Terex Genie Lift Guard S-40, Genie Lift Guard S-60, Genie Lift Guard S-65, Genie Lift Guard S-45 Operator's Manual Supplement

Operator's Manual Supplement

Lift Guard™ Sensor for Booms

S®-40

from S4015-20505

S®-45

S®-60

From S6012-24492

S®-65

First Edition
First Printing
Part No. 1294064GT

Operator's Manual Supplement First Edition • First Printing

Introduction

Introducti on

Lift Guard™ Sensor for Booms

The Lift Guard Sensor system is designed to alert
the operator and occupants before the platform
makes contact with an object from behind or above.
The operator will be warned by light and joystick
vibration when in close proximity to the object and
boom movement will be interrupted before contact.

The system is designed to be unobtrusive, with
sensors mounted at the rear of the platform hand
rail. When the platform moves near an object that
is sensed the platform controls will indicate with a
warning light and vibration feedback.Some
machine functions will operate at reduced speed. If
the platform continues toward the object, the
frequency of the light will increase until the boom
movement is halted by the system. The operator
has the option to acknowledge by pushing a button
on the platform control box and continue moving
toward the object at a reduced speed.

Danger

Failure to obey the instructions and
safety rules in this manual and in the
operator's manual for this machine
will result in death or serious injury.

Note: These installation instructions apply to
the Genie models listed below:

S-Booms: S®-40, S®-45, S®-60, S®-65

2 Lift Guard

™

Sensing Part No. 1294064GT

First Edition • First Printing Operator's Manual Supplement

Lift Guard Sensor for Booms
weight.

28.

Read the supplement manual,
part number, 1294064.

Lift Guard Sensor LED

Introduction

Lift Guard™ Sensor for Booms

Safety

Read, understand and obey all warnings and
instructions provided with the Lift Guard Sensor.

Do not exceed the rated platform capacity. The
weight of the Lift Guard Sensor assembly will
reduce the rated platform capacity and must be
subtracted from the total platform load.

The Lift Guard Sensor for Booms assembly weighs

28.8 lbs/13.1 kg.
Verify the Lift Guard Sensor is securely installed.

Symbol and Hazard Pictorials Definitions

8 lbs/13.1 kg.

Pre-operation Inspection

 Be sure that the operator’s manual, safety

manual, responsibilities manual and any
necessary supplements are complete, legible
and in the storage container located in the

platform.
 Be sure that all decals are legible and in place.
Check the following components or areas for

damage, improperly installed, or missing parts and
unauthorized modifications:

 Nuts, bolts and other fasteners

 Electrical components, wiring, and

electrical cables

Check entire machine for:

 Cracks in welds or structural components

 Dents or damage to machine

 Excessive rust, corrosion or oxidation

 Damage or debris on sensors

Part No. 1294064GT Lift Guard

™

Sensing 3