Telegesis TG-RouterE-PM-01-100 Product Manual
Telegesis
TG-RouterE-PM-01-100
1
Router-E
Product Manual
1.00
TG-RouterE-PM-01-100
Router-E Wireless Router
PRODUCT MANUAL
Telegesis
©2007 Telegesis (UK) Ltd Router-E Product Manual (Rev 1.00)
Telegesis
TG-RouterE-PM-01-100
2
Router-E
Product Manual
1.00
Table of Contents
1. INTRODUCTION..................................................................................................... 3
1.1. Installation Requirements ........................................................................................ 3
2. ABSOLUTE MAXIMUM RATINGS ......................................................................... 4
3. OPERATING CONDITIONS ................................................................................... 4
4. DEVICE INSTALLATION AND OPERATION ......................................................... 5
5. FIRMWARE CHANGES AND UPGRADES ................................ ............................ 5
6. SCHEMATICS ........................................................................................................ 5
7. ORDERING INFORMATION ................................................................................... 7
8. TRADEMARKS ...................................................................................................... 8
9. DISCLAIMER .......................................................................................................... 8
10. CONTACT INFORMATION .................................................................................... 8
11. REFERENCES ....................................................................................................... 8
©2007 Telegesis (UK) Ltd Router-E Product Manual (Rev 1.00)
Telegesis
TG-RouterE-PM-01-100
3
Router-E
Product Manual
1.00
1. Introduction
The Router-E wireless mesh networking router consists of a Telegesis ETRX2 module on a carrier
board together with power supply circuitry. It is ideally suited if an existing network of ETRX2’s
needs to be extended in order to bridge a greater distance between nodes and to form a more
reliable mesh network by extending the routing backbone.
The on-board SIF interface also allows the ETRX2AP to be used as a platform for firmware
development and debugging.
The Router-E also supports the use of Ember’s EZSP (Ember ZigBee® Serial Protocol) instead of
the Telegesis AT Command interface software.
1.1. Installation Requirements
5V-7V Power Supply (supplied separately)
Mains Socket
©2007 Telegesis (UK) Ltd Router-E Product Manual (Rev 1.00)
Loading...