Page 1
THE CD PLAYER
1
EN
1. CONTROL switch. To lock or unlock
the buttons
2. VOLUME. To adjust the
volume.
3. PHONES jack. Insert your phones
here.
4. DC jack. You can insert the adapter
instead of batteries for indoor use.
5. For random playback.
6. MODE button. For repeat or
introscan function.
7. PROG/DISPLAY button. T o program
& display.
8. Press to adjust Bass Boost level.
9. STOP button. Press to stop CD play.
10. PLAY/PAUSE button. Press to play
CD.
11. Skip up one track.
12. Skip down one track.
13. Display Panel. More information
on Page 6.
14. OPEN switch. Slide to open CD
door.
SAFETY INFORMATION
Thomson Information
CAUTION!
Invisible laser radiation when open. Avoid exposure to beam. Class 3B laser product. This system
must be opened only by qualified technicians to
prevent accidents caused by the laser beam.
LASER λ = 780 nm, P max = 5 mW
Rating Information: At bottom of the unit
this unit comply with the existing requirements
In accordance with the rating plate of the unit,
this unit complies with current standards concerning electrical safety and electromagnetlc
compatibility.
2
EN
Please respect the environment Before throwing any batteries away, consult your
distributor who may be able to take them back for specific recycling.
CLASS 1 LASER PRODUCT
LASER KLASSE 1
APPAREIL A LASER DE CLASSE 1
LUOKAN 1 LASERLAITE
KLASS 1 LASERAPPARAT
CAUTION – INVISIBLE LASER
RADIATION WHEN OPEN AND
INTERLOCKS FAILED OR DEFEATED.
AVOID EXPOSURE TO BEAM.
ATTENTION – RAYONNEMENT LASER
INVISIBLE DANGEREUX EN CAS
D'OUVERTURE ET LORSQUE LA
SECURITE EST NEUTRALISEE.
EXPOSITION DANGEREUSE AU
FAISCEAU.
P
R
O
G
/
M
O
D
E
D
I
S
P
L
A
Y
S
H
U
F
F
L
E
B
.
B
O
O
S
T
P
O
R
T
A
B
L
E
C
O
M
P
A
C
T
D
I
S
C
P
L
A
Y
E
R
B
A
S
S
B
O
O
S
T
DIGITAL SOUND
PROCESSING
TRACK MIN SEC
1 bit D/A
CONVERTOR
BASS BOOST
P
PHONESVOLUME
DC IN 4.5V
HOLD ON
CONTROLS
OPEN
1
2
3
4
5
6
7
8
9
10
11
12
13
14
1
RP2300/LAD770 eng 6/21/01 3:12 PM Page 4
Page 2
Listening to a Compact Disc
1. Slide the OPEN switch to the right
to open the door. Insert a disc and
press lightly on the centre to
lock. Close the door. Press PLAY/PAUSE
button. R
D
DDIISSCC
will appear in the
display. Then, the total
number of tracks and
time of the CD will be
displayed. If the
disc compartment
is empty or the
disc cannot be
played, NO DISC
will appear in
the display.
2. Shift CONTROL
switch to
“HOLD”
position to lock the
button to avoid
accidental activation of
unwanted functions.
You can also change tracks or quickly listen
to part of a track by pressing
down or holding
Repeating
You can replay the entire CD or one track
as many times as you wish as well as listen
to the beginning of each track for 10 seconds
Press MODE successively to
1. Replay the entire CD
2. Replay the current track.
3. Replay the beginning of each track
for 10 seconds.
The number of the track begin played will
be displayed and SCAN will appear.
4. Press again to de-select the
function.
Program
This function lets
you listen to the
tracks you selected
in the order you
want. The CD play-
er must be in Stop
mode.
1. Press PROG/DISPLAY
button. P will appear in the
display.
2. Select the track to store by pressing
& press PROG/DISPLAY
again to confirm.
3. Return to step 2 to store other tracks.
4. Press PLAY/PAUSE button to listen to
your programming.
Note: The unit switches off automatically
after 30s if no key has been activated to
prevent excessive battery consumption.
When programming, the unit can switch
3
THE CD PLAYER
P
R
O
G
/
M
O
D
E
D
I
S
P
L
A
Y
S
H
U
F
F
L
E
B
.
B
O
O
S
T
P
O
R
T
A
B
L
E
C
O
M
P
A
C
T
D
I
S
C
P
L
A
Y
E
R
B
A
S
S
B
O
O
S
T
DIGITAL SOUND
PROCESSING
TRACK MIN SEC
1 bit D/A
CONVERTOR
BASS BOOST
P
EN
or
MAINS OUTLET POWER
SUPPL Y
You can power your CD player with the
supplied AC/DC adaptor. Refer to the table
for details of the operating voltage of the
adaptor supplied with your unit.
AC/DC adaptor is purposed for indoor use
in dry rooms only. Remove the jack from
the device to use it with the batteries.
Note : Power is fed to the unit even when
it is not functioning. To cut the power supply off, the AC/DC adaptor must be
unplugged.
BATTERIES POWER SUPPLY
Refer to the table for details of the batteries required to operate your unit.
Recharge function (Thomson Models)
—
To charge Ni-Cd batteries (not included):
Insert 2 rechargeable batteries in the compartment. Turn the switch to the ON position at the back of the unit. Connect the
main adaptor. The batteries take about
eight hours to become fully charged if the
player is not operating. Important : If you
use your CD player with non rechargeable
batteries, turn OFF the switch at the back
of the unit in order to prevent any damage to the unit or batteries.
THE CD PLAYER
EN
4
Model Number Adaptor Batteries
3-8078 240V 50Hz AAx2
( Not included)
or
RP2300/LAD770 eng 6/21/01 3:12 PM Page 6
Page 3
MORE INFORMATION
MORE INFORMATION
USEFUL ADVICE
• Do not store CDs in damp areas.
• Do not expose CDs to high
temperatures or direct sunlight.
• Do not put any tape or adhesives on
either side of the disc.
• You should avoid leaving the CD
door open. Dust is liable to impair
performance of the laser optical unit.
• Do not use your set immediately
after transport from a cold place to a
warm place : there may be
condensation problems.
• Do not touch the playing surface.
Make sure that you keep your set
away from water and high
temperatures.
• If you do not use your set on battery
power for more than one month, we
advise you to take out all the batteries.
• To prevent personal injury , do not
reverse any battery and do not mix
battery types.
• Discard leaking batteries immediately.
Leaking batteries can cause skin burns
or other personal injury.
• Thomson recommends Duracell Ultra
Batteries.
Caution : Charge batteries
if the switch at the back of the unit is
ON (for Thomson Model only).
Do not attempt to charge non Ni-Cd
batteries, you may damage the unit and
batteries.
• Prolonged use of the CD player at full
volume can damage the user’s ear .
• SPC : Soud Pressure Control at 100dB
maximum (only for Thomson models)
PLEASE RESPECT
THE ENVIRONMENT !
Before throwing any batteries away,
consult your distributor who may be able
to take them back for specific recycling.
MAINTENANCE
Clean the player with a soft cloth, or a
damp chamois leather. Never use solvents.
TECHNICAL SPECIFICATIONS
* Frequency response: 20Hz to 20kHz
Power Supply
• 4.5V DC (through AD/DC adaptor
(refer to table page 4 for details)
• 2 batteries
( Duracell Ultra recommended)
• 2 rechargeable Ni-cd batteries
(recharge function on Thomson
models)
• 4.5VDC ( through car DC adaptor
RP2365 & RP2375)
EN
off if you do not press any key within 10s.
If the unit switches off, the programme
will be stored in memory. Resume programming as normal by turning the unit
on again.
You can program up to 24 tracks.
To play your program again, press play .
To add/edit tracks to the program, go to
stop mode ; press and hold PROG/DISPLAY
button again. Refer to step 2 of the above
paragraph.
To check the program, press PLAY and
.
To cancel your program, press and hold
the mode key when you are in the stop
mode. ERASE will appear in the display.
The program will be automatically canceled.
To exit program mode, remove Pfrom the
display by pressing STOP then PROG/DIS-
PLAY.
Random tracks play
1. Listen press PLAY
key.
To cancel this function, de-select
PAUSE
Suspend the playback PLAY/PAUSE but-
ton. The minutes and secondes flash
when interrupted
STOP
Stop playback by pressing STOP button.
The player switches off automatically
after 30 seconds. Press twice stop key to
stop your CD player.
REMAIN TIME
Display remaining time in the play mode.
At play mode, press to display information
about CD playing time.
THE DISPLA Y
1. Repeat
entire disc
2. Repeat
current
track
3. RANDOM
TRACKS
4. PROGRAM
5. Is displayed when the
control button is on HOLD position.
6. Is displayed when Bass Boost is ON.
5
THE CD PLAYER
2. Press
BASS BOOST
P
EN
6
51 23 4
RP2300/LAD770 eng 6/21/01 3:12 PM Page 8
Page 4
Canadian Warranty
Thomson Consumer Electronics Canada, Inc. warrants to the purchaser or gift recipient that if any
manufacturing defect becomes apparent in this product within 1 year from the original date of purchase, it will be replaced free of charge, including return transportation.
This warranty does not include damage to the product resulting from accidents, misuse or leaking batteries.
Should your product not perform properly during the warranty period, either:
1. Return it to the selling dealer with proof of purchase for replacement,
OR
2. Remove the batteries (where applicable), and pack product complete with accessories in the
original carton (or equivalent).
— Mail prepaid (with proof of purchase) and insured to:
Thomson Consumer Electronics Canada, Inc.
Distribution Centre
7400 A Bramalea Road
Mississauga, Ontario L5S 1X1
The provisions of this written warranty are in addition to and not a modification of or subtraction
from the statutory warranties and other rights and remedies contained in any applicable legislation,
and to the extent that any such provisions purport to disclaim, exclude or limit any such statutory warranties and other rights and remedies, such provisions shall be deemed to be amended to the extent
necessary to comply therewith.
If you are unable to find a qualified servicer for out of warranty service, you may write to:
Thomson Consumer Electronics Canada, Inc.
P.O. Box 0944
Indianapolis, Indiana, U.S.A., 46206-0944
Attach your sales receipt to this booklet for future reference. This information is required if service is
needed during the warranty period.
PURCHASE DATE
NAME OF STORE
Model Number:
3-8078
Printed in Hong Kong
©1999 Thomson Consumer Electronics, Inc.
10330 North Meridian Street
Indianapolis, IN 46290-1024
Trademark(s)® Registered
Marca(s) Registrada(s)
Marque(s) ® déposée(s)
8
EN
US Warranty
7
What your warranty covers:
• Any defect in materials or workmanship.
For how long after your purchase:
• One year (The warranty period for rental units begins with the first rental or
45 days from date of shipment to the rental firm, whichever comes first.)
What we will do:
• Provide you with a new, or at our option, a refurbished unit.
• The exchange unit is under warranty for the remainder of the original
product's warranty period.
How to make a warranty claim:
• Properly pack your unit. Include any cables, etc., which were originally provided
with the product. We recommend using the original carton and packing materials.
• Include in the package evidence of purchase date such as the bill of sale. Also
print your name and address and a description of the defect. Send standard UPS or
its equivalent to:
Thomson Consumer Electronics, Inc.
Product Exchange Center
11721 B Alameda Ave.
Socorro, TX 79927
• Pay any charges billed to you by the Exchange Center for service not covered by
the warranty.
• Insure your shipment in case of loss of damage. Thomson accepts no liability in case
of damage or loss.
• A new or refurbished unit will be shipped to you prepaid freight.
What your warranty does not cover:
• Customer instruction. (Your Owner's Manual provides information regarding
operating instructions and user controls. For additional information, ask your dealer.)
• Installation and set-up service adjustments.
• Batteries.
• Damage from misuse or neglect.
• Products which have been modified or incorporated into other products.
• Products purchased or serviced outside the USA.
• Acts of God, such as but not limited to lightning damage.
Product Registration:
• Please complete and mail the Product Registration Card packed with your unit.
It will make it easier to contact you should it ever be necessary. The return of the card is
not required for warranty coverage.
How state law relates to this warranty:
• This warranty gives you specific legal rights, and you may have other rights which vary from
state to state.
If you purchased your product outside the USA:
• This warranty does not apply. Contact your dealer for warranty information.
EN
RP2300/LAD770 eng 6/21/01 3:12 PM Page 10
Page 5
This page is empty.
Please do NOT output film for
this page.
RP2300/LAD770 eng 6/21/01 3:12 PM Page 12
Loading...