Telefunken TKP2177ST Service Manual

Telefunken
SERVICE MANUAL
TKP2177ST
1 Caution………………………………………………………………………2
3 BOM list………………………………………………………………………9
4 Alignment Procedure………………………………………………………25
5 Block Diagram………………………………………………………………34
6 Schematic Diagram…………………………………………………………35
7 PCB Layout…………………………………………………………………36
8 Explode Diagram……………………………………… …………………37
This manual is the latest at the time of printing, and does not include the modification which may be made after the printing, by the constant improvement of product
WARNING: TO REDUCE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lighting flash with arrowhead symbol, with an equilateral triangle is intended to alert the user to the presence of uninsulated voltage within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to the person.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
CAUTION:
Use of controls, adjustments or procedures other than those specified herein may result in hazardous radiation exposure.
CAUTION
RISK RISK OF OF ELECTRIELECTRICC
SHOCK SHOCK DO DO NOT NOT OPEN.OPEN.
2
dangerous
3
FOR YOUR PERSONAL SAFETY
1. When the power cord or plug is damaged or frayed, unplug this television set from the wall outlet and refer servicing to qualified service personnel.
2. Do not overload wall outlets and extension cords as this can result in fire or electric shock.
3. Do not allow anything to rest on or roll over the power cord, and do not place the TV where power cord is subject to traffic or abuse. This may result in a shock or fire hazard.
4. Do not attempt to service this television set yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
5. Never push objects of any kind into this television set through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a fire or electr ic shock. Never spill liquid of any kind on the television set.
6. If the television set has been dropped or the cabinet has been damaged, unplug this television set from the wall outlet and refer servicing to qualified service personnel.
7. If liquid has been spilled into the television set, unplug this television set from the wall outlet and refer servicing to qualified service personnel.
8. Do not subject your television set to impact of any kind. Be particularly careful not to damage the picture tube surface.
9. Unplug this television set from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
10.1. Do not place this television set on an unstable cart, stand, or table. The television set may fall, causing serious injury to a child or an adult, and serious damage to the appliance. Use only with a car t or stand recommended by the manufacturer, or sold with the television set. Wall or shelf mounting should follow the manufacturer s instructions, and should use a mounting kit approved by the manufacturer.
10.2. An appliance and car t combination should be moved with care. Quick stops , excessive force, and uneven surfaces may cause the appliance and cart combination to overturn.
CAUTION:
Read all of these instructions. Save these instructions for later use . Follo w all Warnings and Instructions marked on the audio equipment.
1. Read Instructions- All the safety and operating instructions should be read before the product is operated.
2. Retain Instructions- The safety and operating instructions should be retained for future reference.
3. Heed Warnings- All warnings on the product and in the operating instructions should be adhered to.
4. Follow Instructions- All operating and use instructions should be followed.
IMPORTANT SAFETY INSTRUCTIONS
4
PROTECTION AND LOCATION OF YOUR SET
11. Do not use this television set near water ... for example, near a bathtub, washbowl, kitchen sink, or laundry tub, in a
wet basement, or near a swimming pool, etc. Never expose the set to rain or water. If the set has been exposed to rain or water, unplug the set from the wall outlet and refer servicing to qualified service personnel.
12. Choose a place where light (artificial or sunlight) does not shine directly on the screen.
13. Avoid dusty places, since piling up of dust inside TV chassis may cause failure of the set when high humidity persists.
14. The set has slots, or openings in the cabinet for ventilation purposes, to provide reliable operation of the receiver, to protect it from overheating. These openings must not be blocked or covered.
Never cover the slots or openings with cloth or other material. Never block the bottom ventilation slots of the set by placing it on a bed, sofa, rug, etc. Never place the set near or over a radiator or heat register. Never place the set in enclosure, unless proper ventilation is provided.
PROTECTION AND LOCATION OF YOUR SET
15.1. If an outside antenna is connected to the television set, be sure the antenna system is grounded so as to provide some
protection against voltage surges and built up static charges, Section 810 of the National Electrical Code, NFPA No. 70-1975, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrode, and requirements for the grounding electrode.
15.2. Note to CATV system installer : (Only for the television set with CATV reception)
This reminder is provided to call the CATV system attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.
16. An outside antenna system should not be located in the vicinity of overhead power lines or other electric lights or power
circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.
17. For added protection for this television set during a lightning storm, or when it is left unattended and unused for long
periods of time, unplug it from the wall outlet and disconnect the antenna. This will prevent damage due to lightning and power-line surges.
ANTENNA LEAD- IN WIRE
ANTENNA DISCHARGE UNIT (NEC SECTION 810-20)
GROUNDING CONDUCTORS (NEC SECTION810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250. PART H)
ELECTRIC SERVICE
EQUIPMENT
GROUND CLAMP
NEC-NATIONAL ELECTRICAL CODE
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE
EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE INSTRUCTIONS
a built-in
installer s
OPERATION OF YOUR SET
18.
This television set should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply at your home, consult your television dealer or local power company. For television sets designed to operate from battery power, refer to the operating instructions.
19. If the television set does not operate normally by following the operating instructions, unplug this television set from the
wall outlet and refer servicing to qualified service personnel. Adjust only those controls that are covered in the operating instructions as improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the television set to normal operation.
20. When going on a holiday : If your television set is to remain unused for a period of time, for instance, when you go on
a holiday, turn the television set and unplug the television set from the wall outlet.
IF THE SET DOES NOT OPERATE PROPERLY
21. If you are unable to restore normal operation by following the detailed procedure in your operating instructions,
do not attempt any further adjustment. Unplug the set and call your dealer or service technician.
22. Whenever the television set is damaged or fails, or a distinct change in performance indicates a need for
service, unplug the set and have it checked by a professional service technician.
23. It is normal for some TV sets to make occasional snapping or popping sounds, particularly when being
turned on or off. If the snapping or popping is continuous or frequent, unplug the set and consult your dealer or service technician.
FOR SERVICE AND MODIFICATION
24. Do not use attachments not recommended by the television set manufacturer as they may cause hazards.
25. When replacement parts are required, be sure the service technician has used replacement parts specified
by the manufacturer that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards.
26. Upon completion of any ser vice or repairs to the television set, ask the service technician to perform
routine safety checks to determine that the television is in safe operating condition.
5
off
PFS2 FORMAT-1 Report
Date2004-6-3 15:49
ProductView......:
Report by............:
Specs / Products
MasterData Customer Id
JET LTDA(CHILE)
Version
1
Status Locked 12NC Brand
HYUNDAI
EAN
\
UPC
\
Rece
p
tion
+Tunin
g
- presets/channels
181, Full-Cable
+Tunin
g
- technolo
gy
PLL
+Tunin
g
- Indication
Full-Cable
+Fre
q
Bands
Freq
+Channels +IF Fre
q
45.75M
+TV S
y
stems Off Air/Cabl
e
NTSC-M, PAL MN
+Add S
y
stems Ext In
4.43 NTSC, 4.43PAL
+TV S
y
stems Multi
PAL NTSC
+Sound S
y
stems
AV STEREO
Picture - Processin
g
+Scan
Standard
+Scan Modes
4:3
+Wide Screen Switchin
g
+Combfilter +Picture Control
Brightness, Color, Contrast, Tint, Sharpness Con Var, Smart pict 4 modes
+Pict Enhancement
Blue Mute
+Pict Noise Reduction
Yes
Picture - Dis
play
+Display T
ype
+Screen Format +Size
(
Visual)" - size/vis. cm
21"
+Deflection S
y
stem (CRT onl
y)
+Tube Technology (CRT onl
y)
+CRT Defl +CRT Gun +CRT Ma
g
n field +Resolution +Coatin
g (
only for D.V. sets
)
+White Point Sound +Leaflet Power +RMS Power Intern
2X3W
+RMS Power Extern +Surround Sound ' +Sound Features
Mute, Smart sound(4 modes)
+Sound Control
Volume
Sound - S
p
eakers
+S
p
eaker configuration
2 speakers
+S
p
eakers used
+S
p
eaker Size User Interface +Interface Name
21189
+Voice Control +Menu
Cursor Control
+Menu Colours +Menu Lan
guag
es
Spanish, English
+Special Features
Favorite channel, Notebook, Biological,Calendar
+O
p
erational Features
+PP Features +Tuning/Install Features
Auto Cable/ Auto select. Auto channel Prog, Cable/Antenna select, Factory Mode, Language Selection, Service Mode
Product:
HU-TV2117
2004-6-3 16:13 1465 PFS 1 of 3
Date2004-6-3 15:49
ProductView......:
Report by............:
Specs / Products
Product:
HU-TV2117
+Clock/Timer Functions
sleep timer
+Local Controls Front
Channel +/-, Volume+/-, Mains(Tact Switch), Menu, TV/AV
+Local Controls To
p
+Indicators - screen +Indicators - front +Numb of Loc Cont
(
incl Mains
)
+Number of Ind. (incl Mains
)
+Local Controls (Old
)
Remote Control +Remote Control - sco
p
e
TV
+Remote Control - t
yp
e
Standard
+Remote Control - t
ypenr
RC115
+Remote Control - features Connectors Rea
r
+Scart RGB+Y/C+CVBS +Scart RGB+CVBS +Scart CVBS+Y/C +Com
p
onent In (Y/U/V) Cinch
+In Y/C+Cinch
(
CVBS+St
)
x
+In Y/C+Cinch
(
CVBS+Mo
)
+In Y/C+Cinch(St
)
+In BNC (CVBS
)
+In Cinch(CVBS+St
)
+In Cinch(CVBS+Mo
)
+Out Cinch(CVBS+St
)
x
+Out Cinch
(
CVBS+Mo
)
+Out Cinch Audio Stereo +Out Cinch Audio Mono +Out Cinch Dolb
y
Surround
+Di
g
Audio Out
+Louds
p
eakers +Control Busses +Feature Slot +ITV Smart Port +Terr. Antenna in
75 Ohms(F type)
Guide + IR Blaster Jack Connectors Fron
t
+In Cinch (CVBS + St
)
+In Cinch (CVBS+Mo
)
+Headphone Out
Connectors Side +In Y/C + Cinch
(
CVBS+St
)
+In Y/C + Cinch Stereo +In Cinch
(
CVBS + St
)
x
+IN Cinch
(
CVBS + Mo
)
+Headphone Out Connectors To
p
Connectors Mechanical St
y
lin
g
+Cabinet Name
21189
+Confi
g
uration
+Gra
p
hics/Logo's +Cabinet Colour and Finish +Mechanics +S
p
eaker Visibilit
y
General +Se
g
ment
+Chassis
M123A
+Software Deliver
y
Mode +Software Version +Mains Volta
g
e
110-240V
+Mains Fre
q
uenc
y
50 / 60 Hz
+T
yp
e Mains Cord
VDE
Power Consum
p
tion (P)TV in On
Power Consum
p
tion SB in Watts
less than 3W
Power Consum
p
tion Semi SB in W
+Power in "ON" for
2004-6-3 16:13 1465 PFS 2 of 3
Loading...
+ 14 hidden pages