Thule Top Deck 881 Installation Instructions Manual

TOP DECK
PARTS INCLUDED
B D
881
A
part
A saddle / 753-3565 4
B hook / 853-5465 2
C carriage bolt M6 x 50mm / 915-0650-31 8
D metal bracket / 853-5513 4
E 3 wing knob / 753-0745 8
F 1/4" rope / 853-5466 2
G strap / 753-2030-04 2
C E F G
description
WARNINGS / LIMITATIONS
• Load bars
safe use.
• Ensure that
loading or unloading; otherwise, damage to vehicle or boat could occur.
• For extra
Slide mat (#854, sold separately) or a towel on the edge of the vehicle’s roof during loading/unloading.
• Ensure bottom
damaging boat surface.
• Always tie
bumpers or tow hooks.
• Do not
installed bars.
• Ensure load
to vehicle.
• Failure to
must be at least 24" (610mm) apart for
boat does not contact vehicle while
vehicle protection, place the Thule Water
of hull is clean before loading to avoid
down bow and stern of boat to vehicle
exceed weight limitation of racks or factory
carrier is properly installed and tight
follow above guidelines voids warranty.
NOTE: After kayak use in salt water conditions,
please rinse off kayak carrier with fresh water to keep salt residue off the rack.
5015500_04
1
2
• Insert carriage
Tighten loosely.
• Place assembly
• Loosely attach other carriage bolt and knob as shown.
• Repeat
bolt through bracket and assembly base into wing knob.
onto bar as shown.
above
steps for all 4 saddle assemblies.
3
NOTE: Load bars must be at least 24" (610mm) apart for safe use.
Position saddles for the approximate width of your boat.
5015500_04
Loading...
+ 2 hidden pages