TC Helicon Go Vocal User Manual
Quick Start Guide
GO VOCAL
High-Quality Microphone Preamp for Mobile Devices
Getting started
Install a 9V bat tery by sliding o the rear cover.
Plug the attached cable into yo ur device’s
headphone input or lightning adapter.
Plug a pair of headp hones into the
headphone input.
Connect a microphone via XLR c able.
Move the Power switc h to the ON position.
If you have connec ted a condenser microphone,
select the +48V position to supply phantom power.
The 48V LED on the f ront panel will light red.
While speaking into the microphone, turn up
the GAIN wheel. If your voice distor ts when singing
or speaking loudly, turn the GAIN control back
down a bit.
Left
Right
Ground
Mic
Download your favorite TC Helicon app to
begin experimenting with vocal eect s.
Specications
Analog Connections
Microphone 1 x XLR female, balanced
Impedance 5 k
Headphones 1 x ⁄" TRS female, stereo
Controls
Gain 0 to 52 dBu
Power switch O / On / Phantom
System
Frequency response 50 Hz to 20 kHz, +0/-3 dB
S/N ratio >10 1 d B
Power Supply
Power source Battery power
Batteries 1 x 9 V
Dimensions / Weight
Dimensions
(H x W x D)
Weight 0.10 kg (0.22 lbs)
92 x 45 x 38 mm
(3.6 x 1.8 x 1.5")
FEDERAL COMMUNICATIONS
COMMISSION COMPLIANCE
INFORMATION
TC Helicon
GO VOCAL
Responsible Party Name: Music Tribe B rands UK Ltd.
Address: Klark Industrial Park,
Walter Nash Road,
Kidderminster.
Worceste rshire, DY11 7HJ England
Phone Number: +4 4 1562 741515
GO VOCAL
This equi pment has been test ed and found to compl y with the limits f or a ClassB digital
device, pur suant to part 15 of the FCC Ru les. These limit s are designed to pro vide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
install ed and used in accord ance with the instr uctions, may cau se harmful inter ference
to radio communications. However, there is no guarantee that interference will not occur
in a part icular installat ion. If this equipm ent does cause har mful interfe rence to radio or
televisio n reception, whic h can be determine d by turning the equ ipment o and on,
the user is e ncouraged to tr y to correct the in terference by on e or more of the
following measures:
LEGAL DISCLAIMER
Music Tribe acce pts no liabilit y for any loss which ma y be suered by any per son who relies
either wholly or in part upon any description, photograph, or statement contained herein.
Technical specications, appearances and other information are subject to change without
notice. All tr ademarks are t he propert y of their respec tive owners. M idas, Klark Teknik,
Lab Grup pen, Lake, Tannoy, Turbosound, TC Ele ctronic, TC Hel icon, Behringer, Buge ra
and Coolaudio are trademarks or registered trademarks of Music Tribe Global Brands Ltd.
© Music Tribe Glo bal Brands Ltd. 2018 All rig hts reserve d.
LIMITED WARRANTY
For the applicable warranty terms and conditions and additional information regarding
Music Tribe’s Limi ted Warranty, pleas e see complete de tails online at musi ctribe.com.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connec t the equipment into a n outlet on a circui t dierent from t hat
to which th e receiver is connec ted.
• Consult the d ealer or an experi enced radio/T V technician for he lp.
This equi pment complies wit h Part 15 of the FCC Rules. Op eration is subjec t to the
following two conditions:
(1) This device may not c ause harmful inte rference, and
(2) This device mu st accept any inter ference received , including inter ference that may
cause undesired operation.
Loading...