Tascam MX-8A Specifications

MX-8A

Product Spec Sheet

MATRIX MIXER

MX-8A

■ Specifications
General

・FORMAT

44.1 k/48 kHz, 16 bit/24 bit

Input/output ratings

・USB port

Connector: 4-pin USB B-type
Transfer rate: USB 2.0 High Speed (480 Mbps)

・ANALOG IN connectors

Connector: Euroblock (balanced) 3.81 mm pitch
Minimum input level: -77.5 dBu
Maximum input level: +26 dBu (MIC)
Maximum input level: +24 dBu (LINE)
Input impedance: 2.2 kΩ or higher

・ANALOG OUT connectors

Connector: Euroblock (balanced) 3.81 mm pitch
Nominal output level: +4 dBu (when Ref.Level set to other than -9 dBFS)

+6 dBu (when Ref.Level set to -9 dBFS)

Maximum output level (switchable):

+15 dBu (Ref.Level: -9 dBFS)
+18 dBu (Ref.Level: -14 dBFS)
+20 dBu (Ref.Level: -16 dBFS)
+22 dBu (Ref.Level: -18 dBFS)
+24 dBu (Ref.Level: -20 dBFS)

Output impedance: 200 Ω or lower

・RS-232C connector

D-sub 9-pin (female, inch-standard)

・RS-485 connector

Connector: RJ-45
Cables: category 5e or faster STP cables

・Ethernet connector

Connector: RJ-45
Transmission protocol: TCP/IP
Ethernet standard: 100BASE-TX

Jan, 2019

0083a -1-

MX-8A

Cables: category 5e or faster STP cables

● 0 dBu=0.775 Vrms

Audio performance

・Mic amp EIN (equivalent input noise)

-126 dBu or less (MIC IN ➝ LINE OUT, Input impedance: 150 Ω, 22 kHz LPF, A-weighted, JEITA)

・Frequency response

±0.5 dB: 20 Hz – 20 kHz (+24 dBu input, MIC IN ➝ LINE OUT, GAIN MIN, JEITA)

・Distortion (THD+N)

0.005 % or less (+24 dBu input, 1 kHz, MIC IN ➝ LINE OUT, GAIN MIN, JEITA)

・S/N ratio

106 dB or higher
(+24 dBu input, 44.1 k/48 kHz sampling frequency, MIC IN ➝ LINE OUT, GAIN MIN, JEITA)

・Crosstalk

106 dB or higher (+24 dBu input, 1 kHz, MIC IN ➝ LINE OUT, GAIN MIN, JEITA)

・Dynamic range

106 dB or higher (MIC IN ➝ LINE OUT, GAIN MIN, JEITA)

Note: JEITA indicates compliance with JEITA CP-2150

Other

・Power AC100-240 V, 50/60 Hz
・Power consumption 21 W
・Dimensions 483 × 45 × 304.1 mm (W x H x D, including protrusions)
・Weight 3.0 kg
・Operating temperature range 0゜C–40゜C

■ Dimensional drawings

_____________________________________________________________________________________________ _______________________________________________________

※TASCAM is trademark of TEAC CORPORATION, registered in the U.S. and other countries.
※Other company names, product names and logos are the trademarks or registered trademarks of their owners.
※Specifications and appearance are subject to change without notice.
※All information included in this document is as of Jan, 2019.

0083a -2-