Taylor Freezer C119 General Manual

Item No. _______________________________

C119

Batch Ice Cream Freezer

Features

Serve homemade, medium overrun gourmet ice cream,
custard, gelato, sorbet, Italian ice and slush. Mix and liquid
flavorings may be poured into the convenient fill chute on the
door. Fruits, candies and nuts can be folded in as product is
being drawn into your container. Manufactured in Italy by
Frigomat to ensure European equipment quality and
technology to serve gelato or medium overrun frozen
desserts.

Freezing Cylinder

One, 8.5 quart (8.0 liter).

Electronic Consistency Control

Selection on rotary switch from one to six. Automatically senses
product viscosity to control the refrigeration system for perfect ice
cream quality, batch after batch.

Variable Batch Size

Adjust to a lower viscosity setting for smaller pre-charge of mix.

Rockton, Illinois 61072

800-255-0626

Phone [phone] Fax [phone]

www.taylor-company.com

e-mail: [e-mail]

621

C119

International Office
Taylor Company S.r.l.
Roma, Italy
Tel: [phone] Fax: [phone]
e-mail: [e-mail]

C119Batch Ice Cream Freezer

33

(838)

17-3/8

(440)

49-1/2
(1260)

5

(127)

NOTE: FIGURES IN PARENTHESES INDICATE MILLIMETERS.

WATER IN

WATER OUT

AUX

ELECTRICAL
CONN.

(CONNECTIONS LOCATED IN

LOWER AREA OF REAR PANEL)

22-7/8

(581)

Weights lbs. kgs.

Net 373 169
Crated 478 217

cu. ft. cu. m.

Volume 15.9 0.45

Dimensions in. mm.

Width 17-3/8 440
Water Cooled Depth 31-7/8 810
Air Cooled Depth 3331-7/8 81038
Height 49-1/2 1260

Counter Clearance:

Electrical Maximum Minimum Poles (P)
Fuse Size Circuit Ampacity Wires (W)

208-230/60/1 Air 30 24 2P 3W
208-230/60/1 Water 30 24 2P 3W

This unit may be manufactured in other electrical and cooling characteristics.
Refer to the local Taylor Distributor for availability.
(For exact electrical information, always refer to the data label of the unit.)

Bidding Specs

Electrical: Volt ___________________ Hz__________ ph _________

C119

Options:_________________________________________________
_________________________________________________________

5” (127 mm) mounted on standard casters

Neutral:  Yes No Cooling:  Air  Water  NA

Specifications

Electrical

One dedicated electrical connection is required. See the Electrical chart for
the proper electrical requirements. Manufactured to be permanently
connected. Consult your local Taylor distributor for cord & receptacle
specifications as local codes allow.

Beater Motor

One, 2 HP beater motor.

Refrigeration System

One, approximately 15,500 BTU/hr. R404A.
(BTUs may vary depending on compressor used.)

Air Cooled

Taylor Company,

A Division of Carrier Commercial Refrigeration, Inc.
Rockton, Illinois 61072
815-624-8333 800-255-0626 Fax [phone]

www.taylor-company.com

Minimum 6” (152 mm) on both sides and 12” (305 mm) at rear. Minimum air
clearances must be met to assure adequate air flow for optimum
performance..

Water Cooled

Water inlet and drain connections on back panel 1/2” MPT.

Continuing research results in steady improvements; therefore, these

specifications are subject to change without notice.

Printed in U.S.A.

058464-ADV

8/09