Teltronic U PTRNKTBSR75800, PTRNKTBSR75450 Users manual
BSR75 USER AND INSTALLATION MANUAL
CLASSIFICATION:
PRODUCT:
CODE:
VERSION:
BSR75
D198N61_DDS06
01
REVISION:
00
DATE:
General information Internal document
DOCUMENT MAINTENANCE
THIS DOCUMENT HAS 17 PAGES
EDIT. DATE AUTHOR DESCRIPTION
1.0 15/07/09 Javier Córdova First edition.
15/07/09
DOCUMENT APPROVAL
ACTIVITY NAME DATE SIGNATURE
Prepared
Revised
Project Manager
Approved
R&D Director
01.01.00/1 Rev.1
BSR75 USER AND
Code: D198N61_DDS06
INSTALLATION
Disclaimer
Although every reasonable effort has been made to ensure the accuracy of the information contained herein
and any other referred document, this should not be construed as a commitment on the part of Teltronic S.A.
Unipersonal, and the liability of Teltronic S.A. Unipersonal for any errors and omissions shall be limited to the
correction of such errors and omissions. Teltronic S.A. Unipersonal welcomes any comment as a way to
improve any delivered documentation.
The information contained herein has been prepared for the use of appropriately trained personnel, and it is
intended for the purpose of the agreement under which the information is submitted. Any party using or relying
upon this information assumes full responsibility for such use and in no event shall Teltronic S.A. Unipersonal
be liable to anyone for especial, collateral, incidental, or consequential damages in connection with or arising
out of the use of this information.
The information or statements given in these documents regarding the suitability, capacity or performance of
the mentioned hardware or software products cannot be considered binding but shall be defined in the
agreement made between Teltronic S.A. Unipersonal and the customer.
Teltronic S.A. Unipersonal reserves the right to revise these documents and to make changes to its content at
any time, without prior notification.
Copyrights
No part of the information contained herein and the other referred documents may be copied, distributed or
transmitted by any means to any other party without prior written permission of Teltronic S.A. Unipersonal. The
distribution of this document may be also covered by NDA (non-disclosure agreement) between Teltronic S.A.
Unipersonal and the receiver.
Please also note that part of these contents even may be covered by patent rights.
This document, the referred documents and the described product are considered protected by copyright
according to the applicable laws.
Teltronic and the Teltronic logo are registered trademarks of Teltronic S.A. Unipersonal.
Copyright © Teltronic S.A. Unipersonal. All rights reserved.
MANUAL
Date: 15/07/09 Page: 2 of 16
01.01.00/1 Rev.1
CONTENTS:
1.
INTRODUCTION ......................................................................................................... 4
2.
UNPACKING AND CHECKING .................................................................................. 5
3.
PREVIOUS CONSIDERATIONS................................................................................. 5
4.
INFORMATION ON SAFETY AND ELECTROMAGNETIC COMPATIBILITY ............ 5
5.
EQUIPMENT DESCRIPTION ...................................................................................... 7
5.1.
FRONT VIEW ....................................................................................................... 7
5.2.
REAR VIEW ......................................................................................................... 8
5.3.
MODULES ............................................................................................................ 9
6.
INSTALLATION GUIDE ............................................................................................ 12
6.1.
LOCATION ......................................................................................................... 12
BSR75 USER AND
Code: D198N61_DDS06
INSTALLATION
MANUAL
Date: 15/07/09 Page: 3 of 16
7.
8.
6.2.
POWER SUPPLY CONNECTION ...................................................................... 12
6.3.
ANTENNA CONNECTION ................................................................................. 13
6.4.
SWITCHING ON THE BSR75 ............................................................................ 13
CONFIGURATION .................................................................................................... 14
INCIDENTS ............................................................................................................... 14
8.1.
ALARMS ............................................................................................................ 14
01.01.00/1 Rev.1
BSR75 USER AND
!
Code: D198N61_DDS06
INSTALLATION
MANUAL
Date: 15/07/09 Page: 4 of 16
1. INTRODUCTION
The BSR75 is a digital RF transceiver with a transmitter output power of 75 W. It is
manufactured following a robust mechanical modular design which allows simple and
economic maintenance.
The BSR75 is available in the following frequency bands:
380 - 400 MHz
410 - 430 MHz
450 - 470 MHz
806 - 870 MHz
The modules that form the BSR75 are:
RPS75 (Repeater Power Supply)
RPA75 (Repeater Power Amplifier)
RTX75 (Repeater Transmitter)
RRX (Repeater Receiver)
BSYNC (BSR75 Synchronism) - OPTIONAL
RCPU (Repeater Control Processing Unit)
The proper operation of any electronic device depends on its correct use. It is
therefore recommended to follow the instructions in this manual.
CAUTION: Switch the BSR75 off before inserting/removing any of its modules.
01.01.00/1 Rev.1
BSR75 USER AND
Code: D198N61_DDS06
INSTALLATION
MANUAL
Date: 15/07/09 Page: 5 of 16
2. UNPACKING AND CHECKING
The following elements are supplied in the box:
BSR75
50Ω / 20W load termination
Power Supply Cable
Maintenance Cable
Two Ethernet Cables
The equipment is supplied with all the modules already assembled in the rack. The
modules in the basic configuration are: Power Supply module (RPS), Power Amplifier
(RPA75), Transmitter (RTX75), Receiver (RRX) and Control (RCPU). Synchronism
module (BSYNC) is necessary for testing purposes.
IMPORTANT: if any of these elements is missing or damaged, contact your dealer
and / or installer.
3. PREVIOUS CONSIDERATIONS
This manual contains information on instructions for installation, maintenance and
use. Read the following pages before using this equipment.
Do not switch on the BSR75 without having previously connected the TX antenna
and the 50Ω load to the TNC connector. The equipment may be seriously damaged. It is
important to use an antenna adjusted to the BSR75 transmitter frequency band.
INFORMATION ON SAFETY AND ELECTROMAGNETIC COMPATIBILITY
The equipment has been designed to fulfil the applicable compliance regulations.
The equipment complies with Part 15 of the FCC Title 47 of the Code of Federal
Regulations. Operation is subject to the condition that this device does not cause harmful
interference.
The equipment complies with the applicable Part 90 of the FCC Title 47 of the
Code of Federal Regulations.
01.01.00/1 Rev.1
Loading...