Telensa TBSA1 User Manual

Title:

User Manual for the BS-A US Basestation

Date:

14 Jun 2012

Document ref:

LLT289 02

COMMERCIAL IN CONFIDENCE

Telensa

Lighting Control

LLT289 02 14 Jun 2012 Page 1 of 7

QP4016 09- Tech Note Template

COMMERCIAL IN CONFIDENCE

Contents

OPERATIONAL SAFETY NOTICES ..................................................................................................................... 3

INSTALLER ................................................................................................................................................................ 3

RADIO TRANSMITTER - CAUTION .......................................................................................................................... 3

POWER SUPPLY CONNECTION ................................................................................................................................... 3

INTERNAL POWER SUPPLY ......................................................................................................................................... 3

FCC STATEMENT .................................................................................................................................................... 3

1 ACCESSORIES REQUIRED ........................................................................................................................... 4

2 INSTALLATION PROCEDURE .................................................................................................................... 4

3 BS-A SPECIFICATIONS ................................................................................................................................. 5

3.1 ELECTRICAL PARAMETERS: ......................................................................................................................... 5

3.2 ENVIRONMENTAL ........................................................................................................................................ 5

3.3 SAFETY COMPLIANCE .................................................................................................................................. 5

4 EQUIPMENT DESCRIPTION ................................................................ ................................ ........................ 6

5 CONTACT DETAILS ....................................................................................................................................... 7

LLT289 02 14 Jun 2012 Page 2 of 7

QP4016 09- Tech Note Template

COMMERCIAL IN CONFIDENCE

Operational Safety Notices

Installer

Installers must be suitably trained and qualified for electrical work, according to the laws and local codes
for the locality and country.

This unit must only be installed by personnel that have been trained by Telensa or their representatives to
carry out this work.

Radio Transmitter - CAUTION

The base station unit described in this guide emits radio frequency energy through its antenna. Although
the power level is low, concentrated energy from a directional antenna may pose a health hazard. Only
outdoor antennas certified with this transmitter should be used and must be installed to provide a
separation distance of at least 20.5cm (8 inches) from all persons who could be nearby when the base
station is operating.

Power Supply Connection

The supply voltage for the base station is hazardous and all necessary precautions must be taken to
ensure the safety of the installer, maintenance staff and any person that may come into contact with the
unit or its wiring.

The supply connection must be protected by an MCB or fuse, rated at 6A maximum
Supply connections must be made water and weatherproof against the weather conditions encountered at

the location area.

Internal power supply

Note that the operating voltages within the base station compartment are at 24V DC or below.

FCC Statement

This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Installers and end users must follow the specific installation and operating instructions for satisfying RF
exposure compliance. The antenna used with this transmitter must be maintained at least 20.5 cm (8
inches) from any person when the equipment is operating.

More information on RF exposure is available on the Internet at:

www.fcc.gov/oet/info/documents/bulletins.

This equipment is specifically designed to be used under Section 15.247 of the FCC Rules and
Regulations. Any unauthorised modification or changes to this device without the express approval of
Telensa Limited may void the user’s authority to operate this device.

Furthermore, this device is intended to be used only when installed in accordance with the instructions

outlined in this manual. Failure to comply with these instructions may also void the user’s authority to

operate this device.

LLT289 02 14 Jun 2012 Page 3 of 7

QP4016 09- Tech Note Template