Texas Instruments ETR103 User Manual

Installation Guide for Transition Reader (RX-STU-ETR1)

I. Transition Reader as Shipped from Factory

The Transition Reader as shipped from our factory is compliant
with FCC Part 15 Rules. (Fig. 1)

This device complies with Part 1 5 of the FCC Rules. Operation is
subject to the following t wo conditions:

(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including

interference that may cause undesired operation.

FCC ID: A92ETR103

Antenna (Top Stand)

Reader (Bottom Base)

Figure 1: Original T.I. Transition Reader Configuration

II. Separated Antenna (Top Stand) and Re ader (Bottom Base)

If the Transition Reader is separated into Reader (Bottom Base) and Antenna (Top Stand),
the following instructions must be performed in order to be FCC Part 15 compliant. (Fig. 2)

1) Separate Antenna (Top Stand) and Reader (Bottom Base) a minimum distance of 24
inches.

2) If the 48 inch antenna cable is to be coiled or bundled, the antenna cable coil must be
a minimum of 12 inches away from the Reader (Bottom Base).

Antenna (Top Stand)

expresspay

Antenna cable coil

Reader (Bottom Base)

12 inches

24 Inches

Figure 2: Separated Antenna (Top Stand) and Reader (Bottom Base)

Note: The minimum distances shown are required to maintain FCC p art 15 Rule

compliance when the Antenna (Top Stand) and Reader (Bottom Base) are separated.

15 January 2004