Taylor Freezer 8756 General Manual

Item No.

8756

Soft Serve Freezer

Twin Twist, Pump

Features

Offer all the popular soft serve variations from low or non­fat ice creams to custards, yogurt and sorbet. Serve two
separate soft serve flavors, or an equal combination of both
in a twist.

Freezing Cylinder

Two, 3.4 quart (3.2 liter).

Refrigerated Mix Storage Cabinet

Lower front mix cabinet is independently refrigerated to maintain mix below
41ºF (5ºC). Door is hinged on the right. Two, 9 gallon (34.1 liter) mix tanks.
Two air/mix pumps deliver the precise amount of air and mix to the freezing
cylinder.

8756

Indicator Lights

Mix Low light alerts the operator to add mix. When the Mix Out light flashes,
the unit shuts down automatically to prevent damage.

Electronic Controls

Finished product quality is monitored by SoftechTM controls that measure
viscosity.

Two Locking Casters

Front casters have a locking feature for operators to lock to maintain
equipment in place. The locking casters can be released to move the
equipment for cleaning.

Door Interlock System

Protects the operator from injury as the beater will not operate without the
dispensing door in place.

Rockton, Illinois 61072

800-255-0626

Phone [phone] Fax [phone]

www.taylor-company.com

e-mail: [e-mail]

International Office
Taylor Company S.r.l.
Roma, Italy
Tel: [phone] Fax: [phone]
e-mail: [e-mail]

8756 Soft Serve Freezer

35-7/8

8756

11-43/64

(296)

(911)

26-7/16

(672)

(76)

3

4-13/32

(112)

13/16

(21)

7-15/32

(190)

*1-1/8 (29) DIA
WATER IN

AIR OUT

53-5/16

34-1/4

(870)

(1354)

68-1/4
(1734)

64

(1626)

43-19/64

(1100)

4-1/4
(108)

36

(914)

AIR IN BOTH SIDES

Weights lbs. kgs.

Net 810 367.4
Crated 849 385.1

cu. ft. cu. m.

Volume 77.9 2.2

Dimensions in. mm.

Width 26-7/16 672
Depth 36 914
Height 68-1/4 1734
Floor Clearance 4-1/4 108

*Mounted on standard casters

Electrical Maximum Minimum Poles (P)
Fuse Size Circuit Ampacity Wires (W)
Left Right Left Right

208-230/60/1 Air 35 35 28 24 2P 3W
208-230/60/1 Water 35 35 28 24 2P 3W
208-230/60/3 Air 25 25 22 18 3P 4W
208-230/60/3 Water 25 25 21 18 3P 4W
220-240/50/1 Air 30 25 23 19 2P 3W
380-415/50/3N~ Air 12 9 11 8 4P 5W

This unit may be manufactured in other electrical characteristics. Refer to the
local Taylor Distributor for availability.

(For exact electrical information, always refer to the data label of the unit.)

*1-1/32 (26) HEX

WATER OUT

45-3/4
(1162)

13/16

(21)

NOTES:

1. FIGURES IN PARENTHESES INDICATE MILLIMETERS.

2. *FOR WATER COOLED UNITS ONLY.

17-23/32

(450)

1-1/16 (27)DIA
ELECTRIC HOLE

33-23/32

(856)

TOP VIEW - OPERATOR END

Specifications

Electrical

Two dedicated electrical connections are required. See the Electrical chart
for the proper electrical requirements. Manufactured to be permanently
connected. Consult your local Taylor distributor for cord & receptacle
specifications as local codes allow.

Beater Motor

Two, 1.5 HP.

Refrigeration System

Two, 9,500 BTU/hr. R404A
Mix Cabinet, 1,100 BTU/hr. R404A.
(BTUs may vary depending on compressor used.)

Air Cooled

Minimum 3” (76 mm) around all sides and 12” (305 mm) on top. Minimum
air clearances must be met to assure adequate air flow for optimum
performance.

Water Cooled

Water inlet and drain connections under side of base 1/2” FPT.

Options

• Cone Dispenser

• Draw Valve Lock Kit

• Panel Spinner

• Sneeze Guard

• Syrup Rail Kit (side mount)

ALL CONNECTIONS LOCATED UNDERSIDE OF BASE

Bidding Specs
Electrical: Volt Hz ph
Neutral: Yes  No Cooling: Air Water NA

Options:

Taylor Company,

Rockton, Illinois 61072
815-624-8333 800-255-0626 Fax [phone]

www.taylor-company.com

Continuing research results in steady improvements; therefore,

these specifications are subject to change without notice.

026173-ADV 11/11