Tektronix WFM6100, WFM7100, WFM7000, WFM70UP FP, WFM61UP FP Instructions Manual

Instructions

WFM61UP FP, WFM70UP FP, and WFM71UP FP
Front Panel Upgrade
WFM6100, WFM7000, and WFM7100
Waveform Monitors

075-0948-00

Warning

The servicing instructions are for use by qualified
personnel only. To avoid personal injury, do not
perform any servicing unless you are qualified to
do so. Refer to all safety summaries prior to
performing service.

www.tektronix.com

*P075094800*

075094800

Copyright © Tektronix. All rights reserved. Licensed software products are owned by Tektronix or its subsidiaries or
suppliers, and are protected by national copyright laws and international treaty provisions.

Tektronix products are covered by U.S. and foreign patents, issued and pending. Information in this publication supercedes
that in all previously published material. Specifications and price change privileges reserved.

TEKTRONIX and TEK are registered trademarks of Tektronix, Inc.

Contacting Tektronix

Tektronix, Inc.
14200 SW Karl Braun Drive
P.O. Box 500
Beaverton, OR 97077
USA

For product information, sales, service, and technical support:

H In North America, call 1-800-833-9200.

H Worldwide, visit www.tektronix.com to find contacts in your area.

Service Safety Summary

Only qualified personnel should perform service procedures. Read this Service
Safety Summary before performing any service procedures.

Do Not Service Alone. Do not perform internal service or adjustments of this
product unless another person capable of rendering first aid and resuscitation is
present.

Disconnect Power. To avoid electric shock, switch off the instrument power, then
disconnect the power cord from the mains power.

Use Care When Servicing With Power On. Dangerous voltages or currents may
exist in this product. Disconnect power, remove battery (if applicable), and
disconnect test leads before removing protective panels, soldering, or replacing
components.

To avoid electric shock, do not touch exposed connections.

WFM61UP FP, WFM70UP FP, and WFM71UP

1

Service Safety Summary

2

WFM61UP FP, WFM70UP FP, and WFM71UP

Kit Description

This document describes replacing the waveform monitor front panel with the
new, upgraded front panel. One very obvious change is the number of buttons on
the front panel; there are many more buttons on the new front panel. This is
necessary because the new front panel does not employ a touch-screen interface;
all control is through the front panel buttons. Among other things, this change
provides a noticeable improvement in instrument front panel response.

Products

WFM6100 All
WFM7000 All
WFM7100 All

Minimum Tool and Equipment List

Required tools and equipment Part number

PC with USB port -- -- -- -- -- -- -- -- -- --

Kit Parts List

Network connection ------ -- -- ------ -- --

Torque screwdriver handle Standard tool

T-10 TORX bit Standard tool

Quantity Part number Description

1Each 614--1044--xx FRONT PANEL ASSY

1 Each 063--4072--xx USB FLASH DRIVE, PROGRAMMED

1Each NS OPTION KEY LABEL

1 Each 075--0948--00 UPGRADE KIT INSTRUCTIONS (THIS DOCUMENT)

1Each NS IMPORTANT DOCUMENTS ENVELOPE

1Each 071-2191-01 MANUAL, TECH; SVCPT--UPG; TEKTRONIX SUPPLE-

MENTAL INFORMATION SHEET FOR THE PEOPLES
REPUBLIC OF CHINA; CHINA ROHS

NS - Not Saleable

WFM61UP FP, WFM70UP FP, and WFM71UP

3

Kit Description

4

WFM61UP FP, WFM70UP FP, and WFM71UP