The Singing Machine SMK480M Instruction Manual

SMK480M

www.singingmachine.com/kids

The Singing Machine® is a registered trademark of The Singing Machine Co., Inc.

The Singing Machine Company, Inc.

4060 E Jurupa Street, Unit B

Ontario, CA 91761-1413 USA

Copyright © 2017 All Rights Reserved.

PRINTED IN CHINA

480M-1702-ENG02

Line in Cable

Manual

Please make sure that the following items are included.

Included

Play / Pair buttonRecord button

Record

indicator

Volume +
button

Volume ­button

Handle

Song 1 - 3
button

Effect 1 - 3
button

RECORD

PLAY/PAIR

VOLUME

1

2

3

+

-

1

2

3

SONG EFFECT

INSTRUCTION MANUAL

Warnings

DANGEROUS VOLTAGE: The lightning flash

with arrowhead symbol within an equilate ral
triangle is intended to alert the user to the
presence of uninsulated dangerous voltage
within the product’s enclosure that may be
of sufficient magnitude to constitute a risk of
electric shock to persons.

WARNING: TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.

WARNING: CHOKING HAZARD- Small parts. Not for children
under 36 months.

ATTENTION: The ex clamation point within
an equilateral triangle is intended to alert the
user to the presence of important operating
and maintenance (servicing) instructions in the
literature accompanying this product.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

Important Safety Information

FCC WARNING: This equipment may generate or use radio frequency

energy. Changes or modifications to this equipment may cause harmful
interference unless the modifications are expressly approved in the
instruction manual. The user could lose the authority to operate this
equipment if an unauthorized change or modification is made.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

• The rating information is located at the bottom of the unit.

INDUSTRY CANADA NOTICE:

This device complies with Industry Canada Iicense-exempt RSS
standard(s). Operation is subject to the following two conditions:

1. This device may not cause interference, and

2. This device must accept any interference, including interference that
may cause undesired operation of the device.

CAN ICES-3(B)/NMB-3(B)

CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE. REFER

SERVICING TO QUALIFIED SERVICE PERSONNEL.

The Caution marking is located on the bottom panel.

1. Read these Instructions.

2. Keep these Instructions.

3. Heed all Warnings.

4. Follow all Instructions.

5. Do not use this apparatus near water.

6. Clean only with a dry cloth.

7. Do not block any of the ventilation openings. Install in accordance
with the Manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that
produce heat.

9. Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades with one
wider than the other. A grounding type plug has two blades and a
third grounding prong. The wide blade or the third prong are
provided for your safety. When the provided plug does not fit into
your outlet, consult an electrician for replacement of the obsolete
outlet.

10. Protect the power cord from being walked on or pinched

particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Use only with a cart, stand, tripod, bracket, or
table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination
to avoid injury from tip-over.

13. Unplug this apparatus during lightning storms or
when unused for long periods of time.

14. Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has
been dropped.

15. WARNING: To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture. Do not place objects
filled with water, such as a vase, on the apparatus.

16. The AC mains plug is used as the power disconnect device and it
should remain readily accessible and operable during intended use.
In order to completely disconnect the apparatus from power, the
mains plug should be completely removed from the AC outlet
socket.

17. CAUTION: To reduce the risk of fire or explosion, do not expose
batteries to excessive heat such as sunshine, fire or other heat
sources.

DRIPPING WARNING: This product shall not be exposed to
dripping or splashing, and no objects filled with liquids, such as
vases, shall be placed on the product.

VENTILATION WARNING: The normal ventilation of the product
shall not be impeded for intended use.

Warnings:

Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority
to operate the equipment.

Class II equipment symbol.
This symbol indicates that the unit has a double
insulation system.

Specifications

AUDIO SECTION

Output Power .................................................................................................................. 1 Watts (RMS)

Output Impedance........................................................................................................................ 4 Ohms

BLUETOOTH

Bluetooth Version.................................................................................................................................V4.1

Working Distance............................................................ Up to 10 meters measured in open space

LINE IN SECTION ..............................................................................3.5 mm Stereo line in jack

MICROPHONE SECTION ................................................................ 3.5mm Condensor Microphone

POWER SECTION

Battery .................................................. DC4.5V (”AA” cell 1.5V x 3pcs) (batteries not included)

Power Adaptor................................................................................ Input AC 100-240V ~ 50/60Hz

......................................................................... Output DC 5V 0.6A (Positive Center)

DIMENSION .................................................... 10.4 X 6.7 X 3.3 inches/ 26.4 X 17.0 X 8.4 cm

WEIGHT ................................................................................................................... 1.5 lbs/0.66 kg

Specifications are subject to change without notice.
Please retain the instructions for further reference, as they contain important information.

Troubleshooting Guide

Should this unit exhibit a problem, check the following before seeking service:

No Power

• Power is not on; press the POWER button to turn power on.

• Confirm that the batteries are installed correctly.

No Sound – General

• Volume is set to minimum; raise volume by pressing VOLUME + button.

• If using an external audio device, raise the volume on the device.

• Check if the LINE IN jack is still connected by a cable.

No sound from the microphone

• Make sure the microphone is firmly connected to the Microphone jack.

• Make sure the Mic Guy microphone is not sitting on the platform.

• Volume is set to minimum; raise volume by pressing VOLUME + button

Bluetooth reception failure

• Put the external BT device close to the unit.

• Pair the unit with the BT Device as the procedures stated in this manual.

Power
button

Power

indicator

Play / Pair indicator

Please retain this sheet as it contain important notes.

POWER

ADAPTOR

(sold separately)

BATTERY PRECAUTIONS

The precautions below should be followed when using batteries in this device:

1. Warning – Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

2. Use only the size and type of batteries specified.

3. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. A
reversed battery may cause damage to the device.

4. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and Carbon-zinc) or old batteries
with fresh ones.

5. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.

6. Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (Follow the battery
manufacturer’s directions.)

7. Remove the batteries promptly once its charge is low.

8. Clean the battery contact and also those of the device prior to installing the battery.

ENERGY SAVING (AUTO POWER SYSTEM-APS)

The unit will automatically enter the Standby mode after 15
minutes in the following situations:

1. No button being pressed for 15 minutes.

2. No playback from your audio device for 15 minutes. The
playback of audio device had been stopped but the audio cable
is still plugged into the LINE IN jack.

3. Not singing to the microphone for 15 minutes. The Power
indicator will be turned off.

The unit can be resumed to turn on by pressing the Power button
once. APS is for energy saving purposes.

MIC 1

MIC 2

LINE IN

DC 5V IN

MICROPHONE

(sold separately)

LINE IN jack

Microphone jack

DC jack

Battery

compartment

cover

LINE IN CONNECTION

This unit is able to connect your favorite audio device (e.g.
iPhone/Tablet/MP3 player,etc.). You can connect your
device by using a provided cable (3.5mm audio cable).
LINE IN function is automatically selected once the audio
cable is plugged in.

Warning

- To avoid excessive over amplified sound output, it is
recommended that the volume control is initially adjusted
to one third or less and then increase if required.

BATTERY OPERATION

1. Remove the battery compartment cover on the bottom of the

back of the unit by using a Phillips-head screw driver.

2. Insert three (3) “AA” size alkaline batteries (not included) as

indicated on the right diagram.

3. Replace the cover tightly before operating.

CAUTION:

- Replace all batteries at the same time.

- Do not mix old batteries with new batteries.

POWER ADAPTOR OPERATION

If you would like to purchase an external AC power adapter to save
on battery consumption, please refer to the specification on right.
Insert the DC plug of the power adaptor into the DC jack on the unit.
Plug the other end into a standard AC outlet.

CAUTIONS:

- The AC Adaptor has a polarized plug that fits into the wall outlet only one way.
If the plug does not fit properly, turn it over and try again. Do not force it.

MICROPHONE CONNECTION

Connect the provided Mic Guy microphone into
the microphone jack. Please ensure that you lift the
microphone from the platfrom prior to using it.

Note:

- Do not drop or tap the microphone as damage to
the microphone or speaker may occur.

- Do not twirl the microphone cord as it will cause
damage to the encased wiring.

Making the Connections

Operation

RECORD

PLAY/PAIR

VOLUME

123

+

-

123

SONG EFFECT

u

v

SING-ALONG WITH BUILT-IN SONGS AND EFFECTS

3

There

are 3 built-in songs and 3
sound effects in this sing-along
unit. You can press them one by
one to try.
Press Song 1, Song 2 or Song 3
button to play three different
songs. Press the button again to
stop. Press Effect 1, Effect 2 or
Effect 3 button to play three
different sound effects.

w

RECORD

PLAY/PAIR

VOLUME

1

2

3

+

-

1

2

3

SONG EFFECT

MIC 1

MIC 2

LINE IN

DC 5V IN

x

y

y

RECORD

PLAY/PAIR

VOLUME

+

-

SING-ALONG WITH LINE IN MUSIC

4

Connect the audio device to the LINE IN jack
on the back of this unit. It will allow the audio
to be played through your unit. LINE IN
function is automatically selected once the
audio cable is plugged in.

Note:

• It is highly recommended to set the volume on
the auxiliary unit to 1/3 or lower to avoid
distortion.

SING-ALONG WITH MIC GUY

5

Connect the Mic Guy microphone into the
microphone jack at the back of the unit. Once
you lift the Mic Guy microphone you can see
the Microphone switch is located on the unit.
When the Mic Guy microphone is not sitting
on the platform, the microphone switch is
ON. When the Mic Guy is sitting back on the
platform, the microphone switch is OFF.
You can also connect an extra microphone
(not included) to another mic jack. The extra
microphone should have ON/OFF switch by
itself. Please also turn it ON before singing.

Note:

Please always lift the Mic Guy microphone when
you want to sing with the extra microphone

6

Adjust the volumn to a comfortable level by
pressing the button VOLUME + and
VOLUME - button.

RECORDING YOUR SINGING:

7

To record your singing as well as the music,
press the RECORD button; recording will
begin and the Record/Playback indicator will
blink. When you want to finish the recording,
press the RECORD button again. The
Record/Playback indicator will stop blinking

Note:

• There is 3 minutes and 40 seconds recording time.

• Please note that each time when the new
recording is being recorded, the existing recording
will be deleted.

Microphone

(Mic Guy)

y

V

W

PLAYBACK YOUR VOICE RECORDING:

8

To playback your voice recording,

you can press the PLAY/PAIR
button.
The Record/Playback indicator will
light on. Press the PLAY/PAIR
button again to stop.

1

Connect the unit as described previously. Press the POWER button to turn the unit on;

the power indicator will light on.

USING A BLUETOOTH DEVICE

2

The Bluetooth pair indicator will
blink rapidly to indicate it is in the
pairing mode.

Note:
You can also press and hold the
PLAY/PAIR button to initiate the
pairing mode.

Switch on the Bluetooth function of
your Bluetooth compatible device
within three feet of the unit. You will
see “Mic Guy” appear on your device’s
search list.
Note:
Please always refer to the user manual of your bluetooth device for detailed instructions.

Select “Mic Guy” to start pairing. Wait for completion of the pairing and the Bluetooth
indicator will light solid.

Note:

If your Bluetooth device prompts you for a passcode during the pairing process, please
enter “0000” to connect. If pairing fails, repeat steps 2-4. If you have paired before, a list
of previously searched results will be displayed. Select “Mic Guy” again. On some
Bluetooth devices (i.e.,computers), once pairing is complete, you must select your
Bluetooth device as “Use as Audio Device” or similar.

PLAY/PAUSE: Press the Play/Pause button on the Bluetooth device or on the unit to start.

AC power adaptor specification

I

nput : AC 100-240V ~ 50-60Hz

Output DC 5V 0.6A .

U

YOUR

AUDIO DEVICE

(sold separately)