Teac DV-TV5100 Owner's Manual
TV/DVD COMBO
DV-TV5100
DV-TV5100
WARRANTY REGISTRATION
Keep your purchase receipt to enable you to proceed quickly in the event of a Warranty Service.
Please read this warranty card.
Warranty Terms & Conditions
1. TEAC warrants to the original retail purchaser only, that this product is free from defects in material and
workmanship under normal domestic use and authorises free service during the warranty period at any
TEAC Authorised Centre only. TEAC warranty only applies to products purchased, used and serviced in
Australia.
2. Subject to the terms herein, this warranty effectively covers the equipment as specified in the Warranty
Periods Table from the date of purchase.
3. All parts, except the external cabinet, are warranted as specified in Warranty Periods Table, and will be
repaired or replaced at the sole judgement of TEAC.
4. Normal customer maintenance as described in the owner’s manual is not covered by this warranty (such as
cleaning VCR heads etc.)
5. This warranty does not apply to equipment showing abuse, damage or that it may have been tampered
with, altered or repaired outside any TEAC Authorised Service Centre. If so, the warranty will be void.
*Your nearest Authorised TEAC Service Centre is listed in your Owners Manual
6. In the event that this unit or any defective parts must be returned to TEAC Service Centres, a copy of this
warranty certificate and of your purchase receipt must be enclosed to be a valid warranty. Such
equipment or parts must be sent to the nearest authorised TEAC Service Centre. After the repair, the unit
will be available for collection by the owner or it will be returned to the owner. The warranty does not
cover freight or insurance. In all cases of in-transit damages or loss, a claim must be filed against the
carrier by the purchaser.
7. In home service will only be provided as part of this warranty if all the following conditions are met;
8. No one is authorised to assume any liability on behalf of TEAC or impose any obligation on it, in
9. In no event will TEAC be responsible or liable for indirect or consequential damages from interrupted
10. Warranty is not transferable to any subsequent purchaser if the product is sold during the warranty period,
TEAC PRODUCT
Plasma 1 Year (In-Home Service Included)
Televisions – 51cm and above 1 Year (In-Home Service Included)
Televisions 1 Year
Digital Set Top Boxes 1 Year
VCR 1 Year
DVD 1 Year
Audio Systems 1 Year
a) The product is a Colour Television of 51cm screen size or over.
b) The product is within the warranty period.
c) The product is located within the normal service area of the local TEAC Service Provider.
In any other situation or circumstance, where an in home service call is made, a service fee will be
charged by the Service Provider. TEAC Total Care in home service and installation is available at
competitive rates.
connection with the sale of any equipment other than as stated in this warranty and outlined above.
operations or other causes.
WARRANTY PERIOD
WARRANTY PROCEDURES
Please keep this information for your own records.
Please refer to the owner’s manual to ensure that you have followed the correct installation and
operating procedures.
1. Read owner’s manual carefully
2. If you require Warranty Service, please contact the TEAC Service Centre
3. Please have your purchase receipt as your proof of purchase and the following details
completed for a valid Warranty.
Owner’s Name
Owner’s Address
Postcode
Model Name/No. Serial No.
Dealer’s Name
Dealer’s Address
Postcode
4. Please ensure that your product is packed appropriately upon return to the service centre.
If you have any other queries regarding service or warranty please contact the TEAC Service below:
TEAC Total Care Ph: 1800 656 700
info@teac.com.au
www.teac.com.au
Contents
Safety Precautions..............................................
Installation............................................................
Location of control .............................................
Name and function of remote control ..................
Battery installation..............................................
Operation of the whole machine...........................
Turn ON/OFF power supply....................................
Watching TV programs...........................................
Search .......................... ......................................
Basic operations: Picture and sound control ...........
Time operation.....................................................
Intelligent volume, blue background ................... ...
Technical operation: swap.....................................
DVD Player Operation .................... ....................
General Setup .....................................................
TV Display............................................................
Angle Mark...................................... ....................
OSD Language.....................................................
Closed Captions.............................. ....................
Screen Saver........................................................
Analog Audio Setup............................................
Downmix......................................... ....................
Dolby Digital Setup .............................................
Dual Mono............................................................
Dynamic......................................... .....................
Video Setup.........................................................
Video Output.......................................................
Sharpness............................................................
Brightness...................................... .....................
Contrast..............................................................
Preference Setup.................................................
TV Type.......................................... .....................
Audio...................................................................
Subtitle.......................................... .....................
Disc Menu...................................... .....................
Parental...............................................................
Password.............................................................
Default.................................................................
DVD Operations...................................
1
Play Discs ............................................
3
Pause Mode..........................................
4
OSD.................................... ................
5
DVD Menu Play.....................................
5
Select with Number Button.....................
6
Audio Mode.......................... ................
6
Fast......................................................
6
Slow Play..............................................
7
Repeat Mode.........................................
8
Repeat A-B...........................................
8
Subtitle.................................................
9
Angle ...................................................
10
Goto.....................................................
11
Display (Remain Time) ..........................
11
Resume Play.........................................
11
Zoom ...................................................
11
Program Mode.......................................
11
Picture CD............................................
12
Mp3 Operation ......................................
12
Specifications......................................
12
12
12
12
12
13
13
13
13
13
14
14
14
14
14
15
15
15
16
16
16
16
16
16
16
16
16
16
17
17
17
17
17
17
17
18
18
19
20
Safety and Precautions
To avoid electrical shock, never subject the TV set
to rain or moisture.
It is OK to wipe it with a clean piece of cloth dipped with water
or detergent. Do not use benzene, gasoline or other chemicals
to wipe it. Turn off the TV set before wiping.
To prevent fault with electronic elements, the TV set should be
placed at a ventilated location, and dust, foreign matter shall
be prevented from entering the DVD disk tray.
Do not place the TV set at locations subject to direct sunshine
or close to a heat source, otherwise its normal operation may
be affected.
There is high voltage inside the TV set. Do not remove the back
cover, as it may be dangerous to human safety.
Please turn off the power supply when no one watches TV.
Please remove the plug from power socket.
1
Safety and Precautions
To ensure safe and reliable operation of the TV set, the following precautions must be observed in installation, operation and
maintenance.
Precautions
1. Pay attention to the power cord before installing the TV set. Do not attach anything on the power cord, and avoid treading on the
power cord. The power supply on socket must not overload. The power cord must not be extended without permission, and increased
care shall be taken for integrated sockets, as these may cause electrical shock or fire.
2. The vent on the housing back and the DVD tray on front must not be blocked or covered. The TV set must not be placed close to a heat
source, or it will damage the TV set.
3. This TV set can only use the supply voltage and frequency indicated on the back of housing. If your house power supply does not
conform to the indication, please consult your service personnel.
4. It is strictly forbidden to drop any metal article into the housing vents or the DVD door on front. It is strictly forbidden to have any liquid
flow into the machine, as it will cause short-circuit in the TV set.
5. It is strictly forbidden to subject the TV set to rain or use it in a damp environment. When cleaning the TV set, be sure to remove the
plug from the power supply socket. Do not directly clean the housing with liquid detergent, but it can be wiped with a damp piece of cloth.
Be sure to remove the plug from the power supply socket during a thunderstorm or when it is not used for long time, and the antenna
plug should also be removed, to avoid damaging the parts by lightning.
6. When an indoor antenna is used, do not allow the antenna to contact other electrical appliances, to avoid interfering receiving TV
program.
7. Never use accessories not recommended by manufacturers, as it may cause danger. It is better to use original carton and packaging
materials when handling the TV set.
8. When the DVD function is not used for a long time, the parts operation may not be ideal, so please use the DVD function occasionally
to prevent abnormality.
9. To prevent picture quality deterioration and sound distortion, keep your TV set away from radio sets or other articles with magnetic
fields.
10. If there is condensation on the DVD laser head, do not use the DVD play function, or it may damage the internal parts of DVD.
(Insert the power cord plug into the power supply socket and switch to DVD status and place it for 2-3 hours. This will pre-warm the DVD
Safety
1. Do not remove the back cover without permission, as the high voltage inside the TV set may cause danger. If it is necessary to
remove the back cover, it should be done by a specialized service person.
2. In case of the following, please remove the power supply plug of the TV set from the socket, and contact the service personnel.
3. Please remove the plug from the power supply socket when the TV set is not used for a long time.
4. Heavy object must not be placed on the machine, or the machine be treaded. Otherwise, it may cause serious personal damage or
damage to the machine.
5. Keep your finger away from the tray when closing the DVD tray, or it may cause personal injury.
6. The outdoor antenna must not be erected close to HV lines or other power lines, and great care shall be taken in erecting antenna. It
is strictly forbidden to contact the power line, or it may lead to fatal injury.
(1) There is damage or break in the power cord and plug.
(2) Foreign matter or liquid has entered the TV set or DVD cassette.
(3) The TV set performance has obvious deterioration or there is damage on housing.
2
Instructions on installation
Installation
Before installation, please first read carefully the relevant contents in Safety and Precautions .
Please place the TV set inside a room where sunlight will not directly cast on the screen. Reflection on TV screen will cause eye
fatigue.
To enjoy TV programs comfortably, use soft indirect lighting. The optimum watching distance is 5-7 times the screen height.
There shall be a clearance of 10cm or over between the TV set and wall for good ventilation.
The TV set cannot be placed at a location with excessive high temperature or humidity, to avoid damage or invalidate components.
Automatic demagnetizing
A color TV set is likely to be affected by a magnetic field, to result in color stain on the screen, causing color distortion. If the TV
set is moved, turned or influenced by a magnetic object nearby when it is ON, please turn off its power and wait for at least one hour
before turning it ON again, to ensure that the automatic demagnetizing circuit in the machine can work normally again, to eliminate the
effect of magnetizing on color and restore normal color screen.
Antenna, audio and video connections
To ensure optimum receiving effect, please use outdoor antenna or common antenna (CATV). The antenna types and locations
will vary at different places.
When an outdoor antenna is used, please make the connection as shown above, and lightning protection devices should be
installed and it should be repaired at fixed intervals.
It is recommended to use a 75 coaxial cable, to eliminate interference or noise caused by mismatching of impedance.
3
LOCATION OF CONTROLS
1. Speaker
2. Remote control receiving window
3. Indicator
4. Menu Button
5. AV/ DVD Button
6. DVD Play Button
7. Open/Close Button
8. Channel Button(P-)
9. Channel Button(P+)
10. Volume Button(V )
11. Volume Button(V )
12. Main power switch
13. 75 ohm Antenna Socket
14. AV in
15. AV out
16. Audio digital Out Sockets (For DVD only)
17. Side AV
interface description:
1 Side AV: AV1 mode signal input in TV mode.
2 Rear AV interface: AV2 mode signal input and AV
signal output in TV mode.
3 Optical fiber: in DVD mode, optical fiber signal (digital
and AUDIO) output.
4 Coaxial: in DVD mode, coaxial signal (digital and audio)
output.
Note: If you want to use the DVD mode and AV input
mode of the TV set at the same time, please input the
audio and video signals from side AV (AV1), instead of
from rear AV (Av2).
4
Loading...