Tatung TBM-1203, TBM-1503, TBM-2003, TBM-1703, TBM-0903 User Manual

Operating Instructions

For B/W Video Monitor

TBM-0903 / TBM-1203 / TBM-1403

TBM-1503 / TBM-1703 / TBM-2003

Table of Contents

1. FCC Information

2. Safety Precautions

3. General Features

4. TBM0903 Front and Rear Views

5. TBM1203 Front and Rear Views

6. TBM1403 Front and Rear Views

7. TBM1503 Front and Rear Views

8. TBM1703 Front and Rear Views

9. TBM200310Front and Rear Views

. Operation

-2

-2

-4

-5

-6

-7

-8

-9

-10

-11

1

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Shielded interface cables and A.C. power cord, if any, must be used in order to

comply with emission limits.

Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

SAFETY PRECAUTIONS

1. Operate this unit only from the type of power source indicated on the label.

2. Do not block or cover ventilation openings on the back or bottom of the monitor

cabinet.

3. Do not place this monitor near a radiator or heating vent.

4. Do not push objects of any kind through cabinet openings. This may result in fire

or electrical shock.

5. Before adding attachments always ask a service technician to perform routine

safety tests to determine that equipment is in safe operating condition. Ground

potential tests should be part of the routine safety check made by the service

technician.

6. Do not place monitor on an unstable cart, stand, or shelf where it may fall and

injure personnel or damage equipment.

2

7. Route power cords so that they cannot be walked upon or tripped over. Do not

allow anything to rest on the power cord.

8. Do not install monitor in wet areas, or where it may be exposed to rain or water.

Do not spill liquid of any kind on the unit.

9. Unplug the power cord from the unit before cleaning the display. Use only a damp

cloth. Do not use alcohol, spirits, or ammonia to clean the display.

DO NOT ATTEMPT TO CLEAN THE INTERIOR OF THIS UNIT-THIS ACTION MUST

BE PERFORMED BY THE SERVICE TECHNICIAN AS REQUIRED DURING NORMAL

MAINTENANCE.

10.

Refer all servicing to qualified service personnel. REMOVAL OF BACK COVER BY

UNAUTHORIZED PERSONNEL MAY EXPOSE THE USER TO DANGEROUS

VOLTAGES OR OTHER HAZARDS.

11.

Unplug the unit immediately and notify the service technician.

A. If liquid has been spilled into the display or the display has been exposed to

rain or water.

B. If the unit has been dropped or the cabined damaged.

C. If fuses continue to blow.

D. If the power cord is damaged or frayed.

E. If a distinct change from normal operation is apparent.

When replacement parts are required, be sure that the service technician Uses

components specified by the manufacturer, which have the same characteristics as

the original parts. Unauthorized substitutions may result in fore, electrical shock or

other hazards.

Upon completion of any service or repairs, ask the technician to perform safety

check to determine that the equipment is in safe operating condition.

Warning:

Serious shock hazards exist within the covers of this monitor. Do not

open the covers under any circumstances, there are no user

serviceable components inside.

3