Teledyne AC012XXA-X User Manual

Small Rackmount Accessory Kit

AC012XXA-X

Installation Guide

1

Introduction

This manual describes the procedures to retrofit Sierra M6-2, SierraFC M8-4, and
Voyager M3i systems for rack mounting at your site.

The rack mount kit included is for securing the any of the systems mentioned above
in an EIA 310-D 19-inch equipment rack.

Two L brackets, which are attached (as shown in this document) to the front or back
of the Hamilton chassis, connect the chassis to the mounting posts of the rack.

Some racks provide a power strip along the length of one of the rear posts. If your
rack has this feature, consider the position of the strip when planning fastener
points, and before you install the L brackets on the chassis, determine whether you
will install the chassis from the front or the rear of the rack.

2

Rack Mount Kit Components

The kit includes the following components:

Quantity Part Description

2 L Brackets

1 9/64 Allen Key

4 10-32 x 0.5 Screws

(for securing the
system chassis to the
rack)

1 x Allen Key

4 x Screws 2 x L Brackets

You will also need the
following additional tools:

• Tape Measure

• Level

• Phillips Screwdriver