Telex PN 801546 User Manual

Page 1
TELEX COMMUNICATIONS, INC.
8601 East Cornhusker Highway, Lincoln, NE 68505
INSTRUCTION MANUAL
ALP-600
ANTENNA BRACKET KIT Order No. 878898 PN 801546
General Description
The ALP-600 Antenna Bracket Kit is a configuration of aluminum brackets with mounting hardware used to securely hold the ALP-600 Telescoping Antenna Mast.
The Universal Stadium Mounting Plate, (Figure 1) can be mounted vertically or horizontally depending upon the object in which it is mounted to. The Antenna Mast Bracket Assembly, (Figure
2) then easily attaches to the previously mounted plate by turning the hand knobs until tight.
Components
.
Universal Stadium Antenna Mounting Plate
.
Antenna Mast Bracket Assembly
.
Antenna Bracket Hardware Kit
.
2 - U-bolts 4 - Hex Nuts
.
4 - Flat and Lock washers 2 - Lag Screws
.
4 - Wing Nuts
Figure 1
Universal Stadium Mounting Plate
Figure 2
Antenna Mast Bracket Assembly
-1-
Page 2
Antenna Mast Bracket Assembly
HANDKNOB
RETAININGRING
WASHER
BRACKET
FINALASSEMBLY
Figure 3 Figure 4 Figure 5
Assembly
Insert hand knob with 3/8" flat washer into antenna mast bracket assembly, see Figure 3.
Insert retaining ring into groove on hand knob under loop strap on antenna mast bracket, see Figure 4. Repeat following step for remaining hand knob.
-2-
Page 3
Universal Stadium Mounting Plate and Antenna Mast Bracket Assembly
CENTERLINE
MOUNTING HOLES
CENTERLINE
MOUNTING HOLES
Vertical
Mounting
Horizontal
Mounting
Hole alignment will be off center to right side. Hole alignment will be off center to left side.
MOUNTING HOLES
MOUNTING HOLES
U-clamps or lag screws may be used for permanent mounting
Figure 6
Mounting Holes
-3-
Page 4
Vertical
Horizontal
PRINTED IN U.S.A.. Copyright© 1997 by Telex TELEX COMMUNICATIONS, INC. All rights reserved July 1997
Table
Figure 7
Mounting Suggestions
-4-
Loading...