Telenav Nextel Supported Devices User Manual

TeleNav™ Hardware Installation Guide

TeleNav Phone Mount
Attach the small rectangular metal plate to the back of the battery cover of your phone. Using a mild
cleaner like Windex, clean any dirt, or grime from the battery cover. Peel the protective paper from
the small rectangular metal plate. Press the metal plate onto the cover at the position shown:

Shape the mount so that it will place the phone
conveniently in front of your right shoulder. To reduce
sway, rest a bend in the mount on the dash of your
car. Peel the protective paper from the back of the
mount’s suction cup, flip the plastic lever away from
the suction cup, place the suction cup against the
glass, and then flip the lever toward the glass for
maximum suction. Park the phone against the felt
covered magnetic area. The i90c, i95cl, and i99cl
should ride high on the mount or the magnet will
trigger the cover closure sensor and the display will be
blanked. Orient the shelf so it is to the right of the
lighter phones, and on the bottom of heavier phones.

NOTICE:
rough road conditions or the impact associated with an automobile accident. Recognize these
limitations, and use the mount at your own risk.

Mobile Charging Cable
Open the protective plastic insert that conceals the connector at the bottom of the phone. Connect
the charging cable to the phone, and connect the other end to your vehicle’s cigar lighter socket.

This mount is not intended to retain the mobile phone, or to adhere to the windshield during

Copyright © 2003-5 TeleNav, Inc. TeleNav® is trademark of TeleNav, Inc.