TCL Android TV User Manual

User Guide

www.tclusa.com

Android TV is a trademark of Google LLC. TCL and the TCL Logo are owned by TCL Corporation and under license to TCL North America. Other brand and product names are the trademarks or registered trademarks of their respective owners.

Illustrations in this guide are provided for reference only and may differ from actual product appearance.

Contents

Important Information… …………………………………………3

Important Safety Instructions… ……………………………4

Connections and setup

Before initial setup…………………………………………………6 Protect against power surges… …………………………6

Safety information…………………………………………………6 Avoid audio interference……………………………………6 Avoid direct light…………………………………………………6

Set up your new TV…………………………………………………7 Connect to the Internet… ………………………………………7

Network settings……………………………………………………7 Switch the TV on and off… ……………………………………8

Initial setup………………………………………………………………8

Basic TV operations

Accessing channels… ………………………………………………9

Watching connected devices…………………………………9 Adjusting volume……………………………………………………9 Using the power button on your TV… …………………9

Accessing Android TV homepage…………………… 10 Using TV settings menu… …………………………………… 13

Adjusting your TV

Picture settings……………………………………………………… 14 Sound settings… …………………………………………………… 15 Channel settings…………………………………………………… 16 System settings…………………………………………………… 17

Android TV settings

Suggestions…………………………………………………………… 18 General settings… ………………………………………………… 18 Setting Android TV preferences………………………… 19

Other information

Password in Parental Control………………………………20 Troubleshooting… …………………………………………………20

Broadcasting & Operating Environment………… 21

Electronics recycling information for consumers……………………………………………………………… 21

Legal Statement… ………………………………………………… 22

EN 2

Important Information

CAUTION

RISK OF ELECTRIC SHOCK.

DO NOT OPEN.

Caution: To reduce the risk of electric shock, do not remove cover (or back). No user serviceable parts inside. Refer servicing to qualified service personnel.

WARNING

This symbol indicates that this product incorporates double insulation between hazardous main voltage and user accessible parts. When servicing, use only identical replacement parts.

This symbol indicates “dangerous voltage” inside the product that presents a risk of electric shock or personal injury.

This symbol indicates important instructions accompanying the product.

To reduce the risk of fire or electric shock, do not expose this product to rain or moisture. This product should not be exposed to dripping or splashing. No objects filled with liquids, such as vases, should be placed on the apparatus.

The TV is unstable if it is not properly attached to the base or mounted to the wall. Please follow the base or wall mounting instructions provided in the User’s Guide to ensure your safety.

The batteries shall not be exposed to excessive heat such as sunshine, fire or the like. Refer to the identification/rating label located on the back panel of your product for its proper operating voltage.

Cable TV Installer: This reminder is provided to call your attention to Article 820-40 of the National Electrical Code (Section 54 of the Canadian Electrical Code, Part 1) which provides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected to the grounding system of the building as close to the point of cable entry as practical.

Important: This television is a table model and is designed to sit on a firm, flat surface. Don’t place the TV on soft carpeting or similar surface because the ventilation slots on the bottom of the unit will be blocked, resulting in reduced lifetime from overheating. To assure adequate ventilation for this product, maintain a spacing of 1 inch from the top and side of the TV receiver and 2 inches from the rear of the TV receiver and other surfaces.

Also, make sure the stand or base you use is of adequate size and strength to prevent the TV from being accidentally tipped over, pushed off, or pulled off. This could cause personal injury and/or damage to the TV. Refer to the Important Safety Instructions on the next page.

The Power button on this TV and your remote control puts the TV into a very low-power standby mode but will not completely turn the power off. In order to completely shut the power off, you will need to disconnect the power cord from the outlet. The mains plug/appliance coupler is used to completely turn off the device. If you prefer to completely turn off the device, you should install the TV in a manner that allows you to disconnect the power cord when desired.

Product Registration

Please register your TCL TV purchase on-line at www.tclusa.com. It will make it easier to contact you should it ever be necessary. Registration is not required for warranty coverage.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Keep the apparatus at least 8 inches away from the human body.

For the best viewing experience, remove the energy guide label from the TV front panel or TV screen before use.

EN 3

Important Safety Instructions

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with dry cloth.

7.Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9.Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

10.WARNING: Please refer the information on exterior bottom enclosure for electrical and safety information before installing or operating the apparatus.

11.WARNING: The mains plug is used as disconnect device, the disconnect device shall remain readily operable.

12.When not in use and during movement, please take care of the power cordset, e.g. tie up the power cordset with cable tie or something like that. It shall be free from sharp edges and the like that can cause abrasion of the power cordset. When put into use again, please make sure the power cordset being not damaged. If any damages found, please look for the service person to replace the power cordset specified by the manufacturer or have the same characteristics as the original one.

13.No naked flame sources, such as lighted candles, should be placed on the apparatus.

14.Unplug this apparatus during lightning storms or when unused for long periods of time.

15.Only use attachments/accessories specified by the manufacturer.

16.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

17.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

18.For safe operation of the apparatus, observe these installation requirements:

Keep at least 2 inches of ventilation space between the rear cover of the apparatus and the wall. Keep at least 1 inch of ventilation space between the apparatus and all other surfaces. Do not allow any of the apparatus’ ventilation openings to be blocked by objects that might obstruct them, such as newspapers, curtains, table-cloths or any other objects. Do not expose the apparatus to any external heat sources. Do not place any heat sources such as candles, lamps, etc. on the apparatus. Do not expose the device to high levels of humidity or to any possible sources of moisture. When disposing of used batteries from the remote control, consult local regulations regarding proper disposal.

EN 4

Important Safety Instructions

19.If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and builtup static charges. Section 810 of the National Electrical Code, ANSI/NFPA No. 70-2011 (Section 54 of Canadian Electrical Code, Part 1) provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead in wire to an antenna-discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

See following example:

		ANTENNA LEAD IN WIRE
		GROUND CLAMP
		ANTENNA DISCHARGE UNIT
		(NEC SECTION 810-20)
		GROUNDING CONDUCTORS
		(NEC SECTION 810-21)
		GROUND CLAMPS
	ELECTRIC SERVICE	POWER SERVICE GROUNDING
	EQUIPMENT
		ELECTRODE SYSTEM (NEC ART
		250, PART H)

EN 5

Connections and setup

Before initial setup

Protect against power surges

•Connect all components before you plug any power cords into the wall outlet or power strip.

•NEVER plug your TV into an outlet that is controlled by a wall switch.

•Turn off the TV before you connect or disconnect any cables.

•Make sure all antennas and cables are properly grounded. Refer to the Important Safety Instructions.

Safety information

•Prevent TV from overheating by placing in an area with good ventilation.

•Do not block ventilation holes on the TV. Position the TV so air can circulate freely on all sides.

•Do not stack objects on the TV.

•If you place the TV on a stand, make sure you allow adequate ventilation.

•If you connect an audio receiver or amplifier to the TV, place it on the top shelf so the heated air will not overheat the TV.

Avoid audio interference

•Position cables properly; insert each cable firmly into the designated jack.

•Route all cables down one side of the back of the TV instead of straight down the middle.

•If your antenna uses 300-ohm twin lead cables, do not coil the cables.

•Keep twin lead cables away from audio/video cables.

Avoid direct light

•Do not place the TV where sunlight or room lighting is directed toward the screen. Use soft or indirect lighting.

EN 6

Connections and setup

Set up your new TV

Open the box and remove the TV and other items. Be careful, the TV may be heavy! We strongly recommend that at least two people unbox the TV.

Be sure to check all the foam packaging as the stands from some TV’s are stored in the foam for protection.

Refer to your TV’s Quick Start Guide or other provided documentation for model-specific information about attaching the stands or a wall mount and making connections to AC power and to your other audio/video devices.

Connect to the Internet

The following instructions are just the usual ways to connect your TV to the wired or wireless network. The connection method may be different depending on your actual network configuration. If you have any questions about your home network, please refer to your Internet service provider.

Wired connection

Router

Modem Internet

ETHERNET port

Wireless connection

Modem Internet

Wireless router

Network settings

1.Press on the remote control to display the Android TV homepage.

2.Press ▲/▼/◄/► to move the cursor to on the right top of the screen and press OK to enter the settings menu.

3.Press ▲/▼ to select Network & Internet, press OK to enter the submenu and follow the onscreen guidance to set up your network.

EN 7