Teasi Smart T Power Quick Start Guide

Quick start guide

Intended use:

smarT.power is a universal charging device for charging (in absence of other charging
options) your mobile phone, your TEASI-navigation system or other devices with a 5V
(USB) charging capability while you are out and about. Depending on the battery capacity
of the device to be charged, it may even be possible to charge or recharge it several
times.

smarT.power is also equipped with a high-power LED spotlight, as well as mechanical
connectors for the universal HR 4 Quick Fix System (shortened to 4QF below), which is
the most widely used system in the mobile and outdoor sector and therefore offers you
the most universal connection options.

This means that smarT.power can be securely attached onto your bicycle handlebars
with the same bike mount system as TEASI. The other side of the mount can then hold
your TEASI or your mobile phone case. The road in front of you is well-lit by the powerful
spotlight.

smarT.power is dustproof and waterproof in accordance with standard IP65, which
means that smarT.power can be used outdoors, even in heavy rain, for example. Please
follow the instructions on this subject later in this guide!

Connecting and control elements:

(1) LED spotlight

(2) Connector for HR 4QF mount

(3) Switch for LED spotlight

(4) ON / OFF switch for charging function

(5) Adapter port for external devices

(6) Battery status indicator

(7) HR 4QF mount for external devices

(8) Charging input with rubber cap

Below we simply refer to external devices that are to be charged as “receivers”, as they
receive the charging voltage and current from the “donor” smarT.power.

Basic operation:

(4) Charging the receiver (e.g. smartphone or TEASI):

Press the ON / OFF switch (4) 1x: smarT.power starts to charge the receiver
Pressing the ON / OFF switch (4) again stops the charging process.

(3) Spotlight functions:

Press 1x: switches on LED spotlight: while light, full power
Press 2x: white LED, approx. half strength
Press 3x: red light
Press 4x: switches off LED spotlight

If the switch (3) is not pressed again within 5 seconds to change to the next LED mode,
the next time the switch (3) is pressed, all LED functions are switched off immediately.

(6) Battery status indicator:

This three-colour LED indicator shows the status using 3 colours, red, yellow and green:

1. smarT.power is operational

i.e. smarT.power is operating as a donor. A receiver is being charged or the LED spot-
light is switched on.

Rapidly flickering red light: less than 5% charge remaining

WARNING! Please switch off the smarT.power device immediately to prevent a deep
discharge of the built-in battery!

Note: Even a single deep discharge could permanently damage the built-in lithium bat­tery! This type of damage is not covered by the warranty.

Continuous red light: 16%-30% residual charge. smarT.power should be recharged soon.
Continuous orange light: 31%-50% residual charge
Continuous green light: 51-100% residual charge