Telegesis E, E-PA Product Manual

Telegesis TG-RouterE-PM-008-102
Router-E, Router-E-PA

Product Manual 1.02

©2009 Telegesis (UK) Ltd Router-E Product Manual (Rev 1.02)

Router-E and Router-E-PA Wireless Router

PRODUCT MANUAL

ROUTER-E

©2009 Telegesis (UK) Ltd - 2 - Router-E Product Manual (Rev 1.02)

Table of Contents

1. INTRODUCTION................................................................................................................... 3

1.1. Installation Requirements ..................................................................................................3

2. ABSOLUTE MAXIMUM RATINGS....................................................................................... 4

3. OPERATING CONDITIONS .................................................................................................4

4. DEVICE INSTALLATION AND OPERATION ...................................................................... 5

5. FIRMWARE CHANGES AND UPGRADES .........................................................................5

6. SCHEMATICS ...................................................................................................................... 5

7. ORDERING INFORMATION ................................................................................................ 7

8. TRADEMARKS..................................................................................................................... 8

9. DISCLAIMER........................................................................................................................ 8

10. CONTACT INFORMATION ..................................................................................................8

11. REFERENCES...................................................................................................................... 8

ROUTER-E

©2009 Telegesis (UK) Ltd - 3 - Router-E Product Manual (Rev 1.02)

1 Introduction

The Router-E wireless mesh networking router consists of a Telegesis ETRX2 module on a carrier
board together with power supply circuitry. It is ideally suited if an existing network of ETRX2’s
needs to be extended in order to bridge a greater distance between nodes and to form a more
reliable mesh network by extending the routing backbone.

The on-board SIF interface also allows the Router-E to be used as a platform for firmware
development and debugging.

The Router-E also supports the use of Ember’s EZSP (Ember ZigBee® Serial Protocol) instead of
the Telegesis AT Command interface software.

1.1 Installation Requirements

• 5V-7V Power Supply (supplied separately)

• Mains Socket