster.
2. Remove the crumb tray, and empty it. Wash the crumb tray in
warm detergent water, and rinse it.
3. After the crumb tray is dry, replace it in the toaster.
3
Loading...