Thermador CET366YB Product Spec Sheet

Page 1
CET366YB
36-INCH ELECTRIC COOKTOP
MASTERPIECE® SERIES
- CookSmart® — with 4 preset frying levels, a sensor controls the temperature of the pan taking the guesswork out of temperature selection
- Dual zone bridge element accommodates oblong cookware and multiple diameter sizes
- Triple zone center element allows you to match element size to various sized cookware
- Illuminated touch control panel offers intuitively simple selection of power levels and allows for easy cleaning
- Full stainless steel frame surrounds the cooktop surface
ACCESSORIES (OPTIONAL)
CHEFSPAN08 10" Stainless Steel Pan
GENERAL PROPERTIES
Controls Touch Controls
ELEMENT PERFORMANCE
Power of Front Left Heating Element 1,700 W
Power of Front Left Heating Element (In Boost) 3,000 W
Power of Back Left Heating Element 1,700 / 700 W
Power of Bridge Element 4,000 W
Power of Center Heating Element 3,080 / 2,200 / 1,050 W
Power of Back Right Heating Element 1,200 W
Power of Front Right Heating Element 2,100 / 1,200 W
ELEMENT SIZE
Dimension of Front Left Heating Element 7"
Dimension of Back Left Heating Element 7", 5"
Dimension of Center Heating Element 11", 8", 6"
Dimension of Back Right Heating Element 6"
Dimension of Front Right Heating Element 8", 6"
TECHNICAL DETAILS
Watts (W) 10,520 W
Circuit Breaker (A) 50 / 40 A
Volts (V) 240 / 208 V
Frequency (Hz) 60 Hz
Plug Type No Plug
Conduit 38" Flexible 3-Wire
Energy Source Electric
DIMENSIONS & WEIGHT
77
Overall Appliance Dimensions (HxWxD) (in)
Required Cutout Size (HxWxD) (in) 3
Minimum Distance From Counter Front (in) 2 11/44"
Minimum Distance From Rear Wall (in) 2 33/44"
Net Weight (lbs) 34 lbs
WARRANTY
Limited Warranty, Entire Appliance, Parts and Labor
1515
/
"+3
1515
/
" x 34 33/44" x
1616
/
1616
37" x 21 11/44"
19 77/88"
2 Year
" x
1616
THERMADOR® EXCLUSIVE
Page 1 of 3
3 / 22
Page 2
C:
D:
B:
A:
This distance can be smaller, check
installation instructions of ventilation hood
Min. distance from the cooktop cut-out to
the side wall
Min. distance between the surface of the
cooktop and the underside of the
ventilation hood
Max. recessed depth
Min. distance from the cooktop cut-out to
the wall
Measurements in inches (mm)
37
(940)
2 (51)
(A)
3 (76)
(D)
3 (76)
(D)
211/4(540)
21/4(57)
343/4-347/8(883-886)
197/8-20
(505-508)
30
(762)
(C)
4 (100)
(B)
CET366YB
36-INCH ELECTRIC COOKTOP
MASTERPIECE® SERIES
36-INCH ELECTRIC COOKTOP AND CUTOUT DIMENSIONS
Page 2 of 3
3 / 22
Page 3
CET366YB
Create the cut-out in the countertop according to the installation diagram. The angle of the cut surface to the countertop must be 90°.
The lateral cut-out edges must be flat in order to ensure that the retaining springs are positioned properly on the appliance. With multi-layered countertops, secure strips laterally in the cut-out if necessary.
After creating cut-out, remove shavings. Seal cut surfaces in a heat- and water-resistant manner.
Observe minimum distance between device underside and cabinet surfaces of
3
/8" (10 mm).
Cutout dimensions for 36" cooktops
Models: CEM366TB, CET366TB
(B)
36-INCH ELECTRIC COOKTOP
MASTERPIECE® SERIES
INSTALLATION ABOVE A THERMADOR WALL OVEN
Product Type
Conventional Oven 28 1/4 (718) 31 1/4 (794) min. 4 3/4 (121)
Steam Oven 25 1/16 (636) 28 1/16 (713) 7 15/16 (202)
Steam Oven with 4” Storage Drawer* 28 1/4 (718) 31 1/4 (794) min. 4 3/4 (121)
Microwave / Speed Oven 19 1/4 (488) 24 (609) min. 12” (306)
Microwave / Speed Oven with Warming drawer* 28 1/4 (718) 31 1/4 (794) min. 4 3/4 (121)
When installing an oven or oven with a drawer in combination with a cooktop, a minimum distance between the cabinet floor and countertop is required. Reference the table for dimensions. Refer to the oven installation guide for all other measurements.
COUNTERTOP REQUIREMENTS
A
Inches (mm)
B
min. Inches (mm)
C
max. Inches (mm)
These warr antie s give yo u spec ific legal rights and you may h ave other rights tha t vary from state to s tate. Limited warranty f rom date of purc hase. For comp lete wa rran ty details, refer to your Use & Care manua l, or ask your dealer.
Specifications are for plannin g purp oses only. Refer to inst allation ins truc tions and co nsult your counter top su pplier prior to making counter ope ning. C onsult with a heatin g and ven tilation engineer for your specific ventilation requirements. For the mos t detailed in forma tion, refer to in stallation instructions accompanying product or w rite to Thermador indicating the model number. Speci fications a re correct a t time of p rinting. Thermad or reserve s the right to ch ange produc t spe cificatio ns or de sign withou t notic e. Some models are cer tified for use in Canada. Thermador i s not res pons ible for produ cts that are transpor ted from the U.S. for use i n Canada.
1 800 735 4328 | USA THERMADOR.CO M | CANA DA THERMADOR.C A | ©2022 BSH HOME APPLIANCES CORPORATION. ALL RIGHTS RESERVED.
Page 3 of 3
3 / 22
Loading...