LED PIR Floodlight
Models:
STFL10PIRB
STFL20PIRB
STFL30PIRB
STFL50PIRB
1
1. General Information
These instructions should be read carefully and retained for further reference
and maintenance.
2. Safety
• Before installation or maintenance, ensure the mains supply to the luminaire
is switched off and the circuit supply fuses are removed or the circuit breaker
turned off.
• It is recommended that a qualified electrician is consulted or used for
the installation of this luminaire and install in accordance with the
current IEE wiring and Building Regulations.
• Check that the total load on the circuit including when this luminaire is fitted
does not exceed the rating of the circuit cable, fuse or circuit breaker.
3. Technical Specifications
• 230V AC, 50Hz
• These luminaires are of class I construction and must be earthed
• Energy Efficiency: Class A+
• Colour Temperature: 4000K
• IP65 Rated suitable for restricted external applications
• Detection Angle: 110°
• Detection Range: Up to 10 metres
• Time On Adjustment: 3 seconds to 18 minutes
• Dusk Level Adjustment: Day and Night or Night only operation
• CE Approved
STFL10PIRB
• 10W LED Non replaceable lamp
• Energy Usage: 10kWh/1000h
• Lumen Output: 900lm
STFL20PIRB
• 20W LED Non replaceable lamp
• Energy Usage: 20kWh/1000h
• Lumen Output: 1800lm
STFL30PIRB
•
30W LED Non replaceable lamp
• Energy Usage: 30kWh/1000h
• Lumen Output: 2700lm
STFL50PIRB
• 50W LED Non replaceable lamp
• Energy Usage: 50kWh/1000h
• Lumen Output: 4500lm
4. Installation Advice
As the detector responds to changes in temperature, avoid the following situations:
• Pointing the detector towards objects with highly reflective surfaces,
such as pools of water or white-painted walls.
• Mounting the detector near heat sources, such as heating vents,
air conditioning units, lights etc.
• Pointing the detector towards objects that may move in the wind,
such as curtains, tall plants etc.
• Recommended installation height is 2.5m above ground, the maximum
detection range about 10 m and at the angle of about 110°.
2m
2
2.5m
2m
up to 10m
110°
up to 10m
up to 6m
110°
Walk across
2m
110°
Walk towards
3
5. Installation Procedure
5.1 Mark the position of the mounting holes
on the wall using the U bracket supplied
as a template.
5.2 Drill the holes for the wall plugs ensuring
not to infringe with any gas/water pipes
or electrical cables that may be hidden
below the surface.
5.3 Fix the U bracket to the wall using
the correct screws for the wall
plugs installed.
Loading...