• Turn the knob at the top of the radio clockwise. The display lights up
showing the last used channel and the battery level.
• Select channel 16 (Distress or Safety), press the 16/C key.
• Press the PTT and say:
— “MAYDAY, MAYDAY, MAYDAY”,
— “This is”..... ships name repeated three times
—
— “MAYDAY”
— “This is”..... ships name and call sign,
— The ship’s position in latitude and longitude or other reference
to a known geographical location,
— The nature of distress and assistance wanted,
— Any other information which might facilitate the rescue.
— “OVER”
• SAILOR is a registered trademark of Thrane & Thrane A/S.
• Other product and company names mentioned in this manual may be
trademarks or trade names of their respective owners.
Warranty limitation
IMPORTANT - The radio is a sealed waterproof unit. To create and maintain its
waterproof integrity it was assembled in a controlled environment using special
equipment. The radio is not a user maintainable unit, and under no circumstances
should the unit be opened except by authorized personnel. Unauthorized opening
of the unit will invalidate the warranty.
Disclaimer
Any responsibility or liability for loss or damage in connection with the use of this
product and the accompanying documentation is disclaimed by Thrane & Thrane.
The information in this manual is provided for information purposes only, is
subject to change without notice, may contain errors or inaccuracies, and
represents no commitment whatsoever by Thrane & Thrane. This agreement is
governed by the laws of Denmark.
Manuals issued by Thrane & Thrane are periodically revised and updated. Anyone
relying on this information should satisfy himself/herself as to the most current
version. Providers with access to Thrane & Thrane's Extranet may obtain current
copies of manuals at: http://extranet.thrane.com.
Thrane & Thrane is not responsible for the content or accuracy of any translations
or reproductions, in whole or in part, of this manual from any other source.
0709
i
Precautions
Avoid water and salt in the I/O connector and keep it
clean frequently.
Only use original Thrane & Thrane battery packs. Make
sure they are clean and dry before attaching the
transceiver. Be careful not to damage any gaskets.
Only use the original Thrane & Thrane charger for the
rechargeable battery.
Be very careful when handling the Lithium batteries.
With correct use they are safe but any misuse might
cause dangerous situations.
Never short circuit the battery terminals, never expose
the transceiver and the batteries to extreme temperature
or fire and never use any kind of violence.
Avoid close contact between the antenna and parts of
the human body. The top of the antenna must never be
closer than 5 cm to the body when transmitting.
Do not submerge the transceiver more than 1 m for 30
minutes.
Keep the transceiver at least 0.3 m away from the
magnetic compass.
ii
0709
Training information
SAILOR SP3510 VHF GMDSS is designed for "occupational use only". It must be
operated by licensed personnel only.
The SP3510 complies with the FCC RF exposure limits for "Occupational Use Only".
• FCC OET Bulletin 65 Supplement C, evaluating compliance with FCC guidelines
for human exposure to radio frequency electromagnetic fields.
• American National Standards Institute (C95.1) IEEE standard for safety levels
with respect to human exposure to radio frequency electromagnetic fields,
3 kHz to 300 GHz.
• American National Standards Institute (C95.3) IEEE recommended practice for
the measurement of potentially hazardous electromagnetic fields - RF and
microwaves.
Warning! Your Thrane & Thrane VHF radio generates
electromagnetic RF (radio frequency) energy when
transmitting. To ensure that you are not exposed to excessive
amounts of energy and thus to avoid health hazards from
excessive exposure to RF energy, all persons must be at least 5
cm away from the antenna when the radio is transmitting.
Correct use
For best performance, hold the radio vertically and 10 cm away from the head when
talking into the microphone.
0703
iii
iv
0641
Contents
Chapter 1 Introduction
Your VHF .............................................................................1
The SP3510 VHF is designed for flexibility in daily
use. It connects easily to external equipment like
headsets and fist mikes, making the SP3510
suitable for any noisy environment.
Main features:
Unique man machine interface, an excellent
grip even with gloves, and large tactile
buttons.
Display with red adjustable backlight which
makes the display visible even at night.
Built-in “sleep” function, minimizing power
consumption and improving battery lifetime.
A lanyard and belt clip included.
A huge accessory program comes with the
SAILOR SP3500 series.
Please find the nearest SAILOR distributor on
www.thrane.com.
Chapter 1
0643
1
Introduction
Performance
For best performance of the transceiver keep the following in mind:
•Keep clear of metal environment.
•Hold the transceiver vertically and 10 cm from lips and push the PTT
when transmitting.
•In receive mode carry the transceiver vertically with belt clips.
•To preserve battery power, adjust squelch to close the loudspeaker
when there is no signal.
•If you are in a lifeboat keep the antenna as high as possible.
Channels
This radio operates with the following channels, depending on the
configuration (see the notes on the next pages):
19172560687785US W-ch.CA W-ch.
2 10182661697886W1 W8 W1
311192762717987W2W9W2
412202863728088W3W10W3
51321647381W4
61422657482W5
71523 667583W6
81624677684W7
2
0709
Introduction
Channel modes
The notes in the following sections list the channel restrictions that apply
for each channel mode.
For information on how to select a channel mode, see
configuration mode
Please familiarize yourself with the local laws on how to operate this type
of equipment.
on page 17 and
CHAN
on page 18.
Entering and using
International channels
Note:
Tx power is limited to 1 W on channels 75 and 76.
US channels
Notes:
•TX power is limited to 1 W on channels 13, 67 and 77.
•The channels 2, 4, 60, 61, 62, 75 and 76 cannot be selected.
•The Weather channels (US W-ch. in the channel table) can only be
used in Rx direction.
•Channel 15 can only be used in Rx direction. Tx direction is blocked.
•The channels 1, 3, 5, 7, 18, 19, 21, 22, 23, 63, 64, 65, 66, 78, 79, 80, 81,
82 and 83 may only be used as simplex channels (and is marked A).
Channel 20 may be used as duplex and simplex.
0703
3
Introduction
Canadian channels
Notes:
•Tx power is limited to 1 W on channels 15, 17, 20, 65, 66 and 77.
•The channels 19, 22, 63, 75, 76 and 81 cannot be selected.
•The Weather channels (CA W-ch. in the channel table) can only be
used in Rx direction.
•The channel 21 can only be used in Rx direction. Tx direction is
blocked.
•The channels 4, 5, 7, 18, 19, 21, 22, 61, 62, 64, 65, 66, 78, 79, 80, 81 and
82 may only be used as simplex channels (and marked A). Channel 83
may be used as duplex and simplex.
Inland Waters (BI) channels
Notes:
•TX power is limited to 1 W on channels 15 and 17.
•ATIS function is enabled on all channels.
•Dual watch and Scanning modes are disabled.
ATIS is automatically transmitted after each transmission in Inland
Waters. See
sign.
ATIS
on page 18 for information on how to program the call
4
0709
Operation
Controls
Chapter 2
Keys and buttons
1. On/off/volume
2. Light/Lock
3. Push To Talk (PTT)
4. Up key
5. Down key
6. Hi/Lo output power
7.S q ue l c h
8. Scan
9. Priority channel (16)/
Call channel
0643
1
2
3
4
5
6
7
8
9
5
Operation
Key presses
Pressing and holding certain keys gives access to additional functions,
shown in the table below.
Extra long
press
(3 beeps)
Run through
available
items if an A
or B channel
is tagged
Key
Show next available
item in the list (up or
down).
Default: Channel
selection
Short press
(1 beep)
Long press
(2 beeps)
Run through available
items, or
select tagged channels
A (
T) or B (S).
Activate Squelch
control (Adjust with
up/down arrows).
1 press: Activate/
terminate Dual/Triple
watch.
2 presses: Activate
memory scan.
Toggle between high
and low transmitter
power.
Select channel 16.Select programmed
6
Monitor function. Open
Squelch completely.
Set period of time in
configuration mode.
Add/Delete channel
from memory scan.
Call channel.
Program Call
channel.
0703
The display
The display holds various fields of information, explained below.
456
3
2
1
7
8
9
Operation
11
10
1. Current working channel.
2. Current channel mode.
3. “Lo”: Reduced transmitter power.
Full transmitter power is not shown in display.
4. Dual/Triple watch activated.
5. Current working channel is marked for scanning.
6. Keypad is locked.
7. Battery level indicator.
8. Transmitting (Tx) /Receiving (Rx).
9. Accessory is connected.
10. Service line for various purposes. In this example the volume level.
11. Duplex channel.
0703
7
Loading...
+ 33 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.