Page 1
Model T141
Alarm Clock
For additional information, online registration,
and exclusive special offers visit our website:
www.timexaudio.com
For questions or comments regarding this or other products,
please call our toll-free number 1-800-888-4491.
Para instruccionese en Espanol, llame al 1-800-888-4491.
Page 2
PM Indicator
Alarm Indicator
Controls and Indicators
Snooze Button
Battery Low
Indicator
Hour Button
Minute Button
Time Set Button
Alarm Set/Reset
Button
Alarm Mode Switch
1 2 3 4
Page 3
Installation
Note: After installing the Battery Backup and reading through the Maintenance, plug
the AC line cord correctly into a wall outlet. When the unit is connected to AC
power for the first time the display may blink.
Battery Backup
If the Backup Battery has been installed and a power failure occurs or the AC cord is
accidentally disconnected, the display will not remain lit, but the current time and alarm
time settings will be temporarily maintained.
If the Backup Battery has not been installed or is dead, when the AC power resumes
the display will flash and you must reset the time and alarm settings.
1. Open the battery compartment cover.
2. Install a 9 volt battery (alkaline is recommended for longer life).
Note: You should replace the 9-volt battery every six months or after a power outage
of approximately 10 hours or longer.
Battery Low Indicator
A Battery Low Indicator is located in lower right corner of the display . When the indicator
lights up it is time to replace the 9V backup battery.
Battery Compartment
Page 4
Setting Clock Time and Alarm Time
Setting Clock Time
1. Press and hold the Time Set Button, then press the Hour Button until the current
hour is display. Remember to set the correct AM or PM. A small dot in the upper
left hand corner of the display is the PM Indicator.
2. Press and hold the Time Set Button, then press the Minute Button until correct
time is displayed.
Set ting Alarm Time
1. Press and hold the Alarm Set/Reset Button, then press the Hour Button until the
correct hour is display. Remember to set the correct AM or PM. A small dot in the
upper left hand corner of the display is the PM Indicator.
2. Press and hold the Alarm Set/Reset Button, then press the Minute Button until
correct time is displayed.
Alarm Operation
1. Set alarm time as indicated in Setting Alarm Time.
2. Set the Alarm Mode Switch to "On". Alarm Indicator will appear in the lower left
corner of the display indicating the alarm function is on. The alarm is now set to turn
on automatically at the time selected.
Note: The alarm will play for approximately 2 hours and turn off automatically. This
cycle will repeat every 24 hours unless the controls are changed.
3. The alarm is equipped with a "Gentle Wake" alarm system. When the alarm goes
on it will begin at a low level and gradually become louder until it reaches maximum
volume or unit you stop the alarm.
4. While the alarm sounding, press the Alarm Set/Reset Button to turn off alarm. The
alarm will come on again the next day at the same time.
5. To stop the alarm from coming on the following day, set the Alarm Mode Switch
to OFF.
6. If the alarm is not turned off after it sounds it will play for approximately 2 hours then
turn off automatically. This cycle will repeat every 24 hours unless the controls are
changed.
Page 5
Snooze Operation
1. Press the Snooze Button after the alarm sounds, the alarm will go off and will
come on again in approximately 9 minutes. You may repeat this cycle several times
during the 2 hours alarm cycle.
Maintenance
Place the unit on a level surface away from sources of direct sunlight or excessive
heat.
Protect your furniture when placing your unit on a natural wood and lacquered
finish. A cloth or other protective material should be placed between it and the
furniture.
Clean your unit with a soft cloth moistened only with mild soap and water . Stronger
cleaning agents, such as Benzine, thinner or similar materials can mar the surface
of the case.
Page 6
CAUTION
RISK OF ELECTRIC SHOCK.
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user of the
presence of uninsulated "dangerous voltage" within the
product's enclosure that may be of sufficient magnitude
to constitute a risk electric shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user of the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
The symbols above are located at the rear of the cabinet.
CAUTION: To prevent electric shock, match wide blade of plug to
wide slot. Fully insert.
Page 7
A Consumer Guide to Product Safety
This unit has been designed and manufactured to assure your personal safety. Improper use can
result in potential electrical shock or fire hazards. Please read all safety and operating instructions
carefully before installation and use. Keep these instructions handy for future refer ence. Take special
note, and adhere to all warnings on the unit and in the instruction and service manual.
1. Water and Moisture — The unit should not be used near water. For example, near a bathtub,
washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc.
2. Ventilation — The unit should be situated so that its location or position does not interfere
with its proper ventilation. For example, it should not be situated on a bed, sofa, rug, or similar
surface that may block the ventilation openings; or placed in a built-in installation, such as
bookcase or cabinet that may impede the flow of air through the ventilation openings.
3. Heat — The unit should be situated away from heat source such as radiators, heat register,
stoves, or other appliances (including amplifiers) that produce heat.
4. Power Sources — The unit should be connected to a power supply only of the type described
in the operating instructions or as marked on the appliance.
5. Grounding or Polarization — This product is equipped with a polarized alternating current
line plug (a plug having one blade wider than the other). This plug will fit into the power outlet
only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet,
try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your
obsolete outlet. Do not defeat the safety purpose of the polarized plug.
6. Power Cord Protection — Power-supply cords should be routed so that they are not likely
to be walked on or pinched by items placed upon or against them. Paying particular attention
to cords at plugs, convenience receptacles, and the points where they exit from the unit.
7. Cleaning — The unit should be cleaned only as recommended by the manufacturer.
8. Nonuse Periods — The power cord of the unit should be unplugged from the outlet when it
is to be left unused for a long period of time.
9. Object and Liquid Entry — Care should be taken so that objects do not fall and liquids are
not spilled into the enclosure through openings.
10. Damage Requiring Service — The appliance should be serviced by qualified service personnel
when:
A. The power-supply cord or plug has been damaged.
B. Objects have fallen into or liquid has been spilled into the enclosure.
C. The unit has been exposed to rain.
D. The unit has been dropped or the enclosure damaged.
E. The unit does not appear to operate normally or exhibits a marked change in performance.
11. Servicing — The user should not attempt to service the unit beyond that described in the user's
operating instructions. All other servicing should be referred to qualified service personnel.
Page 8
Limited 90-Day Warranty Information
Timex Audio Products, a division of SDI Technologies Inc. (hereafter referred to as SDI
Technologies), warrants this product to be free from defects in workmanship and materials,
under normal use and conditions, for a period of 90 days from the date of original purchase.
Should service be required by reason of any defect or malfunction during the warranty
period, SDI Technologies will repair or, at its discretion, replace this product without charge
(except for a $3.00 charge for handling, packing, return UPS/postage, and insurance). This
decision is subject to verification of the defect or malfunction upon delivery of this product
to the Factory Service Center listed below. The product must include proof of purchase,
including date of purchase. The fee for service after the warranty period or without proof
of purchase is $6.00.
Before returning this product for service, please first replace the batteries (if applicable)
with fresh ones, as exhausted or defective batteries are the most common cause of problems
encountered.
If service is still required:
1. Remove batteries (if applicable) and pack the unit in a well-padded, heavy corrugated box.
2. Enclose a photocopy of your sales receipt, credit card statement, or other proof of the date
of purchase.
3. Enclose a check or money order payable to the order of Soundesign, for the sum of $3.00
(or $6.00 if after the warranty period or without proof of purchase).
4. Send the unit prepaid to the Factory Service Center listed below:
NOTE: This warranty is valid only if the product is used for the purpose for which it was
designed. It does not cover (i) products which have been damaged by negligence, misuse or
accident, or which have been modified or repaired by unauthorized persons; (ii) cracked or
broken cabinets, or units damaged by excessive heat; (iii) damage to tape cassettes (if
applicable); (iv) the cost of shipping this product to the Factory Service Center and its return
to the owner.
This warranty is valid only in the United States of America and does not extend to owners of
the product subsequent to the original purchaser. Any applicable implied warranties are also
limited to 90 days, and SDI Technologies will not be liable for consequential damages. (Some
states do not allow limitations on implied warranties or exclusion of consequential damages,
so these restrictions may not apply to you.) This warranty gives you specific legal rights, and
you may also have other rights which vary from state to state.
Consumer Repair Department
SDI Technologies Inc.
Timex Audio Products Division
1401 Pullman Drive
El Paso, Texas 79936-7726
TIMEX is a registered trademark of Timex Corporation the United States and other countries.
T141-052104-0 Printed in China
Loading...