TOA WM S300, WM S200 User Manual

UHF WIRELESS SET

WS-200/300

OPERATING INSTRUCTIONS

Thank you for pur

chasing TOA

’

s UHF Wireless Set.

Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment/

Thank you for pur

chasing TOA

’

s UHF Wireless Set.

Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment/

Printed in Taiwan

TOA instruction Manual ARTWORK_2 8/5/06 1:22 pm Page 1

CONTENTS

Introduction and Safety

TOA WS System Overview

Receiver Nomenclature and Operation

Handheld Nomenclature and Operation

Lavalier Nomenclature and Operation

General Set-up and Operating Hints and Fault Finding

System Contents Description and System Part Numbers

Technical Specifications

1.

2.

3.

4.

5.

7.

9.

10.

1

TOA instruction Manual ARTWORK_2 8/5/06 1:23 pm Page 3

When Installing the Unit
(Applicable to the Wireless Tuners)

> Do not expose the unit to rain or an environment
where it may be splashed by water or other liquids,
as doing so may result in fire or electric shock.

> Use the unit only with the voltage specified on the
unit. Using a voltage higher than that which is
specified may result in fire or electric shock.

> Do not cut, kink, otherwise damage nor modify
the power supply cord. In addition, avoid using the
power cord in close proximity to heaters, and never
place heavy objects -- including the unit itself -- on
the power cord, as doing so may result in fire or
electric shock.

> A

void installing or mounting the unit in unstable
locations, such as on a
rickety table or a slanted surface. Doing so may
result in the unit falling down and causing personal
injury and/or property damage.

When the Unit is in Use
(Applicable to the Wireless Tuners)

> Should the following irregularity be found during
use, immediately switch off the power, disconnect
the power supply plug from the AC outlet and
contact your nearest TOA dealer. Make no further
attempt to operate the unit in this condition as this
may cause fire or electric shock.

> If you detect smoke or a strange smell coming
from the unit.
> If water or any metallic objects get into the unit.
> If the unit falls, or the unit case breaks.
> If the power supply cord is damaged, (exposure of
the core, disconnection, etc.)
> If it is malfunctioning (no tone sounds.)

> To prevent a fire or electric shock, never open nor
remove the unit case as there are high voltage
components inside the unit. Refer all ser

vicing to

qualified service personnel.

> Do not place cups, bowls, or other containers of
liquid or metallic objects on top of the unit. If they
accidentally spill into the unit, this may cause a fir

e

or electric shock.

(Common to all WS series)

> T

o pr

event the electromagnetic wave from badly
influencing medical equipment, make sure to switch
off the units power when placing it in close
proximity to the medical equipment.

SAFETY PRECAUTIONS

> Before installation or use, be sure to carefully read all the
instructions in this section for correct and safe operation.

> Be sure to follow all the precautionary instructions in this section, which
contain important warnings and/or cautions regarding safety.

> After reading, keep this manual handy for future reference.

Safety Symbol and Message Conventions

Safety symbols and messages described below are used in this manual to prevent
bodily injury and property damage which could result from mishandling. Before
operating your product, read this manual first and understand the safety symbols and
messages so you are thoroughly aware of the potential safety hazards.

WARNING

CAUTION

WARNING

Indicates a potentially hazardous situation which, if
mishandled, could result in death or serious personal injury.

Indicates a potentially hazardous situation which, if
mishandled, could result in in moderate or minor personal
injury, and/or property damage.

CAUTION

When Installing the Unit

(Applicable to the Wireless Tuners)

> Never plug in nor remove the power
supply plug with wet hands, as doing so
may cause electric shock.

> When unplugging the power supply
cord, be sure to grasp the power supply
plug; never pull on the cord itself.
Operating the unit with damaged power
supply cord may cause a fire or electric
shock.

> When moving the unit, be sure to
remove its power supply cord from the
wall outlet. Moving the unit with the
power cords connected to the outlet
may cause damage to the power cord,
resulting in fire or electric shock. When
removing the power cord, be sure to
hold its to pull.

> Avoid installing the unit in humid or
dusty locations, in locations exposed to
the direct sunlight, near the heaters, or
in locations generating sooty smoke or
steam as doing otherwise may result in
fire or electric shock.

> When the unit is in use

(Applicable to the Wireless Tuners)

> Use the specified AC adaptor for the
unit. Note that the use of other adaptors
may cause a fire.
(Applicable to the Wireless Microphones)

> When the unit is not in use for 10
days or more, be sure to take the
batteries out of the unit because battery
leakage may cause a fire, personal injury,
or contamination of environment.

> Make sure to observe the following
handling precautions so that a fire or
personal injury does not result from
leakage or explosion of the battery.

> Do not short, disassemble, heat nor
put the battery into a fire.
> Avoid using both new and old
batteries together.
> Never charge batteries of the type
which are not rechargeable.
> Do not solder a battery directly.
> Be sure to use the specified type of
batteries.
> Note correct polarity (positive and
negative orientation) when inserting a
battery in the unit.
> Avoid locations exposed to the direct
sunlight, high temperature and high
humidity when storing batteries.

23

TOA instruction Manual ARTWORK_2 8/5/06 1:23 pm Page 5