Thermador DC3689W, DC3089W Installation manual
THERMADOR.COM
Installation
INSTRUCTIONS
For Pro Hood Duct Cover Extensions and Telescoping Extensions
Installation
INSTRUCTIONS
For Pro Hood Duct Cover Extensions and Telescoping Extensions
Table of contents (English) ................................................................3
Table de matières (Français) ..............................................................9
Índice de materias (Español)............................................................15
Models |
Modèles |
Modelos:
CHMHP366W
CHMHP36TW
CHMHP36XTW
CHMHP486W
CHMHP48TW
CHMHP48XTW
DC3089W
DC3689W
DC4289W
DC4889W
DC361012W
DC481012W
THERMADOR.COM
Table of
Safety
CONTENTS
Installation instructions ........................................................... 4
Before you begin............................................................. 4
Pro Chimney hood 6'' duct cover extension................... 4
Pro Chimney hood telescoping duct cover extension .... 5
Pro Wall hood telescoping duct cover extension ........... 7
Support, accessories, and parts............................... back page
DEFINITIONS
9 WARNING
This indicates that death or serious injuries may occur as a
result of non-observance of this warning.
9 CAUTION
This indicates that minor or moderate injuries may occur as a
result of non-observance of this warning.
NOTICE: This indicates that damage to the appliance or
property may occur as a result of non-compliance with this
advisory.
Note: This alerts you to important information and/or tips.
This THERMADOR® appliance is made by
BSH Home Appliances Corporation
1901 Main Street, Suite 600
Irvine, CA 92614
Questions?
1-800-735-4328
www.thermador.com
We look forward to hearing from you!
Page. 3
Installation instructions
Before you begin
Before you begin read these instructions carefully.
9 CAUTION
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being
turned ON accidentally.
Proposition 65 Warning
This product may contain a chemical known to the State of
California, which can cause cancer or reproductive harm.
Therefore, the packaging of your product may bear the
following label as required by California:
STATE OF CALIFORNIA PROPOSITION 65 WARNING:
: WARNING
Cancer and Reproductive Harm -
www.P65Warnings.ca.gov
IMPORTANT: Secure the hood to the wall before installing
the duct cover extension. Follow the hood’s installation
instructions before securing the extension.
Removing the protective film
1. Carefully remove the protective film from the duct
cover and hood assembly prior to the start of the
installation.
Pro Chimney hood 6'' duct
cover extension
Compatible hood models
Duct cover extensions fill the space between the hood
and ceiling of 8 ft. (2.4 m) and 9 ft. (2.7 m) ceilings.
Model 6'' extension
HPCN36WS CHMHP366W
HPCN48WS CHMHP486W
Securing the Pro Chimney hood 6'' duct cover
extension
1. Installation of the hood should maintain a minimum
height of 30'' (762 mm) from the bottom of the hood
to the cooking surface. To determine placement of the
hood with a duct cover extension, the height of the
extension must be calculated (see the hood’s
installation instructions).
2. From inside of hood, screw the supplied 5/8'' (16 mm)
sheet metal screws through the holes on each side
and along the front into bottom of the duct cover
extension, as shown in below. Screw quantity is
dependent on hood size.
The duct cover extension is supported by the hood.
2. Use one hand to maintain the duct cover steady while
the other hand removes the protective film.
Page. 4
Pro Chimney hood telescoping
14"
(356)
14"
(356)
14"
(356)
18"
(457)
18"
(457)
18"
(457)
1¼" (32)1¼" (32)1¼" (32)
18"
(457)
18"
(457)
17"
(432)
17"
(432)
18" – 35"
( 457 – 889)
18" – 35"
( 457 – 889)
18" – 35"
( 457 – 889)
30-¾" or 35-7/8"
(527 or 835)
30-¾" or 35-7/8"
(527 or 835)
30-¾" or 35-7/8"
(527 or 835)
inches (mm)
1¼" (32)1¼" (32)1¼" (32)
inches (mm)
duct cover extension
Compatible hood models
Telescoping extensions accommodate 10 ft. (3 m) ceilings.
Model Telescoping extension
HPCN36WS CHMHP36TW
HPCN36WS CHMHP36XTW
HPCN48WS CHMHP48TW
HPCN48WS CHMHP48XTW
Securing the Pro Chimney hood telescoping extension
1. To prevent scratches, lay paper over the edges of the
lower flue duct to protect the surface.
2. Ensure that the minimum height of 30'' (762 mm) from
the bottom of the hood to the cooking surface will be
maintained (see the hood’s installation instructions).
3. Locate two studs at the mounting location. At the wall
stud locations, measure 1¼'' (32 mm) down from the
ceiling to the middle of the bracket.
4. Mount the bracket at the wall stud locations using (2)
½'' (13 mm) screws (provided). Ensure that the bracket
is level.
Page. 5
5. Insert the complete duct cover at an angle and swivel
toward the wall.
7. From inside of hood, screw the supplied 5/8'' (16 mm)
sheet metal screws through the holes on each side
and along the front into bottom of the extension.
Screw quantity is dependent on hood size.
6. Carefully pull the top part of the extension upwards.
Screw the left and right sides of the extension to the
mounting bracket with the supplied stainless screws.
Page. 6
Pro Wall hood telescoping
18"
(457)
18"
(457)
18"
(457)
BB
AA
CC
1¼" (32)1¼" (32)1¼" (32)
12"
(305)
12"
(305)
30", 36", 42", or 48"
(762, 914, 1067, or 1219)
30", 36", 42", or 48"
(762, 914, 1067, or 1219)
30", 36", 42", or 48"
(762, 914, 1067, or 1219)
inches (mm)
duct cover extension
Compatible hood models
Pro Wall hood telescoping extensions accommodate up to
12 ft. (3.6 m) ceilings.
2. Ensure that the minimum height of 30'' (762 mm) from
the bottom of the hood to the cooking surface will be
maintained (see the hood’s installation instructions).
Model
8 - 9 ft.
telescoping ext.
10 - 12 ft.
telescoping ext.
PH30HWS DC3089W —
PH36HWS
DC3689W DC361012W
PH36GWS
PH42GWS DC4289W —
PH48HWS
DC4889W DC481012W
PH48GWS
Securing the Pro Wall hood telescoping extension
1. To prevent scratches, lay paper over the edges of the
lower flue duct to protect the surface.
8 - 9 ft. installation height
Model Extension A B C
PH30HWS DC3089W
PH36HWS
PH36GWS
PH42GWS DC4289W
PH48HWS
DC3689W
DC4889W
14''
(356)
11''
(279)
PH48GWS
10 - 12 ft. installation height
8’ – 9’1''
(244 –
277 cm)
Model Extension A B C
PH36HWS
PH36GWS
PH48HWS
PH48GWS
DC361012W
DC481012W
32''
(813)
30''
(762)
9’6 –
12’2''
(290 –
371 cm)
Page. 7
Loading...