Teledyne WaveJet Rackmount User Manual

WaveJet Rackmount Installation Instructions

Tools required:

1) Philips Screwdriver for M3 screws

2) Soft work surface

Instructions:

1) Place the WaveJet face down on a soft work surface.

2) Remove four M3 x 8 screws at location 1 as shown below.

3) Remove four M3 x 16 screws at location 2 as shown below.

4) Slide rear plastic case up and off of WaveJet.

5) Remove two rubber feet which are installed in the bottom of the front bezel.

6) Place rackmount plate overtop of exposed metal shield of WaveJet so that the

bent top and bottom of plate face towards the rear of the WaveJet.

7) Make sure that rackmount plate sits flush with the WaveJet front bezel (the lip

on the front bezel should fit inside the opening in the rackmount plate).

8) Replace the rear plastic cover onto the WaveJet and secure using the 4 screws

removed in steps 2 & 3 above.

915558-00 Rev A