Teo 8000 Installation

8000 Series
Terminal Adapters
Installation Instructions
The 8000 Series Terminal Adapters are options for Tone Commander 8610, 8620, or 8810 ISDN telephones. Several Terminal Adapter models are available for interfacing with a computer application and/or standard analog telephone devices. Each Terminal Adapter is housed in a module that replaces the expansion cover on the bottom of the telephone.
8001TA, 8003TA, 8004TA, and 8005TA models enable control of the telephone by any TAPI-compliant Windows computer application program.
The 8001TA and 8003TA connect to the computer via an RS-232 serial interface. The 8004TA and 8005TA use a USB interface. An analog telephone port, described below, is included with 8003TA and 8005TA models.
A Windows TSPI driver, available for download from www.tonecommander.com, is required to use the TAPI features. You will also need TAPI-compliant Windows application program. A USB driver, also available from www.tonecommander.com, is also required for 8004TA and 8005TA models.
®
PhoneLink™ for Outlook Outlook, can be downloaded from www.tonecommander.com. The TSPI driver is included with PhoneLink for Outlook. Several TAPI-compliant programs are available from other vendors.
, a free basic call alerting and control application that integrates with Microsoft
®
Analog Port Terminal Adapters
8002TA, 8003TA, and 8005TA models add one POTS (Plain Old Telephone Service) port to an ISDN telephone, for standard telephones, fax machines, or analog modems.
POTS port features include independent ring delay settings, call waiting tone and caller ID display support, a privacy option to prevent line access from the ISDN telephone when busy, call transfer and conference, and originating call appearance selection.
In addition to the analog port, a TAPI port is provided on the 8003TA (RS-232) and 8005TA (USB).
13-280119 Rev. A
August 2006
Terminal Adapter Installation
Mounting
Refer to the illustration on the following page.
1. Disconnect the line cord. For U-interface models with local power, disconnect the power supply.
Power must be disconnected before installing the Terminal Adapter. Wait 10 seconds after disconnecting power before proceeding.
STATIC SENSITIVE DEVICES – use appropriate precautions.
Do not touch the Terminal Adapter connectors or circuitry!
2. Press the telephone stand down to disengage the snap tabs, then lift off the stand. The low desktop stand position is shown; the removal procedure is the same for high desktop and
wall mount positions.
3. Remove the Phillips screw from the center of the expansion cover. Press the back edge in to release the retention snap, and tilt the top edge of the cover away from the telephone as shown to remove the cover.
4. Install the Terminal Adapter by inserting the lower tabs into the bottom edge of the telephone opening, then carefully pressing the top edge of the Terminal Adapter into the telephone opening until it engages the retention snap. The Terminal Adapter has a connector that mates with the telephone connector as shown below.
Replace the cover screw.
Page 2 Tone Commander 8000 Series Terminal Adapters
Loading...
+ 2 hidden pages