xx
TDS5000B Series
050-3708-00
ZZZ
SATA Hard Disk Drive Replacement Kit
Instructions
www.tektronix.com
P075099100*
*
075-0991-00
Copyright © Tektronix. All rights reserved. Licensed software products are owned by Tektronix or its subsidiaries
or suppliers, and are protected by national copyright laws and international treaty provisions.
Tektronix products are covered by U.S. and foreign patents, issued and pending. Information in this publication
supersedes that in all previously published material. Specifications and price change privileges reserve d.
TEKTRONIX and TEK are registered trademarks of Tektronix, Inc.
Contacting Tektronix
Tektronix, Inc.
14200 SW Karl Braun Drive
P.O. B o x 5 0 0
Beaverto
USA
For product information, sales, service, and technical support:
n, OR 97077
In North America, call 1-800-833-9200.
Worl dwid e, vis i t www.tektronix.com to find contacts in your area.
Table of Contents
Service Safety Summary.................................... ................................ ....................... 1
Kit Description....................................... .................................. ............................. 2
Products...................................... ................................ ................................ ... 2
Kit Parts Li
Installation Instructions ............................................................................................ 3
Preparation........................... ................................ ................................ ........... 3
Remove the External Modules ............................................................................... 3
Install the SATA Hard Disk Drive ........................................................................... 5
st ...... ................................ .................................. ........................... 2
TDS5000B Series Hard Disk Drive Replacement Kit i
Table of Contents
ii TDS5000B Series Hard Disk Drive Replacement Kit
Service Safety Summary
Only qualified personnel should perform service procedures. Read the Service
Safety Summary and the General Safety Summary located in the service manual
before perfo
Do Not Service Alone. Do not perform internal service or adjustments of this
product unless another person capable of rendering first aid and resuscitation is
present.
rming any service p rocedures.
Disconnec
disconnect the power cord from the mains power.
UseCareWhenServicingWithPowerOn. Dangerousvoltagesorcurrentsmay
exist in this product. Disconnect power, remove battery (if applicable), and
disconnect test leads before removing protective panels, soldering, or replacing
compon
To avoid electric shock, do not touch exposed connections.
tPower. To avoid electric shock, switch off the instrument power, then
ents.
TDS5000B Series Hard Disk Drive Replacement Kit 1
Kit Description
Kit Description
Products
This kit describes the installation of the SATA Hard Disk Drive in a TDS5000B
Series Oscilloscope.
TDS5034B. SN B062881 and Below
TDS5054B. SN B065251 and Below
TDS5104B. SN B065251 and Below
TLA5201B. SN B050466 and Below
TLA5202B. SN B050607 and Below
Kit Parts List
TLA5203B. SN B050262 and Below
TLA5204B. SN B050485 and Below
Quantity Part number Description
1 ea 119-
1 ea 174-5273-XX
1 ea 174
1 ea 075-0991-00
7524-XX
-5639-XX
DISK DRIVE, HARD; 3.5 INCH, 7200 RPM,
SATA II 3.0 GB/S INTERFACE;, SAFETY
ROLLED
CONT
LE ASSY; HARD DISK DATA CABLE,
CAB
SATA, STRAIGHT, 0.5M LONG
CABLE ASSY MOLEX TO SATA POWER
ADAPTER
INSTRUCTIONS FOR 050-3708-xx
EPLACEMENT KIT
R
2 TDS5000B Series Hard Disk Drive Replacement Kit
Installation Instructions
Use the following instructions and the procedures in the TDS5000B Series
Service manual (071-1362-XX) to remove the existing hard disk drive and install
the SATA hard
Preparation
Installation Instructions
disk drive.
Before inst
the Removal and Installation Procedures section of the service manual.
Minimum Tool and
Equipmen
tList
For a list of required tools, refer to the Removal and Installation Procedures
section i
Remove the External Modules
Remove t
Installation Procedures sectionintheservicemanual:
Line Co
Trim
Right Cover
Printer Frame (if installed)
Remove Internal Modules
NOTE. Complete the removal of the external modules before removing the
following internal modules.
alling the SATA hard disk drive, follow the Preparation instructions in
n the service manual.
he following external module parts. Refer to the Removal and
rd
Remove the following internal modules. For removal instructions, refer to the
Procedures for Modules in the TDS5000B Series service manual:
Floppy Disk Drive (to allow better visibility)
Hard Disk
TDS5000B Series Hard Disk Drive Replacement Kit 3
Drive
Installation Instructions
PATA Hard Disk D
hard disk drive.
Disconnect th
allow better clearance when connecting the SATA cable to the Mother board.
Figure 1: Cables J1030 and J1040 locations
Discard the unused PATA cable.
rives. Perform these additional tasks before installing the SATA
e two cables from J1030 and J1040 on the PC Interface board to
Figure 2: PATA Hard Disk Drive
4 TDS5000B Series Hard Disk Drive Replacement Kit
Installation Instructions
Install the SA
TA Hard Disk Drive
1. Attach the SATA Hard Disk Drive cable and Molex-to-SATA adapter cable to
the connectors on the SATA Hard Disk Drive as shown.
Figure 3: SATA hard disk drive, existing bracket, and MOLEX-to-SATA power adapter
2. Attach the existing hard disk drive bracket to the SATA hard disk drive using
wo existing T-15 TORX drive screws.
the t
3. Connect the other ends of the two cables (See Figure 3 on page 5.):
Red SATA cable to the SATA Port 1 connector on the Mother board
Molex-to-SATA adapter cable to the P3 power cable connector
TDS5000B Series Hard Disk Drive Replacement Kit 5
Installation Instructions
Figure 4:
SATA cable location
Figure 5: SATA hard disk drive installed
4. Attach the hard disk d rive to the chassis as shown using the two existing
T-15 screws .
6 TDS5000B Series Hard Disk Drive Replacement Kit
Installation Instructions
PATA Hard Disk Drive Only
Reinstall the External and
Internal Mod
ules
Reconnect the t
page 4, PATA Hard Disk Drives.)
Refer to the service manual to reinstall the external and internal modules that
were removed
wo cables to J1030 and J1040 on the PC Interface board. (See
.
TDS5000B Series Hard Disk Drive Replacement Kit 7
Loading...