Techne PS139 User Manual

Description

Part code

Quantity

Description

Part code

Quantity

PS139

Fitting stacking plates and wall plates on a Hybrigene

A trained technician should carry out this work only after reading the full instructions.

There are two kits available for stacking and wall fixing either two or three Hybrigene units:

FHB4DSTK: Stacking and wall mounting kit for two units

Wall Bracket 6105214 1
M4 x 8 Pozi Pan Screw 6008652 9
M4 Crinkle Washers 6008639 9
Thumbscrew 6009552 1
Wall Plate 6105213 1
Stacking Plate 6105212 1

FHB4DKIT: Stacking and wall mounting kit for three units

Wall Bracket 6105214 1
M4 x 8 Pozi Pan Screw 6008652 15
M4 Crinkle Washers 6008639 15
Thumbscrew 6009552 1
Wall Plate 6105213 1
Stacking Plate 6105212 2

Fixing Procedure for two Hybrigenes

1. Ensure the units are turned off and remove the power to them.

2. Place one unit on the top of the other.

3. The stacking plate has three holes and three slots. It has three slots to allow for the
adjustment of the feet for levelling the units.

4. Use three of the screws to attach the plate to the bottom of the top unit.

5. Use another three screws to attach the plate to the bottom hybridiser.

6. Ensure that the units are level and the screws are tight.

Page 1 of 3

PS139 Issue 4 07/2014

Fixing the stacking plate

7. For safety it is recommended that the top unit is fixed to a wall to prevent toppling. Use the
final three screws to attach the wall bracket to the top of the top unit. Ensure that the screws
are tight.

8. Put the hybridisers in the position you want to use them.

9. Position the wall plate and mark the position of the holes.

10. Use the appropriate screws and fixings to attach the wall plate to the wall; ensure that the
screws are tight.

Wall plate

Wall bracket

Hybrigene with wall bracket attached

11. Re-position the hybridisers placing the wall bracket over the wall plate.

12. Use the thumb-screw to attach the wall bracket to the wall plate.

Wall fixings

Fixing Procedure for three Hybrigenes

If you have three units, repeat the above process attaching a stacking plate between each pair of
units.

Page 2 of 3

PS139 Issue 4 07/2014