Telematics Wireless RSC-900 User Manual

DRAFT

RSC-900

Road Side Communicator

User Manual

NOTE:

This equipment has been teste d and found to comply with t he limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio commu nica tions. Operation o f this equipme nt
in a residential area is likely to cause harmful interfere nce in whic h
case the us er will be required to correct the inte rfere nce at his own
expense.

DRAFT

DRAFT

Installation & Operation instructions

The RSC-900 should be installed by professional installers ONLY authorized ONLY by
the local distributor – the “

The RSC has to be installed on a horizontal pipe above the center of a road lane.

The pipe has to be 1.5” up to 2” in diameter, and its length has to be sufficient to locate the RSC
over the center of the lane. (The width of a standard lane is about 3.6m). For longer pipes and for
areas with extreme winds it is important to add additional supports (still cables, etc.) to prevent
bending of the pipe.

Operating Company”

Installation of RSC on the pipe

The unit has two U stretchers that are connecting the main plate to the horizontal pipe.

DRAFT