Page 1
SAFETY GUIDE – PLEASE READ CAREFULLY
BEFORE USING THIS APPLIANCE.
Please follow all the precautions listed below for safety and to
reduce the risk of injury or electric shock.
WARNING: READ ALL INSTRUCTIONS; FAILURE TO
FOLLOW ALL INSTRUCTIONS LISTED BELOW MAY
RESULT IN ELECTRIC SHOCK, OR SERIOUS PERSONAL
INJURY.
WARNING: DO NOT USE THIS APPLIANCE NEAR
BATHTUBS, SHOWERS, BASINS OR OTHER VESSELS
CONTAINING WATER
SAVE THESE INSTRUCTIONS
CLIPPER USE AND CARE
Only use the appliance as described in this User Guide. •
Do not immerse the appliance in water or any other liquid. •
Do not expose the appliance to excessive moisture, dust or dirt.•
Do not allow the appliance to be exposed to rain or moisture •
during use or storage.
Never pull the mains lead to unplug the appliance.•
Do not operate the appliance if the mains lead is damaged.•
Always check the blades for alignment before use.•
Do not use the appliance if the teeth are damaged.•
The appliance can become hot during use, only use for a •
maximum of 30 minutes then allow to cool for 30 minutes.
The appliance is only intended for clipping human hair. Do not •
use for any other purpose.
Always check the appliance for damage prior to use. If any •
damage is observed, do not use the appliance.
Always switch the appliance o after use. •
This appliance has no user serviceable parts. Do not attempt to •
access the appliance covers.
This appliance is for personal use only. It is not suitable for •
commercial use.
This appliance is not intended for use by persons (including •
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure that they do not play •
with the appliance.
Do not place the appliance on or near a heat-sensitive surface.•
Lubricating oil must be placed away from re sources and out of •
the reach of children.
Do not drink the lubricating oil or allow it to contact the eyes.•
If lubricating oil enters the eyes, lay the person down, gently •
ush the eyes with cold water from a container for 15 minutes,
then seek medical help.
PERSONAL SAFETY
Close supervision is necessary if the appliance is operated near •
children.
Never leave the appliance unattended while switched on, or still •
hot.
Only use the appliance as described in this User Guide.•
Do not use the appliance on damaged or broken skin.•
Do not use the appliance with wet hands.•
ELECTRICAL SAFETY
Switch o the appliance before connecting it to the mains •
supply.
Switch o and unplug the appliance after use.•
Do not allow the mains lead to touch hot objects.•
To protect against electric shock, never allow the appliance, •
the mains cable or plug to come into contact with water or any
other liquid.
Never reach for any appliance that has fallen into water. Switch •
o the power supply at the mains immediately and unplug. Do
not re-use until the product has been inspected and approved
by a qualied electrician.
Always ensure that hands are dry before operating or adjusting •
any switch on the product or touching the plug and mains
supply connections.
Never leave the appliance unattended when connected to the •
mains power supply.
Keep all ventilation slots, lters etc. uncovered and clear of •
debris. Never drop or insert objects into the openings.
Do not carry the appliance by the mains lead.•
Never pull the mains lead to unplug the appliance.•
Regularly check the mains lead for damage, particularly where it •
enters the product and the plug.
The mains lead for this appliance cannot be replaced. If the •
mains lead is damaged, the appliance should be discarded.
STORAGE
The appliance should never be stored whilst hot or whilst •
still connected to the mains. Always ensure the appliance is
switched o, unplugged from the mains and has cooled down
before storing.
Never wrap the mains lead around the appliance. Do not hang •
up the appliance by the mains lead, use the hanging loop
provided.
ELECTRICAL INFORMATION
Before using the appliance, ensure that the voltage of your
electricity supply is in the correct range of 220-240V.
SPECIFICATIONS
Model: ..........................................HC988
Net weight: ................................515g
Mains supply voltage: .........220 - 240V~, 50Hz
Power ...........................................8W
Class II double insulated. This product must not be
connected to earth.
MAIN COMPONENTS
Blade Assembly1.
Clipper Body2.
Hanging Loop3.
On/O Switch4.
Adjustable Lever5.
Oil Bottle6.
Comb7.
Set of 4 x Comb Attachments8.
Scissors9.
Cleaning Brush10.
UNPACKING
In the box you should nd the appliance and the accessories shown
in the Main Components drawing.
Remove all the packing from these and retain the packaging. If you
dispose of it, please do so according to any recycling regulations.
If items are missing or damaged, contact your nearest Tesco store
for assistance.
Read and retain this user guide. If you pass the appliance to a third
party, make sure to include this user guide.
OPERATING INSTRUCTIONS
WARNING: NEVER USE THE APPLIANCE ON WET HAIR. IT IS ONLY
DESIGNED FOR USE ON DRY HAIR.
When using this appliance for the rst time it is advisable to
experiment initially on an area of light hair growth.
Before starting, comb the hair 1.
in the direction of hair growth
as shown.
Remove the guard from the 2.
blade.
The Comb Attachments each 3.
cut hair to a dierent length.
Comb Cut length
1 ..................3mm (1/8”)
2 ..................6mm (1/4”)
3 ..................9mm (3/8”)
4 ..................13mm (1/2”)
Select the Comb Attachment 4.
for the cutting length you
require and clip the Comb
Attachment over the Blade
Assembly.
NOTE:- It is advisable to start
with the longest cut, #4, and
cut again with a dierent
comb if a shorter cut is
required.
Check that the Clippers are 5.
switched o, then plug them
into the mains.
Switch on the Clippers by 6.
setting the On/o Switch to
the ‘ON’ position.
Move the Adjustable Lever to 7.
the upward position (shortest
cut) when using one of the
Comb Attachments.
Page 2
Holding the Comb Attachment 8.
against the head with the teeth
pointing upwards and at against
the scalp, start by clipping the
sides from the bottom of the
head upwards. Slowly move the
Clippers up towards the top of
the head cutting small amounts
at a time.
Repeat step 8 around 9.
both sides and the
back of the head.
Position the Clippers 5.
so that only one edge
contacts the hair.
Slowly shape the hair 6.
around the ears and
contour the neckline
by positioning the
blades against the
neck and moving
downwards.
For nal trimming of the hair, fringe or beard, use the scissors 7.
supplied.
After use
When you have nished, switch o the Clippers by setting the
power switch to the ‘0’ position.
Always clean the blades after use with the brush provided.
Align the blades so that the 7.
upper cutting blade tips are
positioned approximately
1.2mm beneath the xed
lower blade tips.
Tighten the securing screws 8.
fully.
Re-check the alignment of 9.
the blades as described in
step 7.
HC988
Hair Clipper Set
Clip the top of the head from 10.
front to back.
NOTE:- Do not push the Clippers
or force the Clippers through the
hair.
To contour the neckline and area around the ears
WARNING: The Clipper blades are
very sharp when unguarded.
CAUTION: Care should be taken
when using the Clippers without
a Comb Attachment tted as the
Clippers will remove any hair
that comes into contact with the
blades.
Switch o the Clippers.1.
Unclip any Comb Attachment 2.
tted to the Clippers.
Set the Adjustable Lever to 3.
the required position for
length of cut.
Switch on the Clippers.4.
CARE AND CLEANING
The appliance must be unplugged before cleaning.
The black plastic Comb Attachments should be cleaned in 1.
running water. Ensure they are completely dry before using
them.
Clean the blades with the Cleaning Brush provided to remove 2.
remaining loose hair clippings.
Clean the housing of the Clippers with a soft, dry cloth.3.
The cutting blades should be lightly oiled with the oil provided 4.
once every few haircuts.
DO NOT use any harsh detergents, abrasives, solvents or cleaners.
NEVER immerse in water to clean.
Dry thoroughly before use.
To remove the cutting blades
Periodically it is advisable to remove, clean and re-align the Blade
Assembly for more thorough cleaning.
Remove the two Philips screws securing the blade guard.1.
Lift o the two-part Blade Assembly.2.
Clean the Blade Assembly and inside the housing thoroughly 3.
with the Cleaning Brush provided.
Lightly oil the contact area between the blades.4.
Re-assemble the Blade Assembly to the Clippers and re-t the 5.
Philips screws. Do not tighten them fully at this stage.
Set the Adjustable Lever up to the ‘shortest cut’ position.6.
WARRANTY
Your appliance is covered by a warranty for 12 months from the date
of purchase. If a fault develops during this period, please return the
unit to your nearest Tesco store together with the original receipt
as proof of purchase. This warranty in no way aects your consumer
rights.
UK: Waste electrical products /batteries should not be
disposed of with household waste. Separate disposal facilities
exist, for your nearest facilities. See www.recycle-more.co.uk
or in-store for details.
ROI: Produced after 13th August 2005. Waste electrical
products/batteries should not be disposed of with household
waste. Please recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
HC988 V0
User Guide
Tesco Stores Ltd,
Delamare Road, Cheshunt, Herts, EN8 9SL
Loading...