Page 1
DF98
9” Desk Fan
User Guide
OPERATION
OSCILLATION
SWITCHING ON
Your fan is controlled by a four position switch.
0 switches the fan off.
Your fan can oscillate about its axis for cooling.
1 selects Low speed
! To oscillate the fan press the Oscillator Knob
2 selects Medium speed
DOWN.
3 selects High speed
! To operate in a fixed position lift the knob UP.
! Ensure the switch is set to‘0’.
Warning: Ensure that the fan can oscillate
! Plug in the fan and switch it on at the mains.
freely without it hitting nearby objects.
! Select the desired speed.
DFMM1211 Desk Fan User Guide
ADJUSTING THE ANGLE OF THE FAN switched off and unplugged at the mains point.
Your fan can be angled up or down.
CARE AND MAINTENANCE
! Switch the fan off
Plastic components may be cleaned with a mild
!
detergent lightly applied to a damp cloth. Remove
Hold the fan at the back of the
all traces of detergent with a clean damp cloth and
motor housing with one hand and the column
dry thoroughly before operating the appliance.
with the other. and gently but firmly angle the
The exterior surfaces of the appliance should be
fan up or down.
cleaned occasionally in the manner described
! DO NOT USE FORCE!
above.
Never spray liquid onto any part of the appliance or
allow liquids to run into the interior of the appliance.
No other maintenance is required. There are no
user serviceable parts in the appliance and
unauthorised dismantling of the motor or base will
render the warranty void.
When not in use, the appliance should be securely
stored away from sources of moisture and heat
and where children and pets cannot access the
unit.
WARRANTY
Your Tesco appliance is covered by a warranty for
12 months from the date of purchase. If a fault
develops during this period, please return it
together with your original purchase receipt to
your nearest Tesco store.
This warranty in no way affects your consumer
rights.
CARRYING THE FAN
Do not carry the fan by the cage. Hold the fan
column in one hand and the base in the other
when moving the fan.
When moving the fan always ensure that it is
The fan head pivots around the pivot screw in
the neck.
DFMM1211 Desk Fan User Guide
NECK PIVOT
Page 6
Tesco Stores Ltd, Delamare Road, Cheshunt, Herts, EN8 9SL
Desk Fan
USER GUIDE
DFMM1211
Page 5
ASSEMBLING THE FAN
Place the base on a level steady surface.
1: Remove the screw from the bottom of the
fan head column.
Place the fan head on the lower column.
Replace the screw and tighten it very firmly to
securely attach the head to the base column.
After tightening the screw finger tight, use a
screwdriver to add one quarter turn.
DO NOT disturb the lower screw on the column
base.
.
1
2
3
0
POWER SWITCHOSCILLATOR
PIVOT
SCREW
Page 2
INTRODUCTION
Before using this appliance please read all these
notes and instructions carefully and famliarise
yourself with the features of your new fan. In
par ticul ar, ple ase s tudy the assem bly
instructions before commencing assembly.
UNPACKING AND ASSEMBLY
Unpack all the items carefully and remove all
plastic wrappings from the component parts.
Check the fan and components. If any items are
damaged or missing, please return the
appliance for replacement to the store you
purchased it from, or to your nearest Tesco
store. Remember to take your receipt.
Retain the packing, or if you decide to dispose of
it, make sure that you do so with due regard to
any recycling provisions currently in force.
Assemble the fan on a sturdy workbench. You
will need a No 1 and No 2 Posidriv screwdriver.
Assemble the base and fan head separately
before joining the two parts togther.
Fan
Blade
Securing
Clip
Oscillator
Button
Column
Base
! This appliance is not intended for use by persons
IMPORTANT SAFETY INSTRUCTIONS
(including children) with reduced physical,
! Read these instructions.
sensory or mental capabilities, or lack of
! Keep these instructions.
experience and knowledge, unless they have
! Follow all instructions.
bee n giv en sup ervi sion or in struc tion
! Unplug the fan when not in use, before moving it
concerning use of this appliance by a person
between locations, and before cleaning,
responsible for their safety.
! Refer all servicing to qualified service personnel.
! Children should be supervised to ensure that
! Do not expose this apparatus to rain or
they do not play with the appliance
moisture, e.g. by operating it in a window or
! This product is intended solely for household use
verandah, etc.
! The means of disconnecting this appliance from
! Do not immerse the power cord or plug in water.
the mains supply is the mains plug. This should
! Do not spray liquids into or near the fan
be unobstructed and readily operable at all
! Do not operate this unit in the presence of
times .
explosive and/or flammable fumes.
ELECTRICAL INFORMATION
! Do not place the fan on or near an open flame,
Before using this appliance ensure that the voltage
cooking or heating appliance.
of your electricity supply is the same as that indicated
! Avoid contact with moving parts.
on the appliance.
! Protect the power cord from being walked on or
pinched.
! The power cord must not overhang the edge of
a desk or other surface.
! Do not operate the fan with a damaged cord or
plug, after a malfunction or if dropped or
Class I construction. This product must be connected to
damaged in any way.
earth.
! To disconnect grip the plug and pull from wall
outlet. Never yank on the power cord.
! If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid hazard.
! The use of attachments not recommended by
the manufacturer may be hazardous.
! Warning: Do NOT use this fan with any solid
state voltage regulator or speed control.
! Always use on a dry, level and stable surface
when operating to avoid overturning.
! Do not hang or mount the fan on a wall or
ceiling.
! Never use the fan without the guards correctly
fitted.
! Do not insert any object into the fan guards
whether the fan is running or not.
! Close supervision is necessary when any
appliance is used by or near children.
SPECIFICATIONS
Mains Voltage: 220V-240V AC, 50 Hz
Mains Power: 45 Watts
Net weight:
UK: Waste electrical products should not be
disposed of with household waste.
e for details.
ROI: Produced after 13th August 2005.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice
3.0 kg
Separate
disposal facilities exist, for your nearest
facilities. See www.recycle-more.co.uk or instor
Guard
Screw
Front
Guard
Rear
Guard
Remove the Column Screw
b
ATTACHING THE COLUMN AND BASE
! Remove the screw from the base of the column
! Place the column in the base
! Hold the base and the column. Invert the assembly. Firmly
attach the screw to the column to secure the assembly
D: Attached to one of the guards
there is a small screw and nut.
Remove these and keep them safe.
Open the side clips of the front guard
fully.
Hook the top clip of the front guard
over the rear guard and pull down to
attach it.
Manoeuvre the front guard so that the
screw holes in both guards line up.
Loosely attach the screw and nut.
Line up the two guards and then shut
the clips to secure the two guards.
Now tighten the screw tightly.
This completes the fan head assembly
Page 2
Page 4
DFMM1211 Desk Fan User Guide DFMM1211 Desk Fan User Guide DFMM1211 Desk Fan User Guide
Speed
Switch
Attaching
Screw
Handle
Insert the Column
c
Screw the base to the column
d
B: Fit the Rear Guard on the motor housing. Place the flat in the
guard over the motor. The handle should be at the top. Replace the
guard nut and hand tighten it firmly.
A: Unscrew the guard nut from the motor head by
rotating it anticlockwise.
C: Fit the fan blade as shown.
Unscrew the fan screw so that it is clear of the mounting bush.
Place the fan blade on the spindle and push the blade in as far
as it will go. Now tighten the screw tightly to lock the fan blade
to the spindle.
Pull the fan blade slightly to check it is firmly attached.
Screw
Screw
TOP CLIP
ASSEMBLING THE FAN HEAD
Page 3
Loading...