Thales TTT Short Manual

Short Manual Installation TTT

1. General notes TTT

2. Unpacking

3. Release transport lock

4. Install the platter

5. Set the level

6. Install the tonearm

1. General notes TTT

- Please use a local cable to connect the drive unit to the electricity network.

- The speed has been pre-adjusted using professional measurement equipment with a reference frequency. If you want to re-adjust the speed, please

only use the custom-made screwdriver delivered with the TTT.

- The clamp uses a spring loaded mechanism to make sure the record is not pressed on the platter with high forces. This means, you can tighten the

clamp to the arresting point for best result.

2. Unpacking

The package consits of three layers. Please take out all items of one layer before taking out the layer completely. Please always use the original packaging for
any transport of the TTT.

Layer 1

Layer 2

Layer 3

-Clamp

-Drive-Unit

-Accessories

-Platter

-Chassis