ELECTRIC HOTPLATES
MODEL
TMHPE, TMPHF
Installation and
Operation
Instructions
2M-Z12999 Rev. - Oct. 1, 2009
TMHPE
TMHPF
is a registerd trademark of Toastmaster, A Middleby Company. All rights reserved.
1
2
These symbols are intended to alert the user to the presence of
important operating and maintenance instructions in the manual accompanying the appliance.
RETAIN THIS MANUAL FOR FUTURE REFERENCE
NOTICE
UsinganypartotherthangenuineToastmasterfactorysuppliedpartsrelievesthe
manufacturer of all liability.
Toastmaster reserves the right to change specications and product design
withoutnotice. Suchrevisionsdonotentitlethebuyertocorrespondingchanges,
improvements, additions or replacements for previously purchased
equipment.
Due to periodic changes in designs, methods, procedures, policies and
regulations, the specications contained in this sheet are subject to change
without notice. While Toastmaster exercises good faith efforts to provide
information that is accurate, we are not responsible for errors or omissions
in information provided or conclusions reached as a result of using the
specications. By using the information provided, the user assumes all risks in
connection with such use.
MAINTENANCE AND REPAIRS
Contact your local authorized service agent for service or required maintenance.
Please record the model number, serial number, voltage and purchase date in the area below and have it
ready when you call to ensure a faster service.
SAFETY SYMBOL
Model No.
Serial No.
Voltage
Purchase Date
Business 8:00 am to 4:30 p.m. Central Standard Time
Hours:
Telephone: (800) 807-9054 Local (314) 781-2777
Fax: (800) 396-2677 Local (314) 781-2714
E-mail Parts@star-mfg.com
Service@star-mfg.com
Warranty@star-mfg.com
Website: www.star-mfg.com
The Service Help Desk
Authorized Service Agent
Reference the listing provided with the unit
or
for an updated listing go to:
Website: www.star-mfg.com
E-mail Service@star-mfg.com
Telephone: (800) 807-9054 Local (314) 781-2777
Mailing Address: Star Manufacturing International Inc.
10 Sunnen Drive
St. Louis, MO 63143
U.S.A
2
GENERAL OPERATING INSTRUCTIONS
CAUTION
This equipment is designed and sold for commercial use only by personnel trained and
experienced in its operation and is not sold for consumer use in and around the home nor for
use directly by the general public in food service locations. For equipment to be used by the
general public, please contact the factory.
The Toastmaster models TMHPE & TMHPF Electric Hot Plates are equipped for the voltage
indicated on the nameplate mounted on the front panel. This unit is designed to operate on
alternating current (A.C.), two wire single phase service only.
DO NOT CONNECT TO DIRECT CURRENT (D.C.).
Total Connected Load:
TMHPF: at 240 Volts, Wattage is 5,200
at 208 Volts, Wattage is 3,900
TMHPE: at 240 V
at 208 Volts, Wattage is 3,150
olts, Wattage is 4,200
INSTALLATION
For your protection, we recommend that a qualied electrician install this appliance. The electrician
should be familiar with electrical installations and your local electrical requirements. The
external wiring should be in conduit or an approved type of exible cable and of suitable size
to carry the load. The supply circuit should be properly fused and equipped with a means
of disconnecting as required by local electrical code. The body of the hot plate should be
grounded (Do not ground to a gas supply pipe). The connections are made in this unit at the
pigtail leads located in the junction box on the back of the unit. To gain access to the pigtail
leads remove cover on junction box.
LOCATE THE UNIT
Do not install the unit closer than 1 inch from a side wall and/or closer than 1 inch from a rear wall.
LEVELING UNIT
Level unit by adjusting the (4) feet for accurate and perfect line up with other Toastmaster series units.
CAUTION
DO NOT INSTALL WITHOUT FEET.
CAUTION
USE ONLY FLAT BOTTOM PANS AND POTS! DO NOT USE RAISED BOTTOM UTENSILS
OR BUCKETS! GOOD HEAT TRANSFER DEPENDS UPON GOOD CONTACT BETWEEN
THE ELEMENT AND POT.
NOTE: Using a 12” diameter or larger pan/pot may cause damage to the element or internal wiring.
Such damages are not covered by warranty. Two (2) heating elements are used. For the TMHPF each
element draws 2,600 Watts on 240 Volts and 1,950 Watts on 208 Volts. For the TMHPE element
draws 2,100 Watts on 240 Volts and 1,575 Watts on 208 Volts. Each element is controlled by an
innite position switch. The right control knob controls the rear cooking element and the left control
knob controls the front cooking element. On “HI” the element delivers uninterrupted full heat. Between
“LO” and “5” any desired amount of heat can be obtained between 6% and 60% of full heat.
Signal lights are provided above the control knobs to give a visual check if either one or both heating
units are turned on.
1