EBKS10 Electric Blanket User Manual EBKS10 Electric Blanket User Manual EBKS10 Electric Blanket User Manual
SAFETY GUIDE - PLEASE READ CAREFULLY
Please follow all the safety precautions listed
below for safety and to reduce the risk of re,
injury or electrical shock.
Read the following instructions carefully •
before using the blanket and retain the
instructions for future use. If you pass this
product to a third person, please include
these instructions.
Remove any packaging material and •
promotional stickers before using the electric
blanket for the rst time.
ELECTRICAL CAUTIONS
Fully unwind the power cords before use.•
Use the electric blanket only with the •
detachable controllers provided.
If any abnormality or defect in operation of •
this blanket is observed, discontinue its use
immediately and consult a retailer’s service
agent or similarly qualied person.
Regularly inspect the supply cords, plugs, •
controllers and blanket to ensure that the
appliance is in serviceable condition. If found
damaged in any way, immediately cease use
of the blanket as a safety hazard may exist.
It is recommended that a qualied and •
registered person inspect your electric blanket
after each 3 years of use.
The appliance is supplied with specially •
designed controllers and no attempt should
be made to repair them.
There are no serviceable parts inside the •
product.
Use this blanket only on a 220-240VAC mains •
supply.
When removing the plug from the mains •
supply, hold the plug not the power cord.
The mains plugs are the ultimate means of •
disconnection from the mains supply. At
all times the mains supply plugs must be
unobstructed and freely operable.
The installation of a residual current device •
(safety switch) is recommended to provide
additional safety protection when using
electrical appliances. It is advisable that a
safety switch with a rated residual operating
current not exceeding 30mA be installed in
the electrical circuit supplying the appliance.
Consult your electrician for professional
advice.
WARNING: If a power cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualied persons in order to avoid a
hazard.
INSTALLATION CAUTIONS
Use this blanket as an under blanket only. This •
product is not recommended for futons or
similar folding bedding systems.
Do not use the blanket rucked, rolled or •
folded. Spread it out fully.
This blanket is not recommended for use on •
an adjustable bed. If it is used on an adjustable
bed, check that the blanket or cord cannot
become caught or rucked.
The blanket must not be used over or under •
a waterbed.
Make sure that the heating area (wire element) •
does not hang over the edge of the mattress
on any side of the bed.
Arrange the blanket so that it is not beneath •
pillows and / or bolsters.
Keep the control units away from open •
windows.
The exible power supply cords and switches •
must, as far as practicable, be kept outside the
bed.
Do not use pins or sharp objects with this •
blanket – they may damage the electric
wiring.
Do not coil or lay the exible lead on the •
blanket.
Do NOT use this blanket on a single bed.•
This appliance is for domestic use only. It is •
not intended for use in hospitals.
CAUTIONS IN USE
Do not tuck in the blanket.•
To avoid overheating, this blanket must be •
kept in the fully spread condition at all times
during use.
Bed clothes should not be folded back when •
the blanket is switched on.
Do not leave heavy objects on the bed when •
the unit is switched on.
Switch o at the power outlet and remove the •
plug when the blanket is not in actual use.
It is dangerous to use a hot water bottle at the •
same time as an electric blanket.
Do not use this blanket with an infant, an •
inrm person or anyone unable to detect or
regulate the temperature for themselves.
The blanket is not to be used by young •
children, unless the controls have been preset by a parent or guardian, or unless the child
has been adequately instructed on how to
operate the controls safely.
Use only for human use, not for pets.•
Using this product over a long extended •
period can result in skin irritation or burns.
Persons suering from bed-wetting should •
not use this product.
Do not switch the power on if the blanket is •
wet or in a folded state.
This appliance is not intended for use by •
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliances by a person
responsible for their safety.
Children should be supervised to ensure that •
they do not play with the appliance.
If the blanket gets soiled, follow the cleaning •
instructions in full.
Do not switch the blanket on if it is wet or •
after washing. Allow it to dry naturally.
Do not dry-clean this blanket. Cleaning liquids •
may damage the insulation or covering of the
heating unit.
Avoid pressing creases into the appliance.•
When storing, allow the blanket to cool fully •
before folding. Fold neatly, but not tightly (or
roll) in the original packaging without sharp
bends in the heating element and store where
no other objects will be placed upon it.
ELECTRICAL INFORMATION
Before using this appliance ensure that the
voltage of your electricity supply is the same as
that indicated on the blanket label and the rating
plate of the controllers.
SPECIFICATIONS
Model: EBKS10 King-size Electric Blanket
Type: Tie-down underlay design
Size: 143 cm x 150 cm approx.
Voltage: 220-240 V~, 50 Hz
Power consumption: 2 x 55-65 Watts
Net Weight: 2 kg
Class II construction double insulated.
This product must not be connected to
earth.
WARRANTY
Your appliance is covered by a warranty for 12
months from the date of purchase. If a fault
develops during this period, please return the
unit to your nearest Tesco store together with the
original receipt as proof of purchase. This warranty
in no way aects your consumer rights
UK: Waste electrical products /batteries
should not be disposed of with
household waste. Separate disposal
facilities exist, for your nearest facilities.
See www.recycle-more.co.uk or in-store
for details.
ROI: Produced after 13th August 2005.
Waste electrical products/batteries
should not be disposed of with
household waste. Please recycle where
facilities exist. Check with your Local
Authority or retailer for recycling advice.
EBKS10 V0.3
CONTROLS AND FEATURES
PREPARATIONS FOR USE
Remove all exterior packaging from the appliance.
Carefully remove the blanket from the polythene
storage bag. Retain the bag for future use. If you
dispose of any packaging please do so according
to any recycling regulations.
CONNECTING THE CONTROLLERS
The dual controller plugs connect to two sockets
which must be located at the pillow end of the
electric blanket.
Connecting a controller plug
Push the plug fully home into the socket, ensuring
that the security latch has engaged on the pin at
the side of the plug.
NOTE: The plugs are polarised so will only t the
socket when correctly aligned.
Blanket wiring1.
Heat control2.
Temperature scale (braille)3.
Power indicator4.
Tie tapes5.
Cord to blanket6.
Temperature scale7.
Power cord8.
Removing a controller plug
Lift the security latch.1.
Pull out the plug.2.
CAUTION: Always hold both the plug and socket
when connecting or disconnecting a controller.
NEVER pull on the cable or blanket to disconnect
a controller plug.
EBKS10 Electric Blanket User Manual EBKS10 Electric Blanket User Manual
SECURING YOUR BLANKET TO THE BED
Connect both controllers to the blanket before 1.
placing it on the bed.
Place the blanket on the mattress, leaving 2.
room for the pillows. The cables to the
controllers should be located at the pillow
end with the cables exiting from underneath
the blanket as shown. This will place the footwarming area of the blanket at the foot of the
bed. The controllers should not be connected
to the power outlet at this stage.
CAUTION: Take care to ensure that the controller
cables can exit directly as shown to separate mains
outlets on the wall where the bed is placed. Check
that the cables will not be stretched, pinched or
lay in a path where they could be a trip hazard.
Remove the tags from the tie tapes. 3.
Pass the middle tie tape under the middle of 4.
the mattress and through the middle eyelet
on the opposite side. Tie tightly.
CAUTION: Matresses can be very heavy. A
minimum of two people is recommended when
lifting the mattress and tieing down the blanket.
Pass the end tie tape under the corresponding 5.
bottom corner of the mattress and through
the end eyelet, down under the other bottom
corner of the mattress and through the
bottom side eyelet
Tie the tie tape rmly. 6.
Repeat procedure 5 for the tie cord at the top 7.
end.
The blanket should now be rmly secured to the
mattress as shown.
Make the bed once you are satised that the 8.
blanket is rmly secured.
Connect the power cords from the controllers 9.
to separate power outlets.
Your electric blanket is now ready for use.
OPERATION & CONTROLS
The control has both numeric and Braille
temperature markings, which allow for easier
temperature adjustment in the dark.
The settings are:
O OFF
1 Low Heat (recommended for all night use)
2 Medium Heat
3 Preheat (recommended to pre-heat the
bed 1 to 2 hours before use with standard
bedding).
DO NOT SLEEP WITH YOUR BLANKET ON THE
PREHEAT SETTING.
When the blanket is switched on the power
indicator illuminates.
Using the blanket for the rst time:
We recommend that the blanket be set on “1”
for 2 hours before sleeping on the bed. This will
assist in drying out any moisture which has been
accumulated in the mattress or the blanket.
You may notice an odour when using the blanket
for the rst time, due to the insulation material.
This is harmless and will subside quickly.
CARE AND MAINTENANCE
Cleaning:
Always unplug and remove the controllers
from the blanket before cleaning.
This electric blanket is washable in accordance
with the following cautions and instructions -
Do not wring the electric blanket.
Do not dry clean.
Do not iron.
Spot cleaning
Sponge the aected area using a luke warm
neutral detergent or mild soapy solution. Follow
this with a sponging using a clean water solution.
Remove any excess water by compressing the
wet area between absorbent towels. Follow the
instructions below to dry the blanket.
Hand washing:
Immerse the electric blanket in a luke warm
neutral detergent or mild soapy solution.
Soak for ve minutes, remove from the solution,
and gently squeeze the solution through the
electric blanket.
Rinse the blanket thoroughly in clean luke warm
water, gently squeeze and drain the excess water
from the electric blanket.
Machine washing:
Your electric blanket can be washed in a domestic
washing machine (size permitting) or by a
commercial laundry.
To wash your blanket in a domestic washing
machine, wash on the WOOL or DELICATES
setting using a neutral wool detergent or mild
soapy solution.
DO NOT wash on a HOT cycle, the temperature
must be kept below 40°C.
Do not use high speed or extra spin cycles.
Do not machine wash with the control/s
connected to the blanket.
Drying:
Drape the electric blanket across a clothes line
and drip dry. DO NOT use pegs to secure the
electric blanket in position. DO NOT dry with a
hair dryer or heater.
Tumble drying:
You may tumble dry your blanket on LOW setting
for 15 minutes MAXIMUM.
Smooth the blanket by gently pulling any creases
out of the fabric.
Do not dry with the control/s connected to the
blanket.
Storage:
When not in use, allow to cool then fold neatly but
not tightly (or roll) in the original packaging without
sharp bends in the heating element. Store where no
other objects will be placed upon it.
User manual
Tesco Stores Ltd, Delamare Road, Cheshunt, Herts, EN8 9SL
EBKS10
King-size electric blanket
Loading...