CHAuFFE-PIsCINE COMMERCIAL POOl HEAT PumP
Owner’s Manual
PRINTED IN CANADA
Table of contents
Introduction |
3 |
General Safety Instructions |
5 |
Thermeau Models’ Specifications |
7 |
Installation Instructions |
|
Location |
8 |
Water piping |
9 |
Electrical |
10 |
Bonding |
11 |
Bonding and plumbing step-by-step instructions |
11 |
Electrical Connections |
12 |
Electrical Diagrams |
13 |
Service Analyzer Control |
14 |
Electronic Temp. Controls |
14 |
Initial Startup |
17 |
Meaning of Display Codes |
18 |
Troubleshooting |
19 |
Requesting Assistance or Service |
21 |
Maintenance |
22 |
Winterizing |
22 |
Pool Heat Pump Warranty |
23 |
2 |
Owner’s manual |
|
CHAuFFE-PIsCINE COMMERCIAL POOl HEAT PumP
Thank you for buying
an THERMEAU pool heat pump.
The THERMEAU pool heat pump is a self-contained unit designed specifically for pool heating. Each component has been selected with care to achieve a high-quality product in an effort to exceed all industry standards.
All THERMEAU pool heat pumps have a Scroll compressor, an electronic board with service analyzer, a titanium heat exchanger tube warranted for 10 years against corrosion. All components are of superior quality, which presents you with an effective, state-of-the-art technology heat pump.
In general, compared to other types of pool heaters, such as gas or oilfired, the THERMEAU pool heat pump has a lower heating capacity on a BTU/hr basis. Therefore, it needs to operate for a longer time to accomplish the desired results. Occasionally, it may be necessary to run the heat pump for up to 24 hours per day. However, this should not be of concern to the owner because the heater is designed to operate continuously. What’s more, despite continuous operation, it will still heat the pool far more economically than other types of heaters.
Owner’s manual |
3 |
|
CHAuFFE-PIsCINE COMMERCIAL POOl HEAT PumP
Please read carefully
Whenever you call to request service for your heater, you must know your complete model and serial numbers. You can find this information on the name plate located on the right side of your heater.
Please also record the purchase date of your device and your dealer’s name, address, and telephone number.
Model Number_____________________________________________________
Serial Number______________________________________________________
Purchase Date_ ____________________________________________________
Dealer Name_______________________________________________________
Dealer Address_____________________________________________________
Dealer Phone_ _____________________________________________________
Keep this book and the sales slip together in a safe place for future reference.
Service can now be obtained by calling these phone numbers.
CANADA AND USA: 1 418 661-2222
4 |
Owner’s manual |
|
CHAuFFE-PIsCINE COMMERCIAL POOl HEAT PumP
General Safety Instructions
We care for our customers
We have provided important safety messages in this manual and on your heater. Always read and obey all safety messages.
IMPORTANT
?The IMPORTANT sign calls attention to a note that provides important information or information essential to the completion of a task.
CAUTION
The CAUTION sign denotes a hazard. It calls attention to an operating
!procedure, practice, or the like, which, if not correctly performed or adhered to, could result in material damage, particularly to the product, up to the destruction of part or all of the product.
WARNING
The WARNING sign denotes a hazard. It calls attention to a procedure, practice, or the like, which, if not correctly performed or adhered to, could result in personal injury or injury to a third party. These signs are rare, but are extremely important.
Owner’s manual |
5 |
|
CHAuFFE-PIsCINE COMMERCIAL POOl HEAT PumP
CAUTION
All electrical connections must be done by a qualified electrician and according to the local electrical codes. Always cut off the unit’s main
!power whenever the access panel is open or removed. Always install the machine outdoors (unless otherwise approved by the manufacturer), while respecting the minimal clearances needed for proper operation and heating.
CAUTION
!Proper pool chemistry is vital to the life of your heater. Pay particular attention to the total alkalinity and TDS. It is highly recommended that you have your pool chemistry checked often by an independent pool store.
Water quality standards that must be strictly observed
Description |
Normal Range |
Verification |
|
|
|
pH level |
7.2 to 7.8 |
Once/week |
|
|
|
Chlorine concentration |
1.0 to 3.0 ppm |
Once/2-3 days |
|
|
|
Total alkalinity |
80 to 100 ppm |
Once/2-3 weeks |
|
|
|
Total dissolved solids (TDS) |
Below 1600 ppm (fresh water) |
Once/month |
|
|
|
|
Below 3000 ppm (salt water) |
Once/month |
|
|
|
Calcium hardness |
200 to 300 ppm |
Once/month |
|
|
|
6 |
Owner’s manual |
|
CHAuFFE-PIsCINE COMMERCIAL POOl HEAT PumP
A robust and reliable product line
ModEl |
TH-150 |
TH-150-3 |
TH-200 |
TH-200-3 |
TH-200-3A |
|
Btu 80 water / |
|
|
|
|
|
|
80 air / |
142,000 – 6 |
150,000 – 6.2 |
185,000 – 5.6 |
200,000 – 6.1 |
200,000 – 6.1 |
|
80 % humidity* |
|
|
|
|
|
|
Btu 80 water / |
|
|
|
|
|
|
80 air / |
132,000 – 5.9 |
142,000 – 6 |
175,000 – 5.5 |
185,000 – 5.9 |
185,000 – 5.9 |
|
63 % humidity** - COP |
|
|
|
|
|
|
Btu 80 water / |
|
|
|
|
|
|
50 air / |
90,000 – 4 |
95,000 – 4.1 |
116,000 – 4 |
128,000 – 4.3 |
128,000 – 4.3 |
|
63 % humidity** - COP |
|
|
|
|
|
|
Compressor ( HP ) |
7 |
7.5 |
2x5 |
10 |
10 |
|
Compressor type |
Scroll |
Scroll |
Scroll |
Scroll |
Scroll |
|
Heat exchanger |
Titanium / PVC |
Titanium / PVC |
Titanium / PVC |
Titanium / PVC |
Titanium / PVC |
|
Heating range |
Up to |
Up to |
Up to |
Up to |
Up to |
|
(°F / °C) |
104°F / 40°C |
104°F / 40°C |
104°F / 40°C |
104°F / 40°C |
104°F / 40°C |
|
Voltage Hz/Ph |
208-240 60/1 |
208-240 60/3 |
208-240 60/1 |
208-240 60/3 |
575-600 60/3 |
|
Required breaker |
60 |
40 |
60 |
60 |
30 |
|
Minimum circuit ampacity |
42.5 |
36.9 |
47 |
44 |
16.8 |
|
(MCA) |
||||||
|
|
|
|
|
||
Plumbing connections |
2’’ |
2’’ |
2’’ |
2’’ |
2’’ |
|
Water Flow (GPM) |
60 to 125 |
60 to 125 |
60 to 125 |
60 to 125 |
60 to 125 |
|
|
H: 40 |
H: 40 |
H: 48 |
H: 48 |
H: 48 |
|
Dimensions in inches |
W: 33 |
W: 33 |
W: 33 |
W: 33 |
W: 33 |
|
|
D: 39 |
D: 39 |
D: 39 |
D: 39 |
D: 39 |
|
Hot Gas Defrost |
Yes |
Yes |
Yes |
Yes |
Yes |
|
Weight (lb) |
304 |
305 |
445 |
375 |
375 |
|
|
|
|
|
|
|
* Tests performed without taking into account the AHRI 1160 standard. ** Tests performed with the AHRI 1160 standard.
Owner’s manual |
7 |
|
CHAuFFE-PIsCINE COMMERCIAL POOl HEAT PumP
Installation Instructions
Location
The placement of the pool heater is very important in keeping installation costs to a minimum while providing for maximum efficiency of operation, as well as allowing adequate access for service and maintenance.
The THERMEAU pool heat pump is designed for outdoor installation and should not be installed in a fully enclosed area, such as a shed, garage, etc., unless ventilation is provided to ensure adequate air exchange for proper operation. Recirculation of cold discharged air back into the evaporator coil will greatly reduce unit heating capacity and efficiency.
The unit should be located as close as practical to the existing pool pump and filter to minimize water piping. However, do not forget to provide a 18” clearance at the very least all around your heat pump.
Mount the unit on a sturdy base, preferably a concrete slab or a set of blocks. The size of the base should not be less than 40” x 40” (100 cm x 100 cm).
? IMPORTANT
All THERMEAU pool heat pump models feature patented, ultrasilent ventilation systems. Air is pulled through the evaporator coil and discharged through the top grille. A minimum clearance of 48 inches should be allowed above the unit for unrestricted air discharge. The unit must not be installed under a porch. Any side of the unit should be located at least 24 inches from a wall or from any other obstruction for unrestricted air intake and service access.
Fig. 1
8 |
Owner’s manual |
|
CHAuFFE-PIsCINE COMMERCIAL POOl HEAT PumP
Loading...