Teka TFL7D35 User Manual

Contents

Safety Precautions

Safety Precautions .................................................................................

Overview of Washer dryer Machine .........................................................

Washer dryer

Install Machine ..................................................................

Operate Machine ..............................................................

Checklist and Preparation before Washing Clothes ..............................

View of Control Panel...........................................................................

..........................................................................

Table of Washing and drying Procedures .............................................

Maintenance ..........................................................................................

................

Remove the problems .......................................................................

Appendix ..............................................................................................

Care Label.........................................................................................

Product Specifications .......................................................................

Washer dryer

Select the procedure

Cleaning and Maintenance of Washer dryer Machine Cabinet

Troubleshooting.................................................................................

Safety Precautions

- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

- The new hose-sets supplied with the appliance are to be used and that old hose-sets should not be reused.

- This washer dryer machine is for indoor use only.

- The ventilation openings must not be obstructed by a carpet.

- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capab

-ilities,or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

- Pull out its plug from the power socket before cleaning or maintenance.

- Make sure that all pockets are emptied.

- Sharp and rigid items such as coin, brooch, nail, screw or stone etc. may cause serious damages to this machine.

- Pull out its plug and cut off water supply after the operation.

- Please check whether the water inside the drum has been drained before opening its door. Please do not open the door if there is any water visible,

- Pets and kids may climb into the machine.Check the machine before every operation.

- Glass door may be very hot during the operation.Keep kids and pets far away from the machine during the operation.

- Take care that power voltage and frequency shall be identical to those of washer dryer machine.

- Do not use any socket with rated current less than that of

P.02

P.03

Safety Precautions

- Do not use any socket with rated current less than that of washer dryer machine.Never pull out power plug with wet hand.

- To ensure your safety, power cord plug must be inserted into an earthed three-pole socket. Check carefully and make sure that your socket is properly and reliably earthed.

- Children of less than 3 years should be kept away unless continously supervised.

- Kids should be supervised to ensure that they do not play with the machine.

- Packing materials may be dangerous to the kids. Please keep all packing materials (plastic bags, foams etc) far away from the kids.

- Washer dryer machine shall not be installed in bath room or very wet rooms as well as in the rooms with explosive or caustic gases.

- Make sure that the water and electrical devices must be connected by a qualified technician in accordance with the manufacturer's instructions and local safety regulations.

- Before operating this machine, all packages and transport bolts must be removed.Otherwise,the washer dryer machine may be seriously damaged while washing the clothes.

- Before washing the clothes at first time, the washer dryer machine shall be operated in one round of the whole procedures without the clothes inside.

- The machine with single inlet valve only can be connected to the cold water supply. The

washer dryer

machine with double inlet valves can be connected to the hot water and cold water supply.

- Your washer dryer machine is only for home use and is only designed for the textiles suitable for machine washing.

- Flammable and explosive or toxic solvents are forbidden.

P.04

Gasoline and alcohol etc. shall not be used as detergents. Please only select the detergents suitable for machine washing, especially for drum.

- It is forbidden to wash carpets.

- Be careful of burning when washing machine drains hot washing water.

- Never refill the water by hand during washing.

- After the program is completed,please wait for two minutes to open the door.

- Please remember to disconnect water and power supply immediately after the clothes are washed.

- Do not climb up and sit on top cover of the machine.

- Do not lean against machine door.

- Please do not close the door with excessive forces.If it is found difficult to close the door,please check if the excessive clothes are put in or distributed well.

- Cautions during Handling Machine

1.Transport bolts shall be reinstalled to the machine by a specialized person.

2.The accumulated water shall be drained out of the machine.

3. Handle the machine carefully. Never hold each protruded part on the machine while lifting. Machine door can not be used as the handle during the conveyance.

4. That the hands shall not be inserted into running water

-extracting tub.

- The washer dryer is not to be used if industrial chemicals have been used for cleaning.

- Oil-affected items can ignite spontaneously, especially when exposed to heat sources such as in a tumble dryer. The items become warm, causing an oxidation reaction in the oil. Oxidation creates heat. If the heat cannot escape,

P.05

Safety Precautions

the items can become hot enough to catch fire. Piling, stacking or storing oil-affected items can prevent heat from escaping and so create a fire hazard.

- If it is unavoidable that fabrics that contain vegetable or cooking oil or have been contaminated by hair care products. be placed in a tumble dryer they should first be washed in hot water with extra detergent - this will reduce, but not eliminate, the hazard.

- Adequate ventilation has to be provided to avoid the back flow of gases into the room from appliances burning other fuels, including open fires.

- Do not dry unwashed items in the washer dryer.

- Items that have been soiled with substances such as cooking oil, acetone, alcohol, petrol, kerosene, spot removers, turpentine,waxes and wax removers should be washed in hot with an extra amount of detergent before being dried in the washer dryer.

- Items such as foam rubber (latex foam), shower caps,water proof textiles, rubber backed articles and clothes or pillows fitted with foam rubber pads should not be dried in the washer dryer.

- Fabric softeners, or similar products, should be used as specified by the fabric softener instructions.

- The final part of a washer dryer cycle occurs without heat (cool down cycle) to ensure that the items are left at a temperature that ensures that the items will not be damaged.

- Remove all objects from pockets such as lighters and matches before use the appliance.

- WARNING: Never stop a washer dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated.

P.06

Safety Precautions

- The openings must not be obstructed by a carpet.

- The exhaust air must not be discharged into a flue which is for exhausting fumes from appliances burning gas or other fuels.

- The appliance must not be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side to that of the washer dryer.

- The washer dryer shall not beinstalled at a humid place.

- The household washer dryer isn't intended to be built-in.

- The washer dryer whose lid can be opended during water

extraction,that it takes 15s or more for complete stop of water extracting chamber tub.

P.07

Overview of Washing Machine

Install Washer Dryer Machine

Component

Detergent Drawer

Door

Service Panel

Detergent Box

Accessories

Transport

plughole

H plug ( )

ole

optional

Inlet pipe C

Inlet pipe H (optional)

Control Panel

Power Plug

Outlet Hose

Outlet hose (optionalsupport )

Unpacking the washer dryer machine

Unpack your washer dr yer machine and check if there is any damage duri ng the transportation. Also make sure that all t he items (as shown in Page 5) in the attached bag are received. If there is any damage to t he machine during the tr ansportation, or any item is missing, please con tact the local dealer immediately.

Dispose the packing materials The packing materia ls of this machine may be dangerous to kids. Plea se dispose them properly and avoid ea sy touch by kids. Please dispose the related pa cking materials according to the rele vant local regulations. Please do no throw the packing materials away together with th e other daily living rubbishes.

Remove transport bolts Before using this machine, transport bolts

must be removed from th e backside of this machine. Pleas e take the following steps to remove the bolts:

1.Loosen all bolts wit h spanner and then remove them.

2.Stop the holes with tr ansport hole plugs.

3.Keep the transport b olts properly for future use. Select the location

Before installing t he machine, the locati on characterized as follows shall be selected:

- Rigid, dry, and level surface (if not level, please make i t level with reference to the following figure “A djust Leg”)

- Avoid dir ect sunlight

- Suffic ient ventilation

- Room temperature is a bove 0 C

- Keep far away from the he at resources such as coal or gas. Make sure that the machine will not stan d on power cord. Do not install the wash ing machine on the carpet floor.

Adjust Leg

1.When positioning t he machine, please first check if the legs a re closely attached to the cabinet. If not, plea se turn them to their original positions with hand o r spanner and tighten the nuts with spanner.

2.After positionin g the machine,

press washer dryer

four corners on top cov er of

machine

in sequence. If the was hing machine

is not

stable when being pre ssed, this leg shall be adjusted.

washer dryer

P.08

P.09

Install MachineWasher Dryer

Install Machine Washer Dryer

3.Ensure the positio ning status of washer dryer machine. Loosen the lock nut with spanner and turn the leg with han d until it closely contacts with the floor. Pres s the leg with one hand and fasten the nut c losely to the cabinet with the other hand.

4.After being locked p roperly, press four corners again to make sure that they has been adjusted properly. If it is still unstable, it has to repe at Steps 2 and 3.

5.Put a solid cylinder (e.g. pop cans) oppositely on the top cover of the machine from in washer dryer

the left, right, front and back directions. If the cylinder keeps stable, the machine is positioned level. If it rolls, the machine is positioned unlevel. The rolling direction is the

washer dryer

direction of lower ground surface.Then, the two legs in this direction shall be raised at the same time until the machine is level. Steps 1~3 are repeated to make the bottom legs closely the ground and the nuts shall be locked tightly.

washer dryer

against

Connect inlet pipe Connect the inlet pip e as indicated in the figure. For the model which has h ot valve , please connect the hot vale to hot water t ap. Energy will decrease automatically for s ome program.

Install inlet pipe

1.Connect the elbow to t ap and fasten it

clockwise.

2.Connect the other en d of inlet pipe to the inlet

valve at the backside o f washing machine and fasten the pipe tight ly clockwise.

Notes: after connec tion, if there is any leakage with hose, then repea t the steps to connect inlet pipe. Th e most common type of tap shall be used to supply water. If t ap is square or too big, then standard tap sha ll be changed.

Place outlet hose There ar e two ways to place the end of outlet hose:

1.Put it beside the wate r trough.

P.10

2.Connect it to the bran ch drain pipe of the trough.

Max .100c m

Min .60cm

Position outlet hose properly so that the floor will not be dam aged by wat er leakag e. Notes: If the machine has outlet hose support, please ins tall it lik e the follo wing pict ures.

Trough

Hos e Retai ner

Bin d

- When installing outlet hose, fix it properly with a rope.

- Position outlet hose properly so that the floor will not be damaged by water leakage.

Max .100c m Min .60cm

- If outlet hose is too long, do not force it into washer dryer machine as it will cause abnormal noises.

Max .100c m

Min .60cm

Max .100c m

Electrical Connection

- As the maximum current t hrough the unit is 10A when you are using its heatin g function, please make sure the po wer supply system (current, power voltage a nd wire) at your home can meet the norma l loading requirements of the electrical ap pliances.

- Please connect the po wer to a socket which is correctly installed an d properly earthed.

- Make sure the power vol tage at your place is same to that in the machine's r ating label.

- Power plug must match t he socket and cabinet must be properly and effectively earthed.

- Do not use multi-purp ose plug or socket as extension cord.

- Do not connect and pull o ut plug with wet hand.

- When connecting and p ulling out the plug, hold the plug tightly and then pull it out. Do not pull power cord for cibly.

- If power cord is damage d or has any sign of being broken, special power co rd must be selected or purchas ed from its manufacturer or service center fo r replacement.

P.11

+ 12 hidden pages