Instant Calmer Healing Pad Instructions
Easy Start-Up
Place the Pad on a flat surface with jade side facing up
Plug the controller into the pad with arrows facing up
Plug the electrical plug into the electrical socket (standard 110v)
You will see a “5” on the controller – this is the temperature default setting (medium heat)
The up and down arrows allow you to adjust the heat setting from “1” to “9”
Hit the Green Mode Button
You will see a “60” reading on the controller – this is the default time setting
The up down arrows allow you to adjust the time from 15 minutes to 90 minutes
Press Orange ON/OFF button to turn on the heat once you have adjusted settings to your comfort
Green light indicates the Pad is on
The time will appear once the heat is activated and the timer will countdown until the end of the cycle
When the cycle is complete, the last temperature setting will be displayed
To reset for the same cycle (same heat and same timing), hit the Orange ON/OFF button
To change settings, follow directions above
While the heat is activated, the temperature can be changed during the session by using the up and down arrows
The time CANNOT be adjusted in the middle of a cycle (while the heat is activated)
During the session, you may notice the green light above the ON/OFF button will begin to blink. This is just an indication that the pad has reached the desired temperature.
If a “00” appears at any time, UNPLUG the controller from the wall, and UNPLUG the connection from the pad. Then re-plug into the pad (making sure the connection is secure) and then plug back into the wall.
Therasage, L.L.C. |
21000 Boca Rio Road, Suite A-21C |
Boca Raton, Florida |
|
www.Therasage.com |
|
Loading...