Thermador EXTNCB25W User Manual
THERMADOR.COM
For 25 ft. Remote & In-line Blower Extension Cable
Installation
INSTRUCTIONS
THERMADOR.COM
For 25 ft. Remote & In-line Blower Extension Cable
Installation
INSTRUCTIONS
Table of Contents (English)................................................................2
Table de Matières (Français)..............................................................7
Índice de Materias (Español)............................................................12
Models |
Modèles |
Modelos:
EXTNCB25W
Page. 2
This THERMADOR® appliance is made by
BSH Home Appliances Corporation
1901 Main Street, Suite 600
Irvine, CA 92614
Questions?
1-800-735-4328
www.thermador.com
We look forward to hearing from you!
Table of
CONTENTS
Safety ...................................................................................... 3
Important Safety Instructions ..........................................3
Installation Instructions ........................................................... 5
Before You Begin............................................................. 5
25 ft Extension Cable Connection................................... 5
Support, Accessories & Parts................................... back page
Safety
DEFINITIONS
WARNING
This indicates that death or serious injuries may occur as a
result of non-observance of this warning.
CAUTION
This indicates that minor or moderate injuries may occur as a
result of non-observance of this warning.
NOTICE: This indicates that damage to the appliance or
property may occur as a result of non-compliance with this
advisory.
Note: This alerts you to important information and/or tips.
Page. 3
Safety
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
INSTALLER: Please leave these Instructions with this unit
for the owner. Show the owner the location of the circuit
breaker. Mark it for easy reference.
OWNER: Please retain these instructions for future
reference.
WARNING
If the information in this manual is not followed
exactly, fire or shock may result causing property
damage or personal injury.
WARNING
Turn off power circuit at service panel and lock out
panel before wiring this appliance. Allow the
appliance to cool after the power has been turned off
before servicing the appliance.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
• Use this unit only in the manner intended by the
manufacturer.
• Before servicing or cleaning unit, switch power off
at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag,
to the service panel.
WARNING
ELECTRICAL SHOCK HAZARD
• DO NOT remove connections.
• DO NOT use an extension cord.
• Improper grounding can result in a risk of
electric shock.
• Failure to follow these instructions can result
in death, fire, or electrical shock.
State of California Proposition 65 Warning:
WARNING
This product can expose you to chemicals including
vinyl chloride, which is known to the State of California
to cause cancer and birth defects or other
reproductive harm. For more information go to
www.P65Warnings.ca.gov.
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current.
Be sure your appliance is properly installed and grounded
by a qualified technician.
If required by the National Electrical Code (or Canadian
Electrical Code), this appliance must be installed on a
separate branch circuit.
To reduce the risk of fire or electric shock, do not use this
appliance with any solid-state speed control devices.
Installation, wire harness routing, electrical connections
and grounding must comply with all applicable codes. It is
the responsibility of the owner and the installer to
determine if additional requirements and/or local or other
codes apply to specific installations.
The use of multiple blower connection cables is NOT
supported.
Never modify or alter the construction of the appliance,
harness or connectors. Ensure all panels and other
components removed during installation are replaced. See
blower and hood installation manuals for complete
instructions.
CAUTION
For general ventilating use only. DO NOT use to
exhaust hazardous or explosive materials and vapors.
To reduce the risk of fire, use only metal ductwork.
Page. 4
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
• Installation work and electrical wiring must be
done by qualified person(s) in accordance with all
applicable codes and standards, including firerated construction.
• Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of
fuel burning equipment to prevent back drafting.
Follow the heating equipment manufacturer's
guideline and safety standards such as those
published by the National Fire Protection
Association (NFPA), and the American Society for
Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code
authorities.
• USE ONLY METAL DUCTWORK.
• Ducted fans must always be vented to the
outdoors. Do not vent exhaust air into spaces
within walls, ceilings, attics, crawl spaces or
garages.
• When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden
utilities.
Page. 5
Installation Instructions
Before You Begin
Parts Included
• 25ft Extension Cable
• Adapter Cable No. 1
• Adapter Cable No. 2
IMPORTANT: Cutting off a connector to the appliance or
to the extension cable kit will void the warranty.
Compatible Blowers
The blower extension cable is compatible with the
following In-line & Remote blowers:
25 ft Extension Cable
Connection
25 ft Extension Cable
IMPORTANT: Cutting off a connector to the appliance or
to the extension cable kit will void the warranty.
The 25 ft extension cable can be used on the following
ventilation models ONLY:
1. The Hood’s internal blower harness should be routed
through the knockout and secured with a ¾” (19 mm)
strain relief. The 25 ft Extension Cable can then be
connected to the blower harness outside the unit.
Blower Model
Remote Blower 1000 CFM VTR1030W
Remote Blower 1000 CFM VTN1090W
Remote Blower 1300 CFM VTR1330W
Remote Blower 600 CFM DHG6023UC
In-line Blower 600 CFM DHG6015DUC
In-line Blower 600 CFM VTI610W
In-line Blower 1000 CFM VTI1010W
Description Model
Thermador Pro Chimney Wall Hood HPCNxxWS
Thermador Pro Harmony Wall Hood PHxxHWS
Thermador Pro Grand Wall Hood PHxxGWS
Thermador Pro Custom Insert VCINxxGWS
Thermador Pro Island Hood HPINxxWS
(1) Connects to Hood
(2) Connects to Remote or In-line Blower
1
2
Loading...