Toa WA-Z100SD AS Instruction Manual

INSTRUCTION MANUAL
PORTABLE AMPLIFIER WA-Z100SD AS
TABLE OF CONTENTS
1. SAFETY PRECAUTIONS
3. NOMENCLATURE AND FUNCTIONS
4. MASTER PANEL CONTROL
5. POWER AND VOLUME IDENTIFICATION
6. AUDIO MUSIC PLAYER
7. WIRELESS RECEIVER MODULE
8. TRANSMITTERS
8.1.
WM-Z100H Wireless Handheld microphone
8.2. WM-Z100L
Thank you for purchasing TOA's Portable Amplifier. Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment.
Wireless Lavaliere microphone
.................................. 2
................................ 3
............. 4
............................ 5
...... 5
................................... 6
.................... 7
.... 8
.... 8
9. REPLACEMENT OF BATTERY
10. WARNING
11. SPECIFICATIONS
11.1. General specifications
11.2. Microphone specifications
11.3. Channel specifications
........................................... 9
.......... 9
.............. 10
........ 11
.............. 11
1. SAFETY PRECAUTIONS
Be sure to read the instruction in this section carefully before use. Make sure to observe the instructions in this manual as conventions of safety symbols and messages regarded as very important precautions are included. We also recommend you keep this instruction manual handy for future reference.
Safety Symbol and Message Conventions
Safety symbols and messages described below are used in this manual to prevent bodily injury and property damage which could result from mishandling. Before operating your product, read this manual first and understand the safety symbols and messages so you are thoroughly aware of the potential safety hazards.
Indicates a potentially hazardous situation which, if mishandled, could
WARNING
When Installing the Unit
Do not expose the unit to rain or an environment where it may be splashed by water or other liquids, as
doing so may result in fire or electric shock.
Use the unit only with the voltage specified on the unit. Using a voltage higher than that which is specified
doing so may result in fire or electric shock.
result in death or serious personal injury.
Do not cut, kink, otherwise damage nor modify the power supply cord. In addition, avoid using the power
cord in close proximity to heaters,and never place heavy object -- including the unit itself -- on the power cord, as doing so may result in fire or electric shock.
Avoid installing or mounting the unit in unstable locations, such as on rickety table or a slanted surface
Doing so may result in the unit falling down and causing personal injury and/or property damage.
To prevent lightning strikes, install the unit at least five meters away from a lightning rod, and yet within the
protective range (angle of 45° ) of the lightning conductor. Lightning strikes may cause a fire, electric shock or personal injury.
When the Unit is in Use
Should the following irregularity be found during use, immediately switch off the power,disconnect the power
supply plug from the AC outlet and contact your nearest TOA dealer. Make no further attempt to operate the unit in this condition as this may cause fire or electric shock.
If you detect smoke or a strange smell coming from the unit If water or any metallic object gets into the unit If the unit falls, or the unit case breaks the power supply cord is damaged (exposure of the core, disconnection, etc)
Do not place cups,bowls or other containers of liquid or metallic objects on top of the unit. If they accidentally
spill into the unit, this may cause a fire or electric shock.
Do not insert nor drop metallic object or flammable materials in the ventilation slots of the unit’s cover,as this
may result in fire or electric shock.
Do not touch a plug during thunder and lightning, as this may result in electric shock.
To prevent a fire or electric shock, never open nor remove the unit case as there are high voltage
component inside the unit. In addition, modifying the internal parts or circuit may cause the unit to be against the regulations in your country. Refer all servicing to your nearest TOA dealer.
2
Indicates a potentially hazardous situation which, if mishandled, could
CAUTION
When Installing the Unit
Never plug in nor remove the power supply plug with wet hands, as doing so may cause electric shock.
When unplugging the power supply cord, be sure to grasp the power supply plug;never pull on the cord itself.
Operating the unit with a damaged power supply cord may cause a fire or electric shock.
When moving the unit, be sure to remove its power supply cord from the wall outlet. Moving the unit with the
power cord connected to the outlet may cause damage to the power cord, resulting in fire or electric shock. when removing the power cord, be sure to hold its plug to pull.
Avoid installing the unit in humid or dusty locations, in locations exposed to the direct sunlight, near the
heaters, or in locations generating sooty smoke or steam as doing otherwise may result in fire or electric shock.
When the Unit is in Use
Make sure the volume control is set to minimum position before power is switched on. Loud noise produced
at high volume when power is switched on can impair hearing.
result in moderate or minor personal injury, and/or property damage.
Do not place heavy object on the unit as this may cause it to fall or break which may result in personal
injury and/or property damage. In addition, the object itself may fall off and cause injury and/or damage.
Do not stand or sit on, nor hang down from the unit as this may cause it to fall down or drop, resulting in
personal injury and/or property damage.
When the unit is not in use for 10 days or more, or when the AC power is used for operating the unit, be
sure to take the batteries out of the unit because battery leakage may cause a fire, personal injury, or contamination of environment.
Switch off the power, and unplug the power supply plug from the AC outlet for safety purposes when
cleaning or leaving the unit unused for 10 days or more. Doing otherwise may cause a fire or electric shock.
Make sure to observe the following handling precautions so that a fire or personal injury does not result from
leakage or explosion of the battery.
Do not short, disassemble, heat nor put the battery into a fire. Avoid using both new and old batteries together. Do not solder a battery directly. Be sure to use the specified type of batteries. Note correct polarity (positive and negative orientation) when inserting a battery in the unit. Avoid locations exposed to the direct sunlight, high temperature and high humidity when storing batteries.
Do not use trolley on ragged ground to avoid any damage.
2. GENERAL DESCRIPTION
TOA’s WA-Z100SD is a portable amplifier that has an elegant design, durable and water-resistant case. It offers reliable performance, clear, powerful sound, and is simple to operate. Equipped with an audio music player player, music can be played from CD, USB or SD / MMC Card. It has the option of installing up to 2 UHF wireless microphone receiver. Wheels are fitted for moving it around effortlessly. The unit has an operating duration of 3 - 9 hours, depending on the volume.
3
3. NOMENCLATURE AND FUNCTIONS
11
13
1
14A
50cm(H)
12
8
9
10
32cm(W)
55cm(H)
29cm(W)
2
3
4A
14B
4B
5 6
7
1. Carry Handle : To pull or retract the carry handle, press one touch button.
2. Rear Cover : Fixed related operational unit with audio accessories, such as CD player and batteries.
3. Front Cover : Speaker with fixed grill net.
4. Loudspeaker : (4A) 1” tweeter (4B) 10” Woofer
5. Wheel : For moving this unit.
6. Grilled Net : To protect the speaker.
7. Tripod Socket : For tripod stand and rotation of 360 degree to enhance the acoustic fidelity.
8. Power On/Off : [ ] On, power start; [ O ] Off power off, please turn off power to avoid consuming battery
when not in use.
9. AC Power Input : Comply with international voltage 90V-264V.
10. Lead Acid Battery : Instruction for changing battery : Take out 3 pieces of screws and remove batteries from main panel board. Please note to follow the correct operation in order to avoid causing damage to battery. (Positive-red line with red line terminal; negative-black line with black line terminal)
11. The Storage Box : A storage space for microphone, remote control, and AC power cord.
12. Recharging box for Microphone’s battery : Simultaneously charge 4 pieces of 1.2V / 1300mA~2500mA rechargeable batteries for microphone, red light means charging, green continuous light means full load charged.
13. Wireless Receiver compartment for WTU-Z100 (optional).
14. (14A) Rear infrared for remote control.
(14B) Front infrared for remote control.
4
Loading...
+ 8 hidden pages