Teltronic U PTRUNK25RF760 User Manual

CLASSIFICATION:

RF Unit USER AND INSTALLATION MANUAL

PRODUCT:

CODE:

VERSION:

RF Unit

D168X01_DDS09

01

REVISION:

03

DATE:

16/06/09

General information Internal document

DOCUMENT MAINTENANCE

THIS DOCUMENT HAS 17 PAGES

EDIT. DATE AUTHOR DESCRIPTION

1.0 27/12/07 José Roman RF Unit User and Installation Manual.

1.1 09/10/08 Javier Córdova General revision.

1.2 04/11/08 Javier Córdova Correction of subclauses 6.2, 6.3.

1.3 16/06/09 José Román Add FCC RF Exposure Requirements:

DOCUMENT APPROVAL

ACTIVITY NAME DATE SIGNATURE

Prepared

Revised

Project Manager

Approved

R&D Director

01.01.00/1 Rev.1

RF Unit USER AND

Code: D168X01_DDS09

INSTALLATION

MANUAL

Disclaimer

Although every reasonable effort has been made to ensure the accuracy of the information contained herein
and any other referred document, this should not be construed as a commitment on the part of Teltronic S.A.
Unipersonal, and the liability of Teltronic S.A. Unipersonal for any errors and omissions shall be limited to the
correction of such errors and omissions. Teltronic S.A. Unipersonal welcomes any comment as a way to
improve any delivered documentation.

The information contained herein has been prepared for the use of appropriately trained personnel, and it is
intended for the purpose of the agreement under which the information is submitted. Any party using or relying
upon this information assumes full responsibility for such use and in no event shall Teltronic S.A. Unipersonal
be liable to anyone for especial, collateral, incidental, or consequential damages in connection with or arising
out of the use of this information.

The information or statements given in these documents regarding the suitability, capacity or performance of
the mentioned hardware or software products cannot be considered binding but shall be defined in the
agreement made between Teltronic S.A. Unipersonal and the customer.

Teltronic S.A. Unipersonal reserves the right to revise these documents and to make changes to its content at
any time, without prior notification.

Copyrights

No part of the information contained herein and the other referred documents may be copied, distributed or
transmitted by any means to any other party without prior written permission of Teltronic S.A. Unipersonal. The
distribution of this document may be also covered by NDA (non-disclosure agreement) between Teltronic S.A.
Unipersonal and the receiver.

Please also note that part of these contents even may be covered by patent rights.

This document, the referred documents and the described product are considered protected by copyright
according to the applicable laws.

Teltronic and the Teltronic logo are registered trademarks of Teltronic S.A. Unipersonal.

Copyright © Teltronic S.A. Unipersonal. All rights reserved.

Date: 16/06/09 Page: 2 of 16

01.01.00/1 Rev.1

RF Unit USER AND

Code: D168X01_DDS09

INSTALLATION

CONTENTS:

1.

INTRODUCTION ......................................................................................................... 4

2.

UNPACKING AND CHECKING .................................................................................. 5

3.

PREVIOUS CONSIDERATIONS................................................................................. 5

4.

INFORMATION ON SAFETY AND ELECTROMAGNETIC COMPATIBILITY ............ 5

5.

EQUIPMENT DESCRIPTION ...................................................................................... 7

5.1.

FRONT VIEW ....................................................................................................... 7

5.2.

REAR VIEW ......................................................................................................... 8

5.3.

MODULES ............................................................................................................ 9

MANUAL

Date: 16/06/09 Page: 3 of 16

6.

7.

8.

INSTALLATION GUIDE ............................................................................................ 12

6.1.

LOCATION ......................................................................................................... 12

6.2.

POWER SUPPLY CONNECTION ...................................................................... 12

6.3.

ANTENNA CONNECTION ................................................................................. 13

6.4.

SWITCHING ON THE RF UNIT .......................................................................... 13

CONFIGURATION .................................................................................................... 14

INCIDENTS ............................................................................................................... 14

8.1.

ALARMS ............................................................................................................ 14

01.01.00/1 Rev.1

!

RF Unit USER AND

Code: D168X01_DDS09

INSTALLATION

MANUAL

1. INTRODUCTION

The RF Unit is the RF transceiver of Teltronic P25 systems, with a transmitter
output power of 100W. Therefore, this is a mandatory module in the infrastructure P25
network. It is manufactured following a robust mechanical modular design which allows
simple and economic maintenance.

The RF Unit is available in the following frequency bands:



380 - 400 MHz



410 - 430 MHz



450 - 470 MHz



764 - 806 MHz



806 - 870 MHz

The modules that form the RF Unit are:



RPS (Repeater Power Supply P25)



RPA P25 (Repeater Power Amplifier P25)



RTX P25 (Repeater Transmitter P25)



RRX P25(Repeater Receiver P25)



BSYNC (RF Unit Synchronism) - OPTIONAL



RCPU P25(Repeater Control Processing Unit P25)

The proper operation of any electronic device depends on its correct use. It is

therefore recommended to follow the instructions in this manual.

Date: 16/06/09 Page: 4 of 16

CAUTION: Switch the RF Unit off before inserting/removing any of its modules.

01.01.00/1 Rev.1

RF Unit USER AND

Code: D168X01_DDS09

INSTALLATION

MANUAL

2. UNPACKING AND CHECKING

The following elements are supplied in the box:

RF Unit
50Ω / 20W load termination
Power Supply Cable
Maintenance Cable
Two Ethernet Cables

The equipment is supplied with all the modules already assembled in the rack. The
modules in the basic configuration are: Power Supply module (RPS), Power Amplifier
(RPA P25), Transmitter (RTX P25), Receiver (RRX P25) and Control (RCPU P25).
Synchronism module (BSYNC) is necessary for testing purposes.

IMPORTANT: if any of these elements is missing or damaged, contact your dealer
and / or installer.

Date: 16/06/09 Page: 5 of 16

3. PREVIOUS CONSIDERATIONS

This manual contains information on instructions for installation, maintenance and
use. Read the following pages before using this equipment.

Do not switch on the RF Unit without having previously connected the TX antenna
and the 50Ω load to the TNC connector. The equipment may be seriously damaged. It is
important to use an antenna adjusted to the RF Unit transmitter frequency band.

4. INFORMATION ON SAFETY AND ELECTROMAGNETIC COMPATIBILITY

The equipment has been designed to fulfil the applicable compliance regulations.

The equipment complies with Part 15 of the FCC Title 47 of the Code of Federal
Regulations. Operation is subject to the condition that this device does not cause harmful
interference.

The equipment complies with the applicable Part 90 of the FCC Title 47 of the
Code of Federal Regulations.

01.01.00/1 Rev.1