Timex T150 User Manual
®
NOAA Instant-Weather
Triple Alarm Clock
with Nature Sounds
N
O
A
A
S
O
U
O
N
/S
TIME SET
CAL. SET
SLEEP VOL.
N
D
L
E
E
P
WEATHER ON/SLEEP
OFF
RESET
S
N
O
O
Z
E
/
D
I
M
M
E
R
ALARM
SET
WEATHER
SOUNDS
BUZZER
7-5-2
DAILY ALARM
POWER
FWD
DST
M
ONTH
REV
LOW
DM
LOW
DATE
SUN
O
C
E
AN
Model T150
F
O
R
E
S
T
B
R
O
O
K
W
I
N
D
Weather On/Sleep button
Sounds Button
Weather Button
Alarm Set Button
Sound On/Sleep Button
Time Set Button
Calendar Set Button
Sleep Volume Button
S
O
O
N
TIME SET
CAL. SET
SLEEP VOL.
Snooze/Dimmer Bar
Buzzer Button
DC Jack
Off/Reset Button
NO
A
A
R
W
S
N
EATHER
O
O
Z
WEATHER ON/SLEEP
E
/
D
I
M
S
O
O
F
F
R
E
S
E
M
E
R
U
N
D
S
BUZZER
DST
LOW
T
7-5-2
RM
LA
A
ILY
A
D
D
FW
H
T
N
O
M
REV
E
T
A
D
7•5•2 Button
FWD Button
REV Button
U
N
D
/S
L
E
E
P
ALARM
SET
P
O
W
E
LOW
DM
S
U
N
Volume Control
Ocean Button
O
Forest Button
C
E
AN
F
O
R
E
S
T
B
R
O
O
K
W
I
N
D
Weather Band
Wind Button
Brook Button
Preparation for Use
Preparation for Use
1. Remove the radio and all packing materials from the carton. You should
save all the packing materials if the unit ever needs to be returned for
service. If you do not wish to save the materials, please dispose of
them properly.
2. Place the unit on a stable, level surface, close to an AC outlet, out of
direct sunlight, and away from sources of excess dust, dirt, heat, water,
moisture, vibration and strong magnetic fields.
DC Operation
• This unit can operate on both AC and DC power. An AC adapter was
included with this unit. For further instructions on operating this unit
using AC power, see AC Operation.
•3 “AA” alkaline batteries can operate the unit without AC power. They
will also continue running the unit if it is operating on AC power and
there is a power failure. For best results, you should always have fresh
“AA” alkaline batteries installed in this unit.
• This unit comes with a CR-2032 lithium battery already installed. The
CR-2032 is to maintain the time and alarm settings.
3 “AA” Main Battery Installation
1. Gently turn the unit over and remove the battery compartment door.
2. Install 3 “AA” alkaline batteries, while making sure that the + and – ends
match up with those inside the battery compartment.
3. Close the battery compartment door and turn the unit right side up.
Note: This unit was designed to operate on alkaline batteries only.
You must use alkaline batteries with this unit. When the
batteries are getting weak the Battery Low Icon (
the right side of the display.
LOW
) will flash on
Lithium Battery Backup Installation
1. Gently turn the unit over and open the battery compartment door. If
necessary, remove the 3 “AA” batteries to get to the lithium battery
door.
2. Loosen the screw and remove the lithium battery door.
3. Replace the CR-2032 lithium battery, while making sure that the + and
– ends match up with the markings inside the battery compartment.
4. Place the door back on and tighten the screw, then reinstall the 3 “AA”
batteries and close the battery compartment door.
Note: This unit comes equipped with a CR-2032 lithium battery used for
battery backup purposes only. When the lithium battery is getting
weak the Lithium Battery Low Icon (
of the display.
LOW
) will flash on the left side
Battery Backup System
If the unit is being operated through AC power and there is a power
interruption, the 3 “AA” batteries will takeover and run the unit. All settings,
alarms, and instant weather will operate.
If the unit is operating through DC power (3 “AA” batteries) and there is a
power interruption, then the lithium battery (CR-2032) will maintain the time
and alarm time settings and operate the sure alarm. The sure alarm will
default all alarms to buzzer and turn on for 2 minutes.
All settings will be lost if there is a power failure and no batteries are installed.
Loading...