Teenage Engineering PO-20 Arcade User manual

PO-20 arcade
manual

ユー ザ ーズ マニ ュア ル

selected

tempo

play / rec mode

indicates write
mode is active

break away
hanger

time / note /
additional info

sound
parameters A / B

sound

to select sound hold

sound and press 1-16

alarm

pattern

to select pattern hold

pattern and press 1-16

bpm

press to select tempo

m

hold to set master volume 1-16

hold step 1-16 + m

to set multiplier

sound 1-16

chord 1-16

eect 1-16

the unit auto powers o when no buttons are pressed

for a while, only powering the display to show time.

press sound + bpm to show battery status. press sound + write

to manually power o. this ensures that recent modifications

to pattern data will survive a loss of power.

auto power o (a.p.o.)

folding stand

knob A / B

A: parameter 1 B: parameter 2
A: swing B: tempo
A: drone level B: sidechain

chord control

eects

to toggle eects hold FX
and press 1-16

play / stop

write

sound 1-16

1. bass

2. bass drum

3. snare drum

4. hi-hat

5. tom

6. blip

7. hardsync

8. noise fx

9. arpeggio

10. melodic arp

11. falling arp

12. octave arp

13. lead

14. vibrato

15. portamento

16. echo

chord 1-16

1. dm

2. em

3. Esus

4. E

5. F

6. G

7. C/G

8. E/G#

9. am

10. C/A

11. dm/A

12. D/A

13. A

14. B/A

15. C

16. D

eect 1-16

1. solo chords

2. solo chords + lead

3. solo drums

4. solo drums + bass

5. lowpass slow sweep

6. lowpass fast sweep

7. highpass filter

8. highpass sweep

9. fill-in

10. fill-in (fast)

11. retrigger

12. retrigger (fast)

13. glitch

14. glitch (fast)

15. blinds

16. rising arpeggio

1. getting started

power-up

insert two fresh AAA batteries.
pay attention to plus and minus
terminals.

set clock

set time by turning knob A for
hours and knob B for minutes.
press any key to confirm and exit.

alarm clock

press sound + pattern. set alarm
clock by turning A for hours and B
for minutes. (disable by turning
knob A all the way down.) press
any key 1-16 to set pattern for the
alarm. to stop alarm press any key.

reset clock

reset the clock by removing the
batteries and start over.

2. play

select pattern

hold pattern and press any key
from 1-16 to select pattern.
blinking led indicates active
pattern.

play

press play to start playing.
press play again to stop.

sequencer

a pattern consists of 16 steps.

3. creating a pattern

select sound

hold sound and press any key
from 1-16 to select sound.

create

press write. rec symbol is lit on
screen. enter sound/notes in grid.
active steps will be lit. press play
to listen to your pattern.

parameter locking

during play, hold write while
turning knobs to write sound
parameter changes over time.
hold any key 1-16 and turn knobs
to edit sound paramaters on that
particular step. for most sounds,
parameter 1 controls the pitch and
parameter 2 controls the waveform.

4. chords

hold chord and press any key 1-16
to select chord. see reference on
opposite page. during play, the
change takes eect at the next
pattern boundary.

hold chord and press a sequence
of keys 1-16 to create a chain of
up to 128 chords. one chord can

be selected multiple times.
example: 9, 9, 9, 16 plays chord 9
for a duration of three patterns,
then moves on to chord 16. the
entire sequence then repeats.

5. live eects

hold fx and press any key 1-16
to toggle eects. see reference on
opposite page. some eects are
mutually exclusive. fill-in, retrigger
and glitch eects last until the next
pattern boundary. the solo eects
can be pre-activated while the
sequencer is stopped.

drone

hold chord while turning knobs to
control drone playback of the
current chord.

fade out

during playback, press fx + play to
fade out and stop the sequencer.

6. tempo and swing

press bpm to switch tempo. the
bpm will be displayed in the upper
right corner of the screen.
HIP HOP (80 bpm)
DISCO (120 bpm)
TECHNO (140 bpm)
hold bpm and turn A to adjust
the swing. hold bpm and turn B to
fine-tune tempo from 60 to 240 bpm.

7. volume

hold bpm and press any key 1-16
to adjust master volume. at volume
levels 9-16, the filters can be driven
into distortion.

8. live record

while playing, except in write
mode, hold write and press any
key 1-16 to punch in notes.
notes will be quantized according
to the current swing setting.

9. step multiplier

in write mode, press and hold any
key 1-16 to select step, and press
bpm to insert a re-trig on that step.
press bpm multiple times to switch
between 2, 3, 4, 6 or 8 multiplier.

10. making a song

(pattern chaining)

copy pattern

while holding pattern, press write
followed by any key 1-16 to paste
the active pattern to the
corresponding new slot.

clear pattern

hold chord and press pattern to
clear the active pattern.

chain pattern

hold pattern and press a sequence
of keys 1-16 to create a chain of
up to 128 patterns. one pattern
can be selected multiple times.
example: 1, 1, 1, 4 plays pattern 1
three times then moves on to pattern

4. the entire sequence then repeats.

11. sync multiple units

connect a standard stereo audio
cable between the units. the
master unit will control the tempo
of the slave unit. hold chord and
press bpm on master unit to
toggle sync modes. press
repeatedly to toggle between
dierent modes displayed in the
upper right corner of the screen.
press play on slave unit to wait for
master clock sync. press play on
master to start.

sync modes

there are 5 sync modes. default
mode is SY0.
when sync is used the signal will
be split between audio (right) and
sync (left).

sync scenarios

example A

chain: PO-20 PO-12 PO-14
setting: SY1 SY5 SY4

example B

chain: external PO-20
setting: volca SY2
iphone
computer
synckontrol

example C

chain: ext. PO-20 PO-16
setting: SY3 SY4

example D

chain: PO-20 ext. (split cable)
setting: SY1

disclaimer

although teenage engineering will use all reasonable
endeavours to ensure the accuracy and reliability of
this product, neither teenage engineering nor any
third party supplier will be liable for any loss or
damage in connection with the sale or use of the
product except for: a) personal injury caused by our
negligence or that of our employees or agents when
acting in the course of their employment with
ourselves and; b) any other direct loss or damage
caused by our gross negligence or wilful
misconduct.

ALL EXPRESS OR IMPLIED CONDITIONS,
WARRANTIES OR UNDERTAKINGS (OTHER THAN
CONDITIONS, WARRANTIES OR UNDERTAKINGS
EXPRESSLY STATED, OR IMPLIED BY STATUTE
AND WHICH CANNOT BE EXCLUDED), WHETHER
ORAL OR IN WRITING, INCLUDING WARRANTIES
AS TO SATISFACTORY QUALITY AND FITNESS FOR
A PARTICULAR PURPOSE, ARE EXCLUDED.

©2016 teenage engineering ab.
all rights reserved.