T-FAL BALANCED LIVING JUICE EXTRACTOR User Manual

User Guide

Guide de l'utilisateur

www.t-fal.com

E G

L M

J N

fig. 1 fig. 2

fig. 3 fig. 4

fig. 5 fig. 6

fig. 7 fig. 8

fig. 9

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should be followed including the following:

1 Read all instructions.

2. To protect against risk of electrical shock do not put unit in water or other liquid.

3. Close supervision is necessary when unit is used by or near children.

4. Unplug from outlet when not in use, before putting on or taking off parts and before cleaning.

5. Avoid contacting moving parts.

6. Never feed food by hand. Always use food pusher.

7. Do not operate appliance with a damaged cord or plug or after the appliance malfunctions, or is dropped or damaged in any manner. Return appliance to the nearest authorized service facility for examination, repair or electrical or mechanical adjustment.

8. Always make sure juicer cover is clamped securely in place before motor is turned on. Do not unfasten clamps while juicer is in operation.

9. The use of attachments not recommended or sold by the manufacturer may cause fire, electric shock or injury.

10. Do not operate without the pulp container in place.

11. Make sure the motor stops completely and the power supply plug is removed from outlet before disassembling.

12. Do not put your fingers or other objects into the juicer opening

while it is in operation. If food becomes lodged in opening, use food pusher or another piece of fruit or vegetable to push it down. When this method is not possible turn the motor off, unplug it and disassemble juicer to remove remaining food.

13. Ensure unit is completely assembled before use. Do not operate the unit without Grater/Filter Basket, Pulp Container, and Juice Container.

14. Do not use outdoors. This appliance is for household use only. Do not use this appliance for anything other than its intended use.

15. Do not let cord hang over edge of table or counter or bench or touch hot surfaces, including the stove.

16. Switch off the appliance before changing accessories or approaching parts which move in use.

17. Do not use the appliance if the rotating sieve is damaged.

18. Do not leave the juice extractor unattended when in use.

19. Always ensure the juice extractor is turned off by by turning the “0” switch on the control panel. Then switch the appliance off at the power outlet and unplug the cord. Make sure the stainless steel filter basket has stopped before releasing the safety locking arm and/or attempting to move the appliance, when the juice extractor is not in use, and before disassembling, cleaning and storing.

20. Do not operate the appliance continuously with heavy loads for more than 10 seconds. Allow the motor to rest for 5 minutes between each use.

21. Be careful when handling the stainless steel filter basket. The small cutting blades are very sharp. Handle very carefully. Mishandling may cause injury.

22. Fully unwind the cord before use.

SAVE THESE INSTRUCTIONS

Polarization Plug

This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electrical shock, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not modify the plug in any way.

Description

A Pusher B Feed tube C Cover D Sieve E Juice collector F Pouring spout with flow-stop system G Pulp collector H Safety clamp

I Control switch (2 speeds) J Drive shaft K Motor unit L Juice jug cover M Foam separator N Juice jug O Brush P Cord storage

Safety system

• This appliance is fitted with a safety mechanism. To start

the juice machine, the cover (C) must be properly secured by the safety clamp (H). Opening the safety clamp (H) will stop the juice machine. At the end of a cycle, place the control switch (I) to 0 and wait until the sieve (D) stops completely before removing the cover.

Before first use

• We recommend that you wash all the removable parts

(A, B,C, D, E, G, L, M, N) in warm soapy water (see paragraph ”Cleaning”). Rinse and dry them carefully.

• Unpack the appliance and place it on a solid, stable work

surface.

• Ensure that all packaging has been removed before starting

the appliance.

Using the appliance

• Fit the juice collector (E) in the appliance, tipping it slightly

forward to pass the pouring spout through the hole provided (see Fig. 1).

• Place the sieve (D) in the juice collector (E). Ensure that the

sieve is properly clipped onto the drive shaft (J). You can hear an audible click when the sieve is positioned correctly (see

Fig. 2).

• Fit the cover (C) on the appliance, ejection spout to the rear

(see Fig. 3).

• Push the safety clamp (H)to the rear until it locks into place.

You will hear an audible “click” (see Fig. 4).

• Fit the pulp collector (G) on the rear of the appliance (see

Fig. 5).

• Slide the pusher (A) into the feed tube (B) aligning the

groove on the pusher with the small ridge in the feed tube.

• If you wish to separate the juice from the froth, slide the

foam separator (M) in the juice jug (N)and fit the cover onto the jug (see Fig. 6). The foam separator allows you to keep the froth inside the jug when you pour the juice into a glass.

• This appliance is fitted with a flow-stop system (F): push the

pouring spout down to initiate the system and allow the juice to flow out (see Fig. 7)

• Place the juice jug (N) under the pouring spout in front of

the appliance (see Fig. 8).

• Plug in the appliance.

• To start the appliance, use the control switch (I).

• Insert the fruits or vegetables through the feed tube (B).

• The fruits and vegetables must be inserted only while the

motor is running.

• Do not press too hard on the pusher (A). Do not use any

other utensil. NEVER push with your fingers.

• When you have finished, stop the appliance by turning the

control switch (I) to 0 and wait until the sieve (D) stops completely.

• When the pulp collector (G) is full, or the juice flow slows

down, empty the pulp collector and clean the sieve and the cover.

• After making your juice, activate the flow-stop system by

pushing the pouring spout up before removing your glass to stop the flow of the juice (see Fig. 9).

+ 18 hidden pages